# AD 51-11-04: Landing Gear Rework

- Type: Airworthiness directive
- Status: Current
- Products: Swift Museum Foundation GC-1A and GC-1B
- Superseded by: Nothing supersedes this AD
- Product type: Aircraft, Small airplane
- Registered aircraft: 541 may be affected, by airframe or engine model (OpenAirDocs)
- FAA DRS: https://drs.faa.gov/browse/excelExternalWindow/C70DF49E9BFE2A1A86256A56006BB026.0001
- DRS record last changed: May 30, 2024
- Page: https://openairdocs.org/ad/51-11-04

## The airworthiness directive

51-11-04 TEMCO: Applies to Models GC-1A and GC-1B and Includes All Serial Numbers.

Compliance required as indicated.

A. At each 100-hour or annual inspection, all bushings in all landing gear pivot points should be inspected for wear that would allow fore and aft travel of the main landing gear. The total fore and aft travel of the wheels, measured at the center of the axle, due to the cumulative slack in the worn bushing, should not be more than 3/8-inch. This check should be made with the hydraulic pressure relieved on the system and with the landing gear in two positions:

  (1) Unlocked and in an intermediate position near to, but not in, the full down position; and

  (2) With the landing gear just entering the wheelwell. If the total fore and aft travel of the wheel of either landing gear is more than 3/8-inch in either position, the landing gear assembly must be repaired as necessary to reduce this travel to less than 3/8-inch.

B. At the next 100-hour or annualinspection, whichever occurs first, unless already accomplished, install spacer emergency landing gear pull down system to prevent inadvertent unthreading of drive screw.

(TEMCO Service Bulletin No. 28 covered this same subject.)

C. At each 100-hour or annual inspection, the emergency extension system should be inspected for proper adjustment in accordance with paragraphs 8, 9 and 12 of TEMCO Service Bulletin No. 28.

## Affected data sheets (1) (OpenAirDocs)

The type certificate data sheets whose models the AD names.

- [TCDS A-766](https://openairdocs.org/tcds/A-766): Swift Museum Foundation Inc.; names 2 of 2 models: GC-1A, GC-1B

## Registered aircraft it may apply to (OpenAirDocs)

Matched by airframe and engine model; the AD's applicability may narrow it by serial number, part number or equipment.

- Aircraft: 541 (541 by airframe model, 0 by engine model)
- Makers: Globe 426, Temco 115

Models with the most aircraft:

- [Globe GC-1B](https://openairdocs.org/model/globe-gc-1b): 395 aircraft (airframe model)
- [Temco GC-1B](https://openairdocs.org/model/temco-gc-1b): 115 aircraft (airframe model)
- [Globe GC-1A](https://openairdocs.org/model/globe-gc-1a): 31 aircraft (airframe model)

All 3 models: https://openairdocs.org/ad/51-11-04/models.md
Every aircraft: https://openairdocs.org/ad/51-11-04/aircraft.md

Its text cites no advisory circulars or STCs.

---
OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.