# AD 62-02-04: Aileron Tab Lockout Bracket - Type: Airworthiness directive - Status: Current - Products: Boeing DC-8-11, DC-8-12, DC-8-21, DC-8-31, DC-8-32, DC-8-33, DC-8-41, DC-8-42, DC-8-43, DC-8-51, DC-8-52, DC-8-53 and 15 more - Effective: January 24, 1962 - Published: January 24, 1962 - Superseded by: Nothing supersedes this AD - Product type: Aircraft, Large airplane - Registered aircraft: 8 may be affected, by airframe or engine model (OpenAirDocs) - FAA DRS: https://drs.faa.gov/browse/excelExternalWindow/6BF01500198507CD862569BC00753A8C.0001 - DRS record last changed: May 30, 2024 - Page: https://openairdocs.org/ad/62-02-04 ## The airworthiness directive 62-02-04 DOUGLAS: Amdt. 392 Part 507 Federal Register January 24, 1962. Applies to DC-8 Aircraft Serial Numbers 45252-45289, 45291-45306, 45376-45393, 45408-45413, 45416-45419, 45421-45431, 45433-45437, 45442-45445, 45526, 45565-45570, 45588-45614, 45616-45628 and 45636-45638. Compliance required as indicated. To prevent aileron tab lockout mechanism bracket assembly failure, resulting in partial or complete loss of control force to one aileron, the following shall be accomplished: (a) At periods prescribed in (b), conduct close visual inspection, using low-power magnifying glass or equivalent means, for evidence of cracking of the left and right side aileron tab lockout bracket assemblies, P/N 4643350. The critical areas to be inspected are shown in Douglas Service Bulletin 27-115, Figure 1, Step 3. Any evidence of cracking shall be verified by dye check or equivalent means, with the tab lockout cylinder disconnected from the bracket assembly, within the next 10hours' time in service following the detection of such evidence of cracking. Any part found to be cracked shall be replaced prior to further flight with an assembly of the same part number which has been inspected in accordance with the provisions of this paragraph and found to be free of cracks or with assembly P/N 3773970-1. (b) The initial and repetitive inspections of assemblies, P/N 4643350, shall be conducted at the following times: (1) On assemblies which have accumulated a total time in service of less than 3,000 hours as of the effective date of this AD: Initial inspection within next 350 hours' time in service, but in no event to exceed 3,100 hours' assembly total time in service; repetitive inspections thereafter at intervals not to exceed 350 hours' time in service except that after the assembly total time in service reaches 3,000 hours the repetitive intervals shall not exceed 100 hours' time in service. (2) On assemblies which have accumulated a total time in service of 3,000 hours or more as of the effective date of this AD: Initial inspection within next 100 hours' time in service; repetitive inspections thereafter at intervals not to exceed 100 hours' time in service. (c) When assembly, P/N 3773970-1 is installed in place of P/N 4643350, the repetitive inspections may be discontinued. (d) When assembly P/N 4643350 is replaced with an assembly of the same part number which has been inspected in accordance with (a) and found to be free of cracks, the replacement part shall be reinspected in accordance with the provisions of (b). (e) Upon request of the operator, an FAA maintenance inspector, subject to prior approval of the Chief, Engineering and Manufacturing Branch, FAA Western Region, may adjust the repetitive inspection intervals specified in this AD to permit compliance at an established inspection period of the operator if the request contains substantiating data to justify the increase for such operator.(Douglas Service Bulletin 27-115, Revision No. 1, dated October 25, 1961, pertains to this same subject.) This directive effective January 24, 1962. ## Affected data sheets (1) (OpenAirDocs) The type certificate data sheets whose models the AD names. - [TCDS 4A25](https://openairdocs.org/tcds/4A25): The Boeing Company; names 27 of 27 models: DC-8-41, DC-8-52, DC-8-61, DC-8-53, DC-8-51, DC-8-63, DC-8-11, DC-8-72F… ## Registered aircraft it may apply to (OpenAirDocs) Matched by airframe and engine model; the AD's applicability may narrow it by serial number, part number or equipment. - Aircraft: 8 (8 by airframe model, 0 by engine model) - Makers: Douglas 5, Mcdonnell Douglas 3 Models with the most aircraft: - [Douglas DC-8-73](https://openairdocs.org/model/douglas-dc-8-73): 2 aircraft (airframe model) - [Douglas DC-8-73F](https://openairdocs.org/model/douglas-dc-8-73f): 2 aircraft (airframe model) - [Mcdonnell Douglas DC-8-62](https://openairdocs.org/model/mcdonnell-douglas-dc-8-62): 1 aircraft (airframe model) - [Mcdonnell Douglas DC-8-63](https://openairdocs.org/model/mcdonnell-douglas-dc-8-63): 1 aircraft (airframe model) - [Mcdonnell Douglas DC-8-63F](https://openairdocs.org/model/mcdonnell-douglas-dc-8-63f): 1 aircraft (airframe model) - [Douglas DC-8-72](https://openairdocs.org/model/douglas-dc-8-72): 1 aircraft (airframe model) All 6 models: https://openairdocs.org/ad/62-02-04/models.md Every aircraft: https://openairdocs.org/ad/62-02-04/aircraft.md Its text cites no advisory circulars or STCs. --- OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.