# AD 64-19-01: Air Conditioning Bay Access Doors - Type: Airworthiness directive - Status: Current - Products: Boeing 707-100 Long Body, 707-100B Long Body, 707-100B Short Body, 707-200, 707-300 Series, 707-300B Series, 707-300C Series, 707-400 Series, 720 Series and 720B Series - Effective: September 7, 1964 - Superseded by: Nothing supersedes this AD - Product type: Aircraft, Large airplane - Registered aircraft: 6 may be affected, by airframe or engine model (OpenAirDocs) - FAA DRS: https://drs.faa.gov/browse/excelExternalWindow/E145B902C3DDF6B4862569920051DC40.0001 - DRS record last changed: May 30, 2024 - Page: https://openairdocs.org/ad/64-19-01 ## The airworthiness directive 64-19-01 BOEING: Amdt. 787 Part 507 Federal Register August 7, 1964. Applies to Models 707 and 720 Series Aircraft. Compliance required as indicated. As a result of several incidents involving loss of air conditioning bay access doors, accomplish the following: (a) Within 550 hours' time in service after the effective date of this AD, unless accomplished within the last 2,500 hours' time in service, and at intervals thereafter not to exceed 3,050 hours' time in service from the last inspection: (1) On all Models 707 and 720 Series aircraft, inspect for lobe wear the five hinges on the left and right-hand air conditioning bay access doors and the mating hinges located on the bottom of the fuselage between fuselage Station 620 and 820. (2) Remove any hinges that have lobe wall thicknesses less than 0.030 inches and replace with new hinges of the same part number or an FAA approved equivalent hinge, before further flight. (3) On aircraft Serial Numbers17586 through 17619, 17623 through 17626, 17628 through 17652, 17658 through 17673, 17675 through 17684, 17692 through 17706, 17718 through 17720, 17722 through 17724, 17903 through 17905, 17907 through 17909, 17925 through 17927 and 18013, visually inspect the air conditioning bay access doorframes and the hinges thereon for cracks around the rivets attaching the hinges to the door. Before further flight, replace cracked hinges with hinges of the same part number or an FAA-approved hinge, and if the doorframes are cracked, either replace the doors with new doors or repair them in accordance with the applicable Boeing Structural Repair Manual, or repair data approved by a Boeing Structural Designated Engineering Representative (DER). (b) The inspections specified in (a)(3) may be discontinued when reinforcement plates and bolts are added to the access doors in accordance with Paragraph 3, Modification Data, of Boeing Service Bulletin No. 879, dated July 8, 1960, or an FAA Western Region, Aircraft Engineering Division, approved equivalent. (c) Upon request of the operator, an FAA maintenance inspector, subject to prior approval of the Chief, Aircraft Engineering Division, FAA Western Region, may adjust the repetitive inspection intervals specified in this AD to permit compliance at an established inspection period of the operator if the request contains substantiating data to justify the increase for such operator. (Boeing Service Bulletin No. 879 pertains to this same subject.) This directive effective September 7, 1964. ## Affected data sheets (3) (OpenAirDocs) The type certificate data sheets whose models the AD names. - [TCDS 4A21](https://openairdocs.org/tcds/4A21): The Boeing Company; names 4 of 4 models: 707-100B Short Body, 707-200, 707-100 Long Body, 707-100B Long Body - [TCDS 4A26](https://openairdocs.org/tcds/4A26): The Boeing Company; names 4 of 4 models: 707-300B Series, 707-400 Series, 707-300 Series, 707-300C Series - [TCDS 4A28](https://openairdocs.org/tcds/4A28): The Boeing Company; names 2 of 2 models: 720B Series, 720 Series ## Registered aircraft it may apply to (OpenAirDocs) Matched by airframe and engine model; the AD's applicability may narrow it by serial number, part number or equipment. - Aircraft: 6 (6 by airframe model, 0 by engine model) - Makers: Boeing 6 Models with the most aircraft: - [Boeing 707-338C](https://openairdocs.org/model/boeing-707-338c): 2 aircraft (airframe model) - [Boeing 707-368C](https://openairdocs.org/model/boeing-707-368c): 1 aircraft (airframe model) - [Boeing 707-321B](https://openairdocs.org/model/boeing-707-321b): 1 aircraft (airframe model) - [Boeing 707-323B](https://openairdocs.org/model/boeing-707-323b): 1 aircraft (airframe model) - [Boeing 707-351B](https://openairdocs.org/model/boeing-707-351b): 1 aircraft (airframe model) All 5 models: https://openairdocs.org/ad/64-19-01/models.md Every aircraft: https://openairdocs.org/ad/64-19-01/aircraft.md Its text cites no advisory circulars or STCs. --- OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.