# AD 87-12-01: Main Landing Gear Bolts - Type: Airworthiness directive - Status: Current - Products: Boeing DC-9-81 (MD-81), DC-9-82 (MD-82) and DC-9-83 (MD-83) - Effective: June 22, 1987 - Superseded by: Nothing supersedes this AD - Product type: Aircraft, Large airplane - Amendment: 39-5636 - Registered aircraft: 72 may be affected, by airframe or engine model (OpenAirDocs) - FAA DRS: https://drs.faa.gov/browse/excelExternalWindow/5198E2ED020E988B862569F2006C6A72.0001 - DRS record last changed: May 30, 2024 - Page: https://openairdocs.org/ad/87-12-01 ## The airworthiness directive 87-12-01 MCDONNELL DOUGLAS: Amendment 39-5636. Applies to McDonnell Douglas Model DC-9-81, -82, -83 (MD-81, -82, -83) series airplanes, Fuselage Numbers 909 through 1350, certificated in any category. Compliance required as indicated unless previously accomplished. To ensure the integrity of the main landing gear upper torque link attach bolts, P/N 3935363, accomplish the following: A. Within 7 days after the effective date of this AD, in accordance with the Accomplishment Instructions of Douglas Aircraft Alert Service Bulletin A32-220, dated April 20, 1987, or later FAA-approved revision, perform a visual inspection to verify the installation of the left and right main landing gear upper torque arm attach bolt, washer, and nut. If a bolt is missing, prior to further flight replace with a new or serviceable bolt, washer, and nut. If the original bolt, washer, and nut are present, repeat visual inspections of the original bolt, washer, and nut at intervals not to exceed 7 days until the requirements of paragraph B. or C., below, are accomplished. B. Within 90 days after the effective date of this AD, in accordance with the Accomplishment Instructions of Douglas Aircraft Alert Service Bulletin A32-220, dated April 20, 1987, or later FAA-approved revision, perform an ultrasonic inspection of the attach bolt for defects. If no defects are found, loosen and retighten the original nut to a torque of 80 to 100 foot-pounds. Repeat the ultrasonic inspections at intervals not to exceed 180 days until the requirements of paragraph C., below, are accomplished. If a defect is found, prior to further flight replace with a new or serviceable bolt, washer, and nut. C. Accomplishment of the magnetic particle inspection of the bolt in accordance with the Accomplishment Instructions of Douglas Aircraft Alert Service Bulletin A32-220, dated April 20, 1987, or later FAA-approved revision, constitutes terminating action for the repetitive inspections required by paragraphs A. and B., above, if no defects are found as a result of the magnetic particle inspection. If a defect is found, prior to further flight replace with a new or serviceable bolt, washer, and nut. D. Installation of new or serviceable bolt, washer, and nut in accordance with the Accomplishment Instructions of Douglas Aircraft Alert Service Bulletin A32-220, dated April 20, 1987, or later FAA-approved revision, constitutes terminating action for the repetitive inspections required by this AD. E. Alternate means of compliance which provide an acceptable level of safety may be used when approved by the Manager, Los Angeles Aircraft Certification Office, FAA, Northwest Mountain Region. F. Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base in order to comply with the requirements of this AD. All persons affected by this directive who have not already received the appropriate service information fromthe manufacturer may obtain copies upon request to McDonnell Douglas Corporation, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Director, Publications and Training, C1-750 (54-60). This information may be examined at the FAA, Northwest Mountain Region, 17900 Pacific Highway South, Seattle, Washington, or the Los Angeles Aircraft Certification Office, 4344 Donald Douglas Drive, Long Beach, California. This amendment becomes effective June 22, 1987. ## Affected data sheets (1) (OpenAirDocs) The type certificate data sheets whose models the AD names. - [TCDS A6WE](https://openairdocs.org/tcds/A6WE): The Boeing Company; names 3 of 25 models: DC-9-81 (MD-81), DC-9-83 (MD-83), DC-9-82 (MD-82) ## Registered aircraft it may apply to (OpenAirDocs) Matched by airframe and engine model; the AD's applicability may narrow it by serial number, part number or equipment. - Aircraft: 72 (72 by airframe model, 0 by engine model) - Makers: Mcdonnell Douglas 71, Douglas 1 Models with the most aircraft: - [Mcdonnell Douglas DC-9-83(MD-83)](https://openairdocs.org/model/mcdonnell-douglas-dc-9-83-md-83): 49 aircraft (airframe model) - [Mcdonnell Douglas DC-9-82(MD-82)](https://openairdocs.org/model/mcdonnell-douglas-dc-9-82-md-82): 22 aircraft (airframe model) - [Douglas DC-9-83](https://openairdocs.org/model/douglas-dc-9-83): 1 aircraft (airframe model) All 3 models: https://openairdocs.org/ad/87-12-01/models.md Every aircraft: https://openairdocs.org/ad/87-12-01/aircraft.md Its text cites no advisory circulars or STCs. --- OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.