# NTSB DFW05FA244: Diamond Aircraft Industries DA20-C1, N63PA, Pleasanton, TX, September 21, 2005 - Type: NTSB accident investigation - Classification: Accident · Fatal · Field investigation · Final report - Date: September 21, 2005, 11:32 local (16:32 UTC) - Place: Pleasanton, TX - Coordinates: 28.988332, -98.505836 - Nearby events: https://openairdocs.org/map.md?lat=28.9883&lon=-98.5058&mi=10 - Phase of flight: [Maneuvering](https://openairdocs.org/ntsb-phases/450) (OpenAirDocs' grouping) - Highest injury: Fatal - Injuries: 2 fatal - Status: Completed, report June 28, 2006 - Report: Approved by Office Director - Parties: Teledyne Continental Motors, Inc., Federal Aviation Administration, Major, U.S. Air Force, Diamond Aircraft - NTSB case key (mKey): 62503 - NTSB case page: https://web.ntsb.gov/investigations/?ntsbnumber=DFW05FA244 - NTSB report (PDF, downloads): https://data.ntsb.gov/carol-repgen/api/Aviation/ReportMain/GenerateNewestReport/62503/pdf - Page: https://openairdocs.org/ntsb/DFW05FA244 ## Probable cause The flight instructor's failure to maintain clearance from an unmarked transmission line. A contributing factor was the low altitude flight. ## Sequence of events In NTSB's coding before 2008 (https://www.ntsb.gov/GILS/Documents/codman.pdf). - In flight collision with object, maneuvering - clearance - not maintained, pilot in command(cfi) (cause) - object - wire,transmission - altitude - selected, pilot in command(cfi) (contributing factor) - Loss of control - in flight, descent - uncontrolled - In flight collision with terrain/water, descent - uncontrolled - terrain condition - ground ## Analysis The 5,406-hour flight instructor was demonstrating a forced landing by simulating a loss of engine power when the single-engine airplane struck unmarked power lines approximately 30 feet above the ground. The training flight was the second flight for the student, who was a military officer enrolled in a government undergraduate flight training program. There were no reported witnesses to the accident, and no distress calls were received from the pilot. A postimpact fire consumed the composite airframe. Visual meteorological conditions prevailed and there were no obstructions to visibility at the time of the accident. Flight control continuity was established, and no mechanical anomalies or overdue inspections were noted with the engine or the airframe. ## Factual narrative HISTORY OF FLIGHT On September 21, 2005, at 1132 central daylight time, a single-engine Diamond Aircraft Industries DA20-C1 airplane, N63PA, was destroyed upon impact with terrain following an in-flight collision with power lines while maneuvering near Pleasanton, Texas. The certificated flight instructor (CFI) and non-certificated student receiving instruction sustained fatal injuries. The airplane was registered to Flying Monsters, Inc., of Plano, Texas, and was being operated by Check-Six Aviation, of San Antonio, Texas. Visual meteorological conditions prevailed and a flight plan was not filed for the instructional flight conducted under 14 Code of Federal Regulations Part 91. The local flight originated from the Stinson Municipal Airport (SSF), near San Antonio, Texas, approximately 1048. The student, a 2005 graduate of the United States Air Force Academy who was a commissioned Air Force officer, was enrolled in a government undergraduate pilot training flight program that provided 50-hours of introductory flight training. The Introductory Flight Training program is taught by Check-Six Aviation, an Federal Aviation Administration (FAA) Part 61 certificated flight school. The program requires all candidates to solo prior to 25 flight hours, and to earn their private pilot certificate within 50 consecutive flight hours. An FAA third-class student medical certificate is also required prior to solo; however, the student had not yet received the student pilot certificate. The accident flight was the student's second flight, after receiving 1.2-hours flight time on the first flight on September 20, 2005. During her first flight the CFI demonstrated maneuvers and procedures for the student, including collision avoidance techniques. The student sustained serious thermal injuries during the accident, but was able to give a recorded statement on October 8, 2005, to safety personnel from the Air Force Safety Center (AFSC). On January 10, 2006, the student succumbed to the accident injuries. The following excerpts were taken from the transcribed recorded statement: The student stated that the flight instructor, who was flying the airplane, was demonstrating a forced landing by simulating a loss of engine power. The flight instructor simulated the maneuver by retarding the engine to idle. After completing the checklist, the flight instructor continued the demonstration by selecting a strip of farmland and positioning the airplane for the simulated forced landing. The student noticed that the airstrip was really short, and remembered hearing the flight instructor say how this "probably wasn't the best piece to pick; and on our way back up, in front of us I could see power lines." She added "there was a real loud noise when we hit them.... I don't really remember much that happened after that." When asked by the AFSC personnel about the altitude of the airplane when the approach was made, her answer was, "really close, it was almost as if we were going to land; I don't remember how high an altitude it was though." The student added, "I remember thinking the people who live here are probably wondering why we were buzzing their house or something like that, cause we were really, I think we were that low." Another question asked by the AFSC personnel was about problems with either the airplane or engine, the answer was, "not really, we were fine." The flight school stated that the flight training/practice area is normally conducted within a triangular area from SSF south to Pleasanton, Texas, northeast to Floresville, Texas, and back to SSF. The area is locally referred to as the "south practice area," and the altitude may extend up to 9,000 feet; however, the airspace and altitude are training guidelines and not fixed parameters. A representative from American Electric Power (AEP) reported an electric power interruption at 1132 CDT, before arriving on-scene to repair two of five overhead power lines that were severed. The power company also stated that the 60-foot poles supporting the power lines are planted approximately nine feet into the ground, leaving 51 feet above grade level. The top two cables (about 0.37 inches in diameter) were shield lines, which do not carry line voltage; they were not damaged. The lower three cables (about 0.62 inches in diameter) were phase conductors, and are approximately the same height above the ground. The two cables nearest the wreckage were the ones severed. The estimated height above the ground of the severed cables, which included cable sag, was approximately 30 feet. The flight was not in contact with Air Traffic Control (ATC) at the time of the accident. No radio transmissions or distress calls were received from the aircraft. There were no reported eyewitnesses to the accident. PERSONNEL INFORMATION The 64-year old CFI, held an airplane single-engine land rating and an airline transport certificate with airplane single-engine land and multi-engine land ratings. The CFI also held an instrument airplane rating. The CFI's most recent FAA second-class medical certificate was issued on September 8, 2005, with the restriction of "holder shall possess glasses for near and intermediate vision." The pilot reported on the medical application that he had accumulated 5,406 hours of total flight time. The CFI was reported to be seated on the right seat of the side-by-side trainer. AIRCRAFT INFORMATION The 2004-model low-wing, two-place side-by-side composite airplane, serial number (S/N) C0269, featured a fixed tricycle landing gear. The airplane was powered by a single Teledyne Continental IO-240-B3B four-cylinder, horizontally opposed, fuel injected engine, S/N 650052, rated at 125 horsepower. The fixed pitch, two-bladed wood propeller, model W69EK7-63 was manufactured by the Sensenich Wood Propeller Company. According to the airframe and engine logbooks, the airplane's most recent Diamond 100-hour aircraft maintenance inspection, which included de engine and propeller, was performed on August 20, 2005. The airplane was found to be in an airworthy condition at that time. The airplane total time was recorded as 325.8 hours. Aircraft and engine total time since new was 396.8 hours at time of accident. The following two maintenance entries were recorded in the aircraft logbook: 1. August 23, 2005, an FAA form 8130-3 was submitted for the installation of up-dated software for the Garmin GTX-330 mode S transponder, as per Garmin Service Bulletin (SB) 0426. 2. Due to a low oil pressure gauge reading, the engine oil pressure relief spring, part number 627458, was replaced on September 7, 2005. After the maintenance action was accomplished, the engine was run, operationally checked, and the airplane was approved for return-to-service. On September 21, 2005, the aviation fuel refueling tracking form indicated that 6.3 gallons of fuel was dispensed to top-off the fuel tank. A fuel sample was taken by airport personnel on September 21, 2005. The fuel sample was found to be clear and bright with no anomalies noted. The examination of the maintenance records for the airplane did not reveal any unresolved maintenance discrepancies prior to the accident flight. METEOROLOGICAL INFORMATION At 1153, the automated surface observing system at SSF, which is approximately 22 miles North of the accident site, reported wind calm, visibility 10 statute miles, clear skies, temperature 32 degrees Celsius, dew point 19 degrees Celsius, and a barometric pressure at 30.07 inches of Mercury. The NTSB IIC calculated the density altitude at 2,406 feet. COMMUNICATION Air Traffic Control (ATC) recorded the communications between N63PA and ground control/tower at SSF. Houston Air Traffic Control Center (ARTC) provided an altitude profile using radar data from 1128 to the accident at 1132. Even though the accident airplan ## Aircraft - Registration: [N63PA](https://openairdocs.org/deregistered/N63PA-2007-08-28), registration cancelled 2007-08-28, S/N C0269 (OpenAirDocs) - Reported make and model: Diamond Aircraft Industries DA20-C1 - Registry model: [Diamond Aircraft Ind DA20-C1](https://openairdocs.org/model/diamond-aircraft-ind-da20-c1) (registry code 2990001) (OpenAirDocs) - Category: Airplane - Serial number: C0269 - Airframe hours: 397 - Engines: Diamond Aircraft DA20-C1 125 horsepower reciprocating - Damage: Destroyed - Fire: On-Ground - Flight: Instructional, Part 91 - Operator: Check-Six Aviation, Inc. - Registered owner: Flying Monsters, Inc. - Airworthiness certificate: Standard, Normal - Last inspection: Annual, August 1, 2005, 59.7 hours before - Departed: SSF, San Antonio, TX ## Flight crew As NTSB recorded them. NTSB leaves out names. - Flight instructor; age 64; injuries: fatal; commercial, airline transport, flight instructor; airplane ratings: single-engine land, multi-engine land; instrument ratings: airplane; medical: class 2, with waivers/limitations; last flight review August 1, 2004; seat: right; toxicology performed; flight hours: 5,406 total, 1 in the last 24 hours - Student pilot; injuries: serious ## Weather - Conditions: Visual (VMC), Day - Wind: 0° at 0 knots - Visibility: 10 statute miles - Temperature: 90 °F, dew point 66 °F - Altimeter: 30.06 inHg - Observed at: SSF, 21 nm away ## FAA reports on this event (1) The FAA's own accident and incident reports, matched to the aircraft by N-number and date (OpenAirDocs). - [Accident 20050921025299A](https://openairdocs.org/incident/20050921025299A), Sep 21, 2005: Diamon DA20C1, Pleasanton, TX, Destroyed, 1 fatal. (-23) On September 21, 2005, at 1132 CDT, a diamond aircraft da 20 C1, N63PA, was destroyed upon impact with terrain following an in-flight collision with… From the NTSB's public API. Aircraft are matched to registry aircraft by N-number and event date, checked against the reported serial number, make and model; the registry's history has gaps, so older matches can be wrong. Compare the reported make and model. --- OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.