# NTSB IAD01LA014: Gick Aerocomp CA6WB, N8181L, White Post, VA, November 18, 2000 - Type: NTSB accident investigation - Classification: Accident · No injuries · Limited investigation · Final report - Date: November 18, 2000, 10:41 local (15:41 UTC) - Place: White Post, VA - Coordinates: 39.0625, -78.09111 - Nearby events: https://openairdocs.org/map.md?lat=39.0625&lon=-78.0911&mi=10 - Phase of flight: [Landing](https://openairdocs.org/ntsb-phases/550) (OpenAirDocs' grouping) - Highest injury: No injuries - Injuries: 1 uninjured - Status: Completed, report February 7, 2002 - Report: Approved by Office Director - Parties: FAA FSDO - NTSB case key (mKey): 50649 - NTSB case page: https://web.ntsb.gov/investigations/?ntsbnumber=IAD01LA014 - NTSB report (PDF, downloads): https://data.ntsb.gov/carol-repgen/api/Aviation/ReportMain/GenerateNewestReport/50649/pdf - Page: https://openairdocs.org/ntsb/IAD01LA014 ## Probable cause The pilot's inadequate preflight. Also causal in the accident was the under-inflated tire that flattened and locked during landing, and collapsed the nose landing gear. ## Sequence of events In NTSB's coding before 2008 (https://www.ntsb.gov/GILS/Documents/codman.pdf). - Nose over, landing - roll - landing gear,tire - low pressure (cause) - aircraft preflight - inadequate, pilot in command (cause) - landing gear,nose gear - snagged (cause) ## Analysis The homebuilt airplane touched down on the turf runway, the nose gear collapsed, and the airplane nosed over. Both the pilot and the witness stated the main gear touched down first, then the nose gear. The pilot said the nose tire appeared to lock during the landing, but was free to rotate after the accident. Disassembly of the nose gear revealed the threaded end of the wheel-pant mount screw on the right side rested 1/8 of an inch from the sidewall of the tire. Circumferential scoring of the tire was noted directly across from the screw. The swiveling attach point for the wheel mount was forward of the tire. The distance from the swivel-mount bolt to the ground was 4 inches. The distance from the bottom of the wheel rim to the tire's contact patch was 4 inches. Tire pressure was measured at 11 psi. According to a vendor for the tire manufacturer, the tire pressure recommended for the nose-wheel tire was 50 psi. ## Factual narrative On November 18, 2000, at 1041 eastern standard time, a homebuilt Aerocomp CA6WB airplane, N8181L, was substantially damaged when it nosed over during a landing roll at the White Post Airport (3VA7), White Post, Virginia. The certificated commercial pilot was not injured. Visual meteorological conditions prevailed for the personal flight that originated at Winchester, Virginia (OKV), at 1005. No flight plan was filed for the flight, conducted under 14 CFR Part 91. In a written statement, the pilot said the purpose of the flight was to have maintenance performed on the engine's ignition system at the White Post Airport. He said the discrepancies were noted during the annual inspection that was performed the previous day. According to the pilot: "I overflew the airstrip while at pattern altitude for a visual inspection and made a left hand circuit to set myself up for landing. I flew a circuit to set myself up for an approximate one mile final, with an initial approach speed of 90 mph indicated. Since the approach was clear, I did a normal approach, slowing the aircraft to about 65 mph at the fence, and reduced power for landing. Touchdown was normal, on the main landing gear first, the nosewheel touched a few seconds later and during the rollout all appeared normal. Suddenly, the nose of the aircraft started going down with a simultaneous shudder of the aircraft. The nose of the aircraft contacted the ground, and at the end of a two or three second nose skid, [the airplane] slowly stood up on its nose, and fell over on its back. Points to be noted: 1. Nose wheel appears to have locked - similar to a wheel with the brakes locked. After the accident, the nose wheel was free! 2. No skid marks to indicate the use of brakes on wheels. 3. Nose wheel was on runway and rolling for 50 feet before it appears to have locked for the first time." In a telephone interview, a certificated airframe and powerplant mechanic said he witnessed the accident. According to the witness: "He made a low pass to have a look at the field. It's a real smooth, grass strip. He came in nose high and touched down on the mains. The nose wheel came down, the strut buckled, and that's it. I did see that the nose strut is totally inadequate for that big old O-540 engine." The pilot provided a detailed wreckage diagram and notes that outlined his observations. According to the diagram, the main landing gear touched down 240 feet beyond the approach end of the runway. The nose gear touched down 359 feet further beyond the approach end of the runway. Along the subsequent 165 feet of the wreckage path, the pilot noted ground scars that illustrated "the nosewheel appears to have locked" and "locked again." The pilot further documented ground scars from propeller and nose cowling strikes, and where the airplane nosed over and came to rest inverted. In a telephone interview, a representative of the kit manufacturer was asked about the numbers of kits delivered in either the nosewheel or tailwheel configuration. He said: "Almost all are tailwheels. [The accident] airplane is the only one with a nose wheel. I don't know of any piston powered CA6s that are nose wheels. The nose wheel hasn't been very popular. There was one other nose wheel airplane in Canada, but it was destroyed in a stall accident. The problems we've had with the nose wheel aircraft have all been pilot induced. There was a Comp Air 3 that was delivered as a nosewheel, but it's a taildragger now." The manufacturer's representative was asked if the company still sold the kits with the nose wheel configuration. He said: "Yes. But the nose wheel we would sell you would be the one from our turbine-powered airplanes, not the one from [the accident airplane]. It's a completely different design. It's for airplane's that weigh up to 6,000 pounds. That's the only one we offer anymore, it's very heavy duty. The one on [the accident airplane] was only for airplanes up to 3,200 pounds gross weight." Examination revealed the nose gear was a fixed, non-dampening tube bolted inside a tri-pod airframe mount. The nose-gear tire was a free-castering, non-steerable type, with no brakes installed. The gear was twisted and bent aft 90 degrees at the point where the tube entered the mount. Disassembly of the nose gear revealed that the threaded end of the wheel-pant mount screw on the right side rested 1/8 of an inch from the sidewall of the tire. Circumferential scoring of the tire was noted directly across from the screw. The swiveling attach point for the wheel mount was forward of the tire. The distance from the swivel-mount bolt to the ground was 4 inches. The distance from the bottom of the wheel rim to the tire's contact patch was 4 inches. Tire pressure was 11 psi. According to a vendor for the tire manufacturer, the tire pressure recommended for the nose-wheel tire was 50 psi. The pilot reported 10,000 hours of total flight experience. He reported 350 hours of experience in this type airplane, of which 4 hours were in the accident airplane. The winds reported at Winchester, Virginia, 5 miles north of White Post, were from 290 degrees at 9 knots. ## Aircraft - Registration: [N8181L](https://openairdocs.org/deregistered/N8181L-2012-05-18), registration cancelled 2012-05-18, S/N 97159, built 1999 (OpenAirDocs) - Reported make and model: Gick AEROCOMP CA6WB (AEROCOMP C) - Registry model: [Gick S/Gick P AEROCOMP CA6WB](https://openairdocs.org/model/gick-s-gick-p-aerocomp-ca6wb) (registry code 05606LR) (OpenAirDocs) - Registry engine: [Lycoming 0-540 series](https://openairdocs.org/engine/lycoming-0-540-series) (registry code 41532, reciprocating) (OpenAirDocs) - Category: Airplane, amateur-built - Serial number: 97159 - Engines: Lycoming O-540 250 horsepower reciprocating - Damage: Substantial damage - Flight: Personal, Part 91 - Operator: Leon Stoman - Registered owner: Pamela Gick - Airworthiness certificate: Special, Experimental (Special) - Last inspection: Annual, November 17, 2000, 1 hours before - Departed: OKV, WINCHESTER, VA - Destination: 3VA7, WHITE POST, VA - Airport: 3VA7, White Post, runway 220, 2,000 × 75 ft, grass/turf ## Flight crew As NTSB recorded them. NTSB leaves out names. - Pilot; age 38; injuries: none; commercial; airplane ratings: multi-engine land, single-engine land; instrument ratings: airplane; medical: class 2, valid medical--no waivers/lim.; flight hours: 10,000 total, 350 in this make and model, 250 in the last 90 days ## Weather - Conditions: Visual (VMC), Day - Wind: 290° at 9 knots - Visibility: 10 statute miles - Lowest ceiling: 4,300 ft overcast - Temperature: 37 °F, dew point 21 °F - Altimeter: 30.00 inHg - Observed at: OKV, 5 nm away ## FAA reports on this event (1) The FAA's own accident and incident reports, matched to the aircraft by N-number and date (OpenAirDocs). - [Accident 20001118043779A](https://openairdocs.org/incident/20001118043779A), Nov 18, 2000: Amtr COMPAIR6WB, White Post, VA, Substantial damage. (-23) On November 18, 2000, aircraft 8181L attempted a normal landing on a grass airstrip located at White Post, VA. The pilot stated that the aircraft touched… From the NTSB's public API. Aircraft are matched to registry aircraft by N-number and event date, checked against the reported serial number, make and model; the registry's history has gaps, so older matches can be wrong. Compare the reported make and model. --- OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.