# NTSB NYC95FA221: Robinson R-22 Beta, N22BX, Akron, OH, September 10, 1995 - Type: NTSB accident investigation - Classification: Accident · Fatal · Field investigation · Final report - Date: September 10, 1995, 17:50 local (21:50 UTC) - Place: Akron, OH - Coordinates: 41.039203, -81.480865 (estimated) - Nearby events: https://openairdocs.org/map.md?lat=41.0392&lon=-81.4809&mi=10 - Phase of flight: [Initial climb](https://openairdocs.org/ntsb-phases/350) (OpenAirDocs' grouping) - Highest injury: Fatal - Injuries: 1 fatal - Status: Completed, report May 29, 1996 - Report: Approved by Office Director - NTSB case key (mKey): 38865 - NTSB case page: https://web.ntsb.gov/investigations/?ntsbnumber=NYC95FA221 - NTSB report (PDF, downloads): https://data.ntsb.gov/carol-repgen/api/Aviation/ReportMain/GenerateNewestReport/38865/pdf - Page: https://openairdocs.org/ntsb/NYC95FA221 ## Probable cause the pilot's failure to maintain control of the rotor RPM, and his improper remedial action, which resulted in the rotor stalling. A contributing factor was the pilot's lack of recent experience in helicopters, and his lack of total experience in make and model. ## Sequence of events In NTSB's coding before 2008 (https://www.ntsb.gov/GILS/Documents/codman.pdf). - Loss of control - in flight, takeoff - initial climb - rotor rpm - not maintained, pilot in command (cause) - remedial action - improper, pilot in command (cause) - lack of recent experience in kind of aircraft, pilot in command (contributing factor) - lack of recent experience in type of aircraft, pilot in command (contributing factor) - In flight collision with terrain/water, descent - uncontrolled - terrain condition - ground ## Analysis The pilot had not logged any helicopter experience during the past 4-1/2 years. He purchased the helicopter and obtained the mandatory awareness training, with 10 hours of dual flight instruction required by SFAR 73; however, his instructors recommended he receive additional training before flying his helicopter. Eight days later, the helicopter was observed at 200 feet during takeoff, when it began to 'wobble.' The helicopter entered a spin and crashed on the airport. Examination of the wreckage revealed no pre-impact failure of the helicopter's systems or drive train. When placed on a test stand, the engine ran within normal limits. The pilot had 417 hours of total flight time in helicopters, of which 13 hours were in make and model. Segments of the awareness training presented to the pilot included low RPM rotor stall, and energy management and rotor RPM decay. This was the third hour logged on the helicopter since the pilot purchased it. ## Factual narrative HISTORY OF FLIGHT On September 10, 1995, at 1750 eastern daylight time, a Robinson R-22 Beta, N22BX, was destroyed when it impacted the ground after takeoff at the Akron-Fulton Airport, Akron, Ohio. The private pilot was fatally injured. Visual meteorological conditions prevailed, for the personal flight that originated from Akron-Canton, Ohio, about 1735. No flight plan had been filed for the flight conducted under 14 CFR Part 91. The pilot departed the Akron-Canton traffic pattern in N22BX, for the Akron-Fulton Airport (AKR). According to witnesses near AKR, the helicopter was observed hovering on the airport before takeoff. The helicopter departed to the north and climbed to about 200 feet, where it was observed to "wobble." A police officer who witnessed the accident stated: ...I heard what sounded like an aircraft engine suddenly running at full throttle. Looking up, I observed a small helicopter two to three hundred feet off the ground. The helicopter was at an odd attitude, with the tail at a down angle and wobbling back and forth. While I watched, the craft pitched sideways to the right and began to spin out of control, with the aircraft body revolving 360 degrees about 4 times, before impact. The tail rotor appeared to be spinning slower than normal as the blades were visible instead of the usual blur. Impact was in a bulldozed field... Another police officer who witnessed the accident stated: ...I saw the helicopter come across...It was swaying from left to right. It then made a U-Turn, and started to head back towards the airport. At that point it began to spin in circles and came straight down... The accident occurred during the hours of daylight about 41 degrees, 02 minutes north latitude, and 81 degrees, 28 minutes west longitude. PERSONNEL INFORMATION The pilot, Mr. Gerald P. Nye, held a Private Pilot Certificate with ratings for airplane single engine land, rotorcraft helicopter, and instrument airplane. His most recent Federal Aviation Administration (FAA) Third Class Medical Certificate was issued on October 19, 1993. Mr. Nye's pilot log books revealed that he had about 2,575 hours of total flight experience, of which 417 hours were in helicopters. According to the log books, he had not logged any helicopter flight hours between April 1991, and August 30, 1995. He logged a total of 10 hours of dual instruction in the R-22, on August 30, and September 1, 1995. His estimated total flight experience in the R-22 was 13 hours, which included 3 hours that was logged on the helicopter's hobbs meter, between August 11, 1995, and the accident. WRECKAGE AND IMPACT INFORMATION The helicopter wreckage was examined at the accident site on September 11 and 12, 1995. The examination revealed that all major components of the helicopter were accounted for at the scene. The helicopter came to rest upright, on a magnetic bearing of 195 degrees, on a level dirt area about 400 feet north of runway 27. Examination of the wreckage revealed that the lower right, aft side of the fuselage, was crushed upward. The tailboom was buckled upward at the fuselage attaching point, and about 4 feet forward of the tail rotor gear box. The examination further revealed no pre-impact failure of helicopter systems or structures. Control continuity was confirmed from the pilot's flight controls, to the cyclic, collective and tail rotor. Drive train continuity was confirmed from the engine, through the transmission, to the main rotor. Continuity was also confirmed to the tail rotor drive shaft; however, the shaft was observed to be buckled and separated near the tail rotor gear box. There were no rotational scratches on the inside tailboom paint, where the shaft end was laying against the tailboom. The main rotor blades displayed symmetrical upward coning, with corresponding chord wise wrinkling. There was no leading edge damage or marks on the rotor blades. A few chord wise scratches were observed on the yellow paint, on the lower side of both blades tips. Yellow paint was observed on the white tailboom, in the vicinity of the crushed area, where the tail rotor drive shaft was separated inside the boom. One tail rotor blade was bent over at a 90 degree angle, a few inches from the hub. Neither of the tail rotor blades displayed any chord wise scratches nor leading edge damage. The main fuel tank was bulged outward, ruptured, and absent of fuel. The airframe fuel filter contained a few ounces of fuel. The fuel sample was tested with water finding paste and found to be absent of water. The engine cooling fan was observed to be crushed on one side. No rotational scratches were observed. The engine was removed from the wreckage for further examination. MEDICAL AND PATHOLOGICAL INFORMATION An autopsy was performed on Mr. Gerald Nye, on September 11, 1995, by Dr. William A. Cox, Coroner of Summit County, Ohio. Toxicological testing was conducted by the FAA Toxicology Accident Research Laboratory, Oklahoma City, Oklahoma. TESTS AND RESEARCH The engine was examined and test run at the Textron-Lycoming Facility, Williamsport, Pennsylvania, on October 31, 1995. Present during the examination were representatives from Lycoming, and the National Transportation Safety Board. The examination revealed that the timing of the left and right magnetos were set 4 and 5 degrees late, respectively. The carburetor fuel inlet finger screen, and the oil sump screen, were absent of debris. Due to impact damage, components replaced included the number two cylinder intake sump tube, number two and four intake pipe tubes, right magneto wiring harness, starter motor, and the carburetor pump inlet strainer housing (dome only). The engine was placed on a test stand, started, and ran within normal limits for about 30 minutes. ADDITIONAL INFORMATION The pilot purchased the helicopter on August 11, 1995, and helped ferry it to the Akron-Canton Airport. The pilot received the mandatory R-22 awareness training, required by SFAR 73, in West Mifflin, Pennsylvania, on August 31, and September 1, 1995. The training was not a qualification course, and the pilot did not receive a "sign-off" in the R-22. In a written statement, one of the flight instructors who flew with the pilot stated: ...I conducted the first session of his flight training...[The pilot] seemed to resent the fact that he had to take any training since he was already a rated helicopter pilot...he told me that he had 'a lot of time in the R22,' and had recently purchased one...[He] appeared knowledgeable about the operation of helicopters during the preflight briefing, but prior to liftoff, [he] asked me to 'stay close on the controls' since he did not have a lot of R22 time...By the end of the session [he] performed the awareness maneuvers satisfactorily...During the post flight briefing...I also discussed the differences between the R22 and the other helicopters that he had flown (especially in respect to rotor inertia), and recommended that when he returned to Akron he should seek additional training in the R22, especially since he did not appear from his logbooks to have much recent helicopter time. (Although [he] claimed he was current in helicopters, the last logbook he could produce showed no helicopter time since 1991)...As [he] was preparing to leave, [the flight school owner] strongly recommended that he receive more training at his home base... In a written statement, the owner of the flight school stated: ...[The pilot] requested and received the ten hours of dual instruction required by SFAR 73...We trained him without the ## Aircraft - Registration: [N22BX](https://openairdocs.org/deregistered/N22BX-2012-09-06), registration cancelled 2012-09-06, S/N 1050, built 1989 (OpenAirDocs) - Reported make and model: ROBINSON R-22 BETA - Registry model: [Robinson Helicopter R22 BETA](https://openairdocs.org/model/robinson-helicopter-r22-beta) (registry code 7640110) (OpenAirDocs) - Registry engine: [Lycoming 0-320 series](https://openairdocs.org/engine/lycoming-0-320-series) (registry code 41508, reciprocating) (OpenAirDocs) - Category: Helicopter - Serial number: 1050 - Airframe hours: 2831 - Engines: LYCOMING O-320-B2C 160 horsepower reciprocating - Damage: Destroyed - Flight: Personal, Part 91 - Registered owner: Gerald P. Nye - Airworthiness certificate: Standard, Normal - Last inspection: 100 hour, June 28, 1995, 49 hours before - Departed: CAK, CANTON, OH - Destination: AKR - Airport: AKR, Akron-Fulton Intl ## Flight crew As NTSB recorded them. NTSB leaves out names. - Pilot; age 61; private; airplane ratings: single-engine land; instrument ratings: airplane; medical: class 3, valid medical--w/ waivers/lim; seat: right; toxicology performed; flight hours: 2,575 total, 13 in this make and model, 2,511 as pilot in command, 37 in the last 90 days, 14 in the last 30 days ## Weather - Conditions: Visual (VMC), Day - Wind: 10° at 8 knots - Visibility: 10 statute miles - Lowest ceiling: none - Temperature: 63 °F, dew point 39 °F - Altimeter: 30.00 inHg - Observed at: CAK, 7 nm away ## FAA reports on this event (1) The FAA's own accident and incident reports, matched to the aircraft by N-number and date (OpenAirDocs). - [Accident 19950910028089A](https://openairdocs.org/incident/19950910028089A), Sep 10, 1995: Robsin R22BETA, Akron, OH, Destroyed, 1 fatal. Climbed to 200 AGL. Wobbled turned back and spun to ground. No control anomalies. Engine to be examined. (-23) helicopter departed to the north and climbed to… From the NTSB's public API. Aircraft are matched to registry aircraft by N-number and event date, checked against the reported serial number, make and model; the registry's history has gaps, so older matches can be wrong. Compare the reported make and model. --- OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.