# NTSB WPR24LA110: Beech 60, N167U, Chino, CA, March 11, 2024 - Type: NTSB accident investigation - Classification: Accident · No injuries · Class 3 · Limited · Final report - Date: March 10, 2024, 23:30 local (Mar 11, 2024, 06:30 UTC) - Place: Chino, CA - Coordinates: 33.973062, -117.636 - Nearby events: https://openairdocs.org/map.md?lat=33.9731&lon=-117.6360&mi=10 - Phase of flight: [Landing](https://openairdocs.org/ntsb-phases/550) (OpenAirDocs' grouping) - Defining event: [Landing: Sys/Comp malf/fail (non-power)](https://openairdocs.org/ntsb-events/330) - Highest injury: No injuries - Injuries: 6 uninjured - Status: Completed - Report: Approved by Office Director - Investigation class: Class 3 - NTSB office: Western Pacific Region - Parties: Textron Aviation, Federal Aviation Administration - NTSB case key (mKey): 193931 - NTSB case page: https://web.ntsb.gov/investigations/?ntsbnumber=WPR24LA110 - NTSB report (PDF, downloads): https://data.ntsb.gov/carol-repgen/api/Aviation/ReportMain/GenerateNewestReport/193931/pdf - NTSB docket: https://data.ntsb.gov/Docket?ProjectID=193931 - Page: https://openairdocs.org/ntsb/WPR24LA110 ## Probable cause Corrosion on a landing gear retract rod assembly which precluded an extension of the gear and resulted in a gear-up landing. ## Findings NTSB's coded findings; those marked are part of the probable cause. - [Landing gear system: gear extension and retract sys](https://openairdocs.org/ntsb-findings/01023230): Aircraft › Aircraft systems · Fatigue/wear/corrosion (probable cause); cases with it: [Beech 60, 1 case](https://openairdocs.org/ntsb-findings/01023230/cases.md?model=1153602), [All aircraft, 416 cases](https://openairdocs.org/ntsb-findings/01023230/cases.md) - [Landing gear system: main landing gear](https://openairdocs.org/ntsb-findings/01023210): Aircraft › Aircraft systems · Failure (probable cause); cases with it: [Beech 60, 1 case](https://openairdocs.org/ntsb-findings/01023210/cases.md?model=1153602), [All aircraft, 241 cases](https://openairdocs.org/ntsb-findings/01023210/cases.md) ## Sequence of events The events NTSB coded, in order, by phase of flight. The defining event best describes what happened. - [Landing: Sys/Comp malf/fail (non-power)](https://openairdocs.org/ntsb-events/330) (defining event); cases with it: [Beech 60, 1 case](https://openairdocs.org/ntsb-events/330/sequence.md?model=1153602), [All aircraft, 994 cases](https://openairdocs.org/ntsb-events/330/sequence.md) ## Analysis After an uneventful flight, the pilot attempted to extend the landing gear in preparation for landing and observed that the left main landing gear green light annunciator was extinguished. He cycled the landing gear, changed the annunciator light bulb, and attempted to manually extend the landing gear; however, the pilot was unable to extend the landing gear or prompt a green light on the instrument panel to indicate the left main landing gear was down. The pilot then landed with the left main gear retracted, which resulted in substantial damage to the left wing. Postaccident examination of the landing gear system revealed that the gear motor functioned normally. Both manual and automatic extension of the left main landing gear failed due to a separation in the retraction rod assembly. The main gear retract system includes a pressure boot that is attached to a bushing on the retract rod assembly that extends and retracts the landing gear. A metallurgical examination of the landing gear retract rod found that the rod fractured due to buckling from compression overload during the landing gear extension. The primer on the rod was worn where the bushing for the pressure boot slides along the rod during extension and retraction operations, which exposed the underlying steel surfaces to oxidation. The bushing likely seized on the corroded (oxidized) rod near the retracted position due to increased friction from the accumulation of corrosion products. The rod then buckled during normal extension operations due to constraint from the pressure boot and the seized bushing. With the rod segment outboard of the bushing held in place near the retracted position by the pressure boot and seized bushing, the left main landing gear would not have been able to extend when the main landing gear actuator rotated to extend the gear. The maintenance logbooks indicated that the retract rod would have been inspected during the annual inspection seven months before the accident; however, it is unknown if a visual inspection would have found the wear on the retract rod. ## Factual narrative On March 10, 2024, about 2330 Pacific daylight time, a Beechcraft 60, N167U, was substantially damaged when it was involved in an accident near Chino, California. The pilot and five passengers were not injured. The airplane was operated as a Title 14 Code of Federal Regulations Part 91 personal flight. According to the pilot, he extended the landing gear about five miles from his destination airport and noticed that the left main landing gear green annunciator light was OFF. He cycled the landing gear, but observed the same result. The pilot also changed the left landing gear annunciator light bulb during the accident flight, but the annunciator light remained OFF. He then overflew the airport while he attempted to manually extend the landing gear with the hand crank, but was still unable to extend the left main landing gear. He then landed with the left main landing gear retracted, which resulted in substantial damage to the left wing. A postaccident gear swing revealed that the landing gear system retracted and extended normally with exception of the left main landing gear, which had a broken main gear retract rod assembly. The examination also found that the left main landing gear retract rod had punctured the gearbox case. In addition, the uplock cable was severed at the wheel well. The emergency gear extension functioned normally when tested. The broken cable was isolated at both ends and retained for metallurgical examination as was the left landing gear retract rod assembly and the pressure boot. A metallurgical examination of the retained parts revealed that the left main landing gear retract rod exhibited fracture features consistent with ductile overstress. The overall deformation and fracture pattern was consistent with buckling from compression loading. The bushing for the pressure boot was located outboard of the outboard fracture in the retract rod and did not move under hand forces. The retract rod displayed a yellowish-green coating, consistent with primer, at the inboard end. The outboard end had white paint covering the yellowish-green coating. A portion of the retract rod on either side of the pressure boot bushing had a green coating, also consistent with primer. Rub marks were observed on the green primer, which exposed bare metal, and sliding contact marks were observed inboard of the bushing. The remaining green primer was substantially bubbled and flaked away from oxidation of the underlying surface. The uplock cable fracture surfaces exhibited contact damage from another object at the fracture location, and the wires were thinned consistent with ductile overstress fracture. No evidence of a progressive mechanism such as fatigue was observed. According to the manufacturer, the rod assembly is attached to the gear motor and serves as the linkage for the gear retraction process. The maintenance manual states, “The landing gear motor is controlled by the gear extension switch located on the left subpanel. The larger upperarms and the lower arm of the actuator, in conjunction with rod assemblies and linkage, control extension and retraction of the main and nose landing gear. Rod assemblies attached to the smaller upper actuator arms operate the inboard main landing gear doors.” The manufacturer’s 100 hour/annual inspection guidance does not include any specific criteria to inspect the main landing gear linkages; however, Appendix D to 14 Code of Federal Regulations Part 43 does require that “each person performing an annual or 100-hour inspection shall inspect…linkages, trusses, and members for undue or excessive wear fatigue and distortion.” The regulation also requires an inspection of the retraction and locking mechanism for improper operation. According to the airplane’s maintenance logbooks, the most recent annual inspection, completed seven months before the accident, “Inspected this aircraft FAR 43 appendix D checklist for Annual inspection…inspected and greased all wheel bearings, serviced brake’s reservoir, tested landing gear and systems with airplane on jacks, no defects found.” A review of the airplane logbooks from 2001 to present did not reveal any adjustments or modifications to the retraction linkage. The landing gear motor was replaced in 2006; however, the maintenance excerpt did not include any adjustments to the retract assembly. ## Aircraft - Registration: [N167U](https://openairdocs.org/aircraft/N167U), registered now, S/N P-99 (OpenAirDocs) - Reported make and model: BEECH 60 - Registry model: [Beech 60](https://openairdocs.org/model/beech-60) (registry code 1153602) (OpenAirDocs) - Registry engine: [Lycoming TI0-541 series](https://openairdocs.org/engine/lycoming-ti0-541-series) (registry code 41536, reciprocating) (OpenAirDocs) - Category: Airplane - Serial number: P-99 - Airframe hours: 7855.3 - Engines: Lycoming TIO-541 380 hp reciprocating; Lycoming TIO-541 380 hp reciprocating - Damage: Substantial damage - Flight: Personal, Part 91 - Registered owner: Jarochos Enterprises Inc - Airworthiness certificate: Standard, Normal - Last inspection: Annual, August 18, 2023 - Departed: GYR, Goodyear, AZ - Destination: Same as departure - Airport: CNO, Chino, runway 08R/26L, 7,000 × 150 ft, asphalt - Equipment: Auto-pilot, ADS-B ## Flight crew As NTSB recorded them. NTSB leaves out names. - Pilot; age 63; injuries: none; flight instructor, commercial; airplane ratings: multi-engine land, single-engine land; instrument ratings: airplane; medical: class 2, with waivers/limitations; last flight review July 16, 2023; seat: left; restraint: lap only; flight hours: 8,281 total, 150 in this make and model, 15.4 in the last 90 days, 5.8 in the last 30 days ## Weather - Conditions: Visual (VMC), Night - Wind: 260° at 7 knots - Visibility: 10 statute miles - Temperature: 52 °F, dew point 46 °F - Altimeter: 30.06 inHg - Observed at: KCNO, 1 nm away - METAR: METAR KCNO 110553Z AUTO 26007KT 10SM CLR 11/08 A3006 RMK AO2 SLP177 T01060078 10200 20106 50011 $= ## FAA reports on this event (1) The FAA's own accident and incident reports, matched to the aircraft by N-number and date (OpenAirDocs). - [Accident 20240310002779A](https://openairdocs.org/incident/20240310002779A), Mar 10, 2024: Beech 60, Chino, CA, Substantial damage. On March 10, 2024, at approximately 23:50 local time, a Beechcraft 60 multi-engine piston-powered fixed-wing aircraft, [privacy data omitted], was arriving on… ## Docket (9 files) The files NTSB released with the investigation on February 26, 2025, on NTSB's docket system: https://data.ntsb.gov/Docket?ProjectID=193931. 10.9 MB in all. - Pilot/operator aircraft accident report, NTSB form 6120.1 (item 1, PDF, 8 pages, 4.7 MB): https://data.ntsb.gov/Docket/Document/docBLOB?ID=18091523&FileExtension=pdf&FileName=6120_Redacted-Rel.pdf - FAA email correspondence, exam observations (item 2, PDF, 2 pages, 374 KB): https://data.ntsb.gov/Docket/Document/docBLOB?ID=18092100&FileExtension=pdf&FileName=FAA%20notes%20gear%20swing_Redacted-Rel.pdf - Record of conversation, mechanic examination report (item 3, PDF, 1 page, 76 KB): https://data.ntsb.gov/Docket/Document/docBLOB?ID=18091667&FileExtension=pdf&FileName=MOR%20mechanic%20report-Rel.pdf - Maintenance logbook excerpt (item 4, PDF, 1 page, 3.7 MB): https://data.ntsb.gov/Docket/Document/docBLOB?ID=18165336&FileExtension=pdf&FileName=mx%20logbook%20excerpt_Redacted-Rel.pdf - Excerpt from ipc of landing gear retract mechanism (item 5, PDF, 7 pages, 318 KB): https://data.ntsb.gov/Docket/Document/docBLOB?ID=18092110&FileExtension=pdf&FileName=main%20gear%20retract%20mechanism%20from%20IPC-Rel.pdf - Excerpt from maintenance manual (item 6, PDF, 3 pages, 161 KB): https://data.ntsb.gov/Docket/Document/docBLOB?ID=18092439&FileExtension=pdf&FileName=maintenance%20manual%20excerpt-Rel.pdf - Materials laboratory factual report 24-037 (item 7, PDF, 5 pages, 1 photo, 361 KB): https://data.ntsb.gov/Docket/Document/docBLOB?ID=17927626&FileExtension=pdf&FileName=24-037-Rel.pdf - Release of aircraft wreckage, NTSB form 6120.15 (item 8, PDF, 1 page, 410 KB): https://data.ntsb.gov/Docket/Document/docBLOB?ID=18092217&FileExtension=pdf&FileName=NTSB%20release_redacted-Rel.pdf - Statement of party representatives to NTSB investigation (item 9, PDF, 1 page, 784 KB): https://data.ntsb.gov/Docket/Document/docBLOB?ID=18160675&FileExtension=pdf&FileName=party%20form_Redacted-Rel.pdf From the NTSB's public API. Aircraft are matched to registry aircraft by N-number and event date, checked against the reported serial number, make and model; the registry's history has gaps, so older matches can be wrong. Compare the reported make and model. --- OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.