# Britten-Norman Service Bulletin 398: Revision 2

- Rights: © Britten-Norman. Filed by the FAA in regulations.gov docket FAA-2024-0044; AD 2024-08-03 incorporates this document by reference. Not covered by OpenAirDocs’ CC0 dedication.
- Document: [Britten-Norman Service Bulletin 398](https://openairdocs.org/service-documents/britten-norman/sb-398.md)
- Title as filed: Britten-Norman Service Bulletin SB 398 Issue 2
- Pages: 7
- PDF: https://openairdocs.org/files/sha256/f2/65/f265d1e9c5fef9bdf2a8de582522083f2741175797c10905082f8c1562be6c20
- Page: https://openairdocs.org/service-documents/britten-norman/sb-398/file/f265d1e9c5fe

## Text

Some pages are OCR from a scan. OCR can misread letters and numbers. Each page's text from the PDF; open the PDF at a page with #page=N.

### Page 1

SERVICE 
BULLETIN  
 
30/05/2022 SB 398 
Issue 2 Page 1 of 7 
Template: DT-DF-028_V2.0 
Models Affected Service Bulletin Number 
All BN2 Series Islander and Trislander Aircraft. 
 
SB 398 
Issue 2 – 30/05/2022 
RECOMMENDED ACTION TO INSPECT CABLE ROUTING BEHIND THE 
INSTRUMENT PANEL FOR INTERFERENCE WITH CONTROL COLUMN 
This is a highly recommended safety related Service Bulletin. Mandatory Action is expected. 
1 COMPLIANCE STATEMENT 
Compliance is required within the next 100 flying hours of the release of this SB at Issue 2. 
 
Further work is required at Issue 2 of this Service Bulletin due to the introduction of clarification for a “Freedom” or 
“Full and Free Movement Check” to ensure no further cable interference with the control column. 
2 INTRODUCTION 
Britten-Norman Aircraft have been made aware of instances of cables interference on the control column which has 
the potential to restrict full and free movement of the flight controls.  This Service Bulletin introduces actions to be 
taken on finding such fouling. 
Issue 1 introduced a one-time inspection for interference between the rudder pedal and control column.  
Issue 2 clarifies and requires the “Freedom” ('Full and Free Movement Check) to ensure no further interference.   
3 APPLICABILITY 
This Service Bulletin is applicable to all BN2 series Islander and Trislander aircraft. 
4 EFFECT ON WEIGHT AND BALANCE 
None. 
5 EFFECT ON PUBLICATIONS 
The aircraft publications will be amended as necessary by normal revision action.  The manuals affected are as 
follows:- 
MM/1 – BN2A / BN2B Series 
MM/2 – Trislander Series

### Page 2

Service Bulletin 
 
SB 398 30/05/2022 
Page 2 of 7 Issue 2 
 Template: DT-DF-028_V2.0 
MM/4 – BN2T Series 
AMP – BN2T-4S Series 
 
A General Aircraft Flight Manual Supplement for the clarification of flight controls 'Freedom' check, 
effective to all aircraft  will also be released. Reference General Supplement 24 , Titled “Supplemental 
Information For Conduct Of Flying Control Freedom Checks.” 
6 INSPECTION 
Operators are requested to examine  behind the instrument panel , between applicable fuselage station numbers 
(see Table 1 below), to ensure all cables and wiring to the instrument panel and in the surrounding area are routed 
securely and there is a clearance to allow full and free movement of the flight controls.  
Particular attention should be taken to the routing of the Rudder Ped al Adjuster Cable and the Koiled Kord  by 
ensuring the Koiled Kord between the control column and the terminal block is routed and secured clear of the 
Rudder Pedal Adjuster cable for all positions of the control column and positions of the Rudder Pedal ass embly.  
  
AIRCRAFT TYPE FORWARD FRAME 
STATION NUMBER 
AFT FRAME 
STATION NUMBER 
REFERENCE 
IMAGE 
BN2A, BN2B, BN2T 
Series  46 66 Figure 1 
BN2T-4S 16 36 Figure 2 
Trilander 56.95 76.95 Figure 3 
Table 1: Fuselage Station Number  s for inspection in Section 7. 
Figure 1: BN2A, BN2B, BN2T Series Fuselage Frame Stations

### Page 3 (OCR)

Service Bulletin
Vertical
Datum
STA 0.O
-48.25  -11.0 16.0 41.5
47.0  79.0 &
81.55
BN2T-4S
Figure 2: BN2T-4S Fuselage Frame Stations
Vertical
Datum
STA O.0  29.95  76.95  122.85
56.95  87.95
6.5  43.45  82.45  104.4 125.4
Trilander
Figure 3: Trilander Fuselage Frame Stations
7  ACTION
1) Check for evidence of interference between the control column, the rudder pedal adjuster cable and any
wiring (including the Koiled cord) whilst performing a control column "Freedom" (Full and Free
Movement) check. For a control column "Freedom" (Full and Free Movement) check procedure, refer to
Para 8.
30/05/2022  SB 398
Issue 2  Page 3 of 7

### Page 4

Service Bulletin 
 
SB 398 30/05/2022 
Page 4 of 7 Issue 2 
 Template: DT-DF-028_V2.0 
2) If evidence of interference is found during the check then the cables must be securely tied clear of the 
control column for its full range of motion.  
3) In the event that inspections result in evidence of interference, ensure the contacting parts are defect 
free prior to securing. 
4) Perform a final control column “Freedom” (Full and Free Movement) check  as detailed in Para  8  to 
ensure no freeplay, friction, binding, non-linear forces and any possible mutual interference. 
8 FLYING CONTROLS FULL-AND-FREE MOVEMENT CHECKS 
The Islander Flight Manual requires a “Freedom” (Full and Free Movement) check of the flying controls to be verified 
as part of the pre -take-off checks.  This requires the controls to be exercised to extremes of deflection in all axes 
concurrently.  This should be achieved as follows: 
 
1) Full left rudder. 
2) Control column fully forward and control wheel fully left/anti-clockwise. 
3) Wheel held and control column moved fully aft. 
4) Control column held and control wheel fully right/clockwise. 
5) Wheel held and control column fully forward. 
6) Flying controls neutral. 
7) Full right rudder. 
8) Repeat steps 2-5 in opposite direction (i.e. control wheel fully right/clockwise first). 
9) Flying controls neutral. 
 
Note: during the control inputs any freeplay, friction, binding, non-linear forces and any possible mutual interference 
should be carefully investigated.  Aileron movement should be visually assessed to ensure full travel in the correct 
sense.  Any abnormal results must be fully investigated and resolved before flight.  
9 MANPOWER 
This procedure will take between 1 and 4 hours to complete. 
10 PROVISIONING 
Service Bulletin SB 398  can be obtained from Britten-Norman Customer Services Department ,  
Britten-Norman, Bembridge Airport, Isle of Wight, PO35 5PR, United Kingdom. 
 
For more information, contact the Customer Support Department at Britten-Norman:  
• Post: Britten-Norman, Bembridge Airport, Isle of Wight. PO35 5PR United Kingdom  
• Telephone: +44 (0) 20 3371 4000  
• Facsimile: +44 (0) 20 3371 4001  
• E-mail: customer.support@britten-norman.com

### Page 5

Service Bulletin 
 
30/05/2022 SB 398 
Issue 2 Page 5 of 7 
11 FOLLOW ON ACTION 
Make an entry in the aircraft log book, and all other related maintenance documentation, that SB 398  Issue 2 has 
been completed. 
If any interference is found du ring the inspection outlined in Section 7 of this document, operators are required to 
complete the operator feedback form at Appendix A and return it to Britten -Norman Customer Support using the 
contact details given above. 
12 APPROVAL  
The technical content of this document is approved under the authority of the DOA ref. UK.21J.0138. 
 
 
Signed:  .............................................................................................................  
 
Date:  .................................................................................................................  
  
30/05/2022

### Page 6

Service Bulletin 
 
SB 398 30/05/2022 
Page 6 of 7 Issue 2 
 Template: DT-DF-028_V2.0 
13 APPENDIX A – OPERATOR FEEDBACK 
OPERATOR DETAILS 
Company 
Name 
 
Contact 
Person 
 
Contact 
address 
 
 
 
Telephone 
Number 
 
Email Address  
AIRCRAFT DETAILS 
Model/Type  
Registration 
Number 
 
Constructor 
Number 
 
Total flying 
Hours 
 
Total landings

### Page 7

Service Bulletin 
 
30/05/2022 SB 398 
Issue 2 Page 7 of 7 
Please record below the details of the cable interference found during the inspection described in 
Section 7 of SB 398. A separate form should be filled out for each aircraft owned by the operator. 
Details of cable interference including affected part numbers:

---
OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain, except the copies of manufacturers’ service documents, which belong to their rights holders.
