# Dassault Service Bulletin F2000-401: Revision 1 - Rights: © Dassault Aviation. Filed by the FAA in regulations.gov docket FAA-2014-0657; AD 2016-09-03 incorporates this document by reference. Not covered by OpenAirDocs’ CC0 dedication. - Document: [Dassault Service Bulletin F2000-401](https://openairdocs.org/service-documents/dassault/f2000-401.md) - Title as filed: SB F2000-401 R1 - Pages: 10 - PDF: https://openairdocs.org/files/sha256/66/c1/66c1e5a1ad18b21c8550cc81d0b7a3a2d4010db1c567234c6f560ac1e1e04762 - Page: https://openairdocs.org/service-documents/dassault/f2000-401/file/66c1e5a1ad18 ## Text Some pages are OCR from a scan. OCR can misread letters and numbers. Each page's text from the PDF; open the PDF at a page with #page=N. ### Page 1 FALCON 2000 No 401-R1 JULY 13, 2012 ATA 25-30 EQUIPMENT/FURNISHINGS PILOT AND COPILOT SEAT INSTALLATION IMPROVEMENT FALCON SERVICE BULLETIN Copyright © 2012 by Dassault Aviation All rights reserved. No part of this work may be reproduced or copied in any form or by any means without written permission of Dassault Aviation. 554 ### Page 2 EQUIPMENT/FURNISHINGS PILOT AND COPILOT SEAT INSTALLATION IMPROVEMENT Initial issuance May 15, 2012 List of effective pages : 6 Revision 1 July 13, 2012 List of effective pages : 1 to 6 List of modified pages : 4 and 5 REASON:Modification of the kit and addition of Service Bulletin identification. This revision is applicable to aircraft already modified per the initial issuance of this Service Bulletin. FALCON 2000 F2000-401 F2000-25-30 ### Page 3 EQUIPMENT/FURNISHINGS PILOT AND COPILOT SEAT INSTALLATION IMPROVEMENT 1. PLANNING INFORMATION A. EFFECTIVITY This Service Bulletin is applicable to FALCON 2000 aircraft with serial numbers 1 through 231 which have already performed their first "C" inspection. B. REASON A Falcon operator reported that during take-off at rotation phase, the copilot seat slid aft. Investigations showed that one locking spring fitted on a seat locking pin was broken and the other one weak. The purpose of this Service Bulletin is to replace the locking springs on both pilot and copilot seats and then, check the correct locking of the seats on all aircraft which have already performed their first "C" inspection. NOTE: The replacement of these springs and the check of the correct locking of the seats will be added in to next revision of the scheduled maintenance program, every "C" inspection. C. DESCRIPTION The operation consists in: • replacing the locking pin springs of each seat, • verifiying the correct locking of the seat after improvement. D. COMPLIANCE If you choose to comply with this Service Bulletin, accomplishment should be performed at the first opportunity but no later than the next "A" inspection. E. APPROVAL The technical content of this document is approved under the authority of DOA nr. EASA.21J.051. F. LABOR Estimated labor-hours: 2 hours per seat. NOTE: These labor-hours only concern the work described in this Service Bulletin and do not include other maintenance work which may be performed on this occasion. G. MATERIAL - PRICE AND AVAILABILITY The modification kit may be obtained from either address listed below: FALCON 2000 F2000-401 July 13, 2012 F2000-25-30 Revision 1 Page 1 / 6 DASSAULT AVIATION Proprietary Data ### Page 4 Western hemisphere: DASSAULT FALCON JET CORP. SPARES DISTRIBUTION CENTER 200 RISER ROAD LITTLE FERRY, NJ 07643 U.S.A. Telephone: • CANADA and U.S.A.: 1-800-800-4036 • MEXICO: 001-800-800-4036 • Other countries: 1-201-541-4809 Fax: • CANADA and U.S.A.: 1-800-800-4817 • MEXICO: 001-800-800-4817 • Other countries: 1-201-440-7021 Other continents: DASSAULT AVIATION Falcon Spares BOITE POSTALE N101 AEROPORT DU BOURGET 93350 - LE BOURGET Cedex (FRANCE) Please contact your Dassault Aviation Account Representative Telephone: 33 (0)1.48.35.56.78 Fax: 33 (0)1.48.35.56.00 Price and availability on request. H. TOOLING - PRICE AND AVAILABILITY Normal maintenance tooling. I. WEIGHT AND BALANCE Change in weight: None. Change in balance with respect to 25% MAC: None. J. REFERENCES Aircraft Maintenance Manual: • GENERAL MAINTENANCE AND SAFETY PRECAUTIONS (Refer to TASK 20-00-00-910-801) • REMOVAL / INSTALLATION OF THE PILOT SEATS (Refer to TASK 25-11-01-900-801) K. OTHER PUBLICATIONS AFFECTED The following publications will be revised at a later date to account for the changes introduced by this Service Bulletin: • Illustrated Parts Catalog. • Aircraft Maintenance Manual. • Chapter 5. FALCON 2000 F2000-401 July 13, 2012 F2000-25-30 Revision 1 Page 2 / 6 DASSAULT AVIATION Proprietary Data ### Page 5 2. ACCOMPLISHMENT INSTRUCTIONS A. PRELIMINARY STEPS (1) The aircraft must be in the maintenance configuration (Refer to TASK 20-00-00-910-801). (2) Set the LH pilot seat (L2MG) and the RH pilot seat (R2MG) to the high position, using the LH pilot seat height adjustment switch (L3MG) and the RH pilot seat height adjustment switch (R3MG). (3) Remove the pilot seats (Refer to TASK 25-11-01-900-801 , paragraph "Removal of pilot or copilot seat"). B. REMOVAL Refer to fig. 1 (1) Remove and discard the pin (1). (2) Remove the ring (2). (3) Remove the two nuts (3). (4) Record the position of the spacer (5). (5) Remove the two screws (4). (6) Remove the spacer (5). (7) Remove the front pad (6). (8) Remove the locking pin (7). (9) Remove and discard the spring (8) from the locking pin (7). C. INSTALLATION Refer to fig. 1 (1) Install a new spring (8) on the locking pin (7). (2) Install the locking pin (7). (3) Install the front pad (6). (4) Install the spacer (5) at the position recorded on removal. (5) Install the two screws (4). (6) Install the two nuts (3). (7) Tighten the two nuts (3). (8) Install the ring (2). (9) Install a new pin (1). D. FINAL STEPS (1) Check the seat tracks and the corresponding attachment fittings for condition. CAUTION: DO NOT APPLY LUBRICANT OR GREASE ON THE SEAT TRACK. FALCON 2000 F2000-401 July 13, 2012 F2000-25-30 Revision 1 Page 3 / 6 DASSAULT AVIATION Proprietary Data ### Page 6 (2) Clean the seat tracks with a cloth dampened with cleaner to remove residue or dust, especially in the locking holes. (3) Install the pilot seats (Refer to TASK 25-11-01-900-801 , paragraph "Installation of pilot or copilot seat"). (4) For A/C 104 and < 102, set the LH pilot seat (15MP) and the RH pilot seat (10MP) to the mid position, using the LH pilot seat height control pushbutton (3MG1) and the RH pilot seat height control pushbutton (3MG2). (5) For A/C ≥ 102, except 104, set the LH pilot seat (L2MG) and the RH pilot seat (R2MG) to the mid position, using the LH pilot seat height adjustment switch (L3MG) and the RH pilot seat height adjustment switch (R3MG). (6) Perform an operational test of the pilot seats (Refer to TASK 25-11-01-900-801 , paragraph "Operational test".) (7) Set the pilot seat /copilot seats in the full rear position. (8) Pull up the handle and push the pilot seat / copilot seats forward. Make sure that the two locking pins (7-fig. 1) lock the seats in all longitudinal positions when you release the handle. (9) Release the handle and make sure that the two locking pins (7-fig. 1) lock the seats in the full forward position. (10) Pull up the handle and push the pilot seat / copilot seats fully rearwards. (11) Release the handle and make sure that the two locking pins (7-fig. 1) lock the seats in the full rear position. (12) Identify Service Bulletin number on the labels, bond the labels to the pilot and copilot seats near the seat identification label and protect with overlay. E. RECORDING Record compliance with this Service Bulletin in the appropriate aircraft documents. Fill out the card located at the end of the Service Bulletin and mail or fax it to Dassault Aviation or Dassault Falcon Jet, or fill out the electronic Service Bulletin reply form located in the Service Bulletin" page on the Falcon portal. FALCON 2000 F2000-401 July 13, 2012 F2000-25-30 Revision 1 Page 4 / 6 DASSAULT AVIATION Proprietary Data ### Page 7 3. MATERIAL INFORMATION A. MODIFICATION KIT Kit P/N SBF900EX0446AR1 NEW P/N QTY KEY WORD FIG / ITEM F0442581 including: 2 Kit. Each kit contains: - 147100-19 2 - Spring Refer to (8-fig. 1) - G0725X12S250 2 - Pin Refer to (1-fig. 1) - 00-6414 1 - Label - Not referenced 1 - Overlay B. LOCAL PROCUREMENT As indicated in Consumable Products Manual (CPM): • cleaner FALCON 2000 F2000-401 July 13, 2012 F2000-25-30 Revision 1 Page 5 / 6 DASSAULT AVIATION Proprietary Data ### Page 8 (OCR) DASSAULT SERVICE BULLETIN AVIATION FALCON 2000 F2000-401 VIEW AS PER G Figure 1: LOCATION OF COMPONENTS July 13, 2012 F2000-25-30 END OF DOCUMENT Revision 1 Page 6 / 6 ### Page 9 (OCR) NO POSTAGE NECESSARY FROM IF MAILED IN THE UNITED STATES ZIP CODE BUSINESS REPLY MAIL FIRST CLASS MAIL PERMIT NO. 3306 HACKENSACK, NJ 07602 POSTAGE WILL BE PAID BY ADDRESSEE: DASSAULT FALCON JET CORP. PO BOX 1946 SO HACKENSACK NJ 07606-9946 ATTENTION: FIELD SERVICE DEPARTMENT DASSAULT AVIATION 78, Quai Marcel Dassault Cedex 300 92552 SAINT-CLOUD Cedex FRANCE A l'attention de DSC ### Page 10 SERVICE BULLETINS COMPLIANCE FALCON 2000 A/C S/N DASSAULT AVIATION Number ATA Number F2000 401 F2000 25 30 Coding: C complete compliance T partial compliance Performed by: Remarks: Revision 1 Date: Signature: SERVICE BULLETINS COMPLIANCE Would you be kind enough to inform us that this Service Bulletin is complied with: - For "Western Hemisphere", mail upper card (No postage necessary if mailed in the U.S.A.) or fax to Dassault Falcon Jet: 1-201-541-4700. - For "Other Continents", mail card herebelow or fax to Dassault Aviation: 33 (0)1.47.11.65.21. On the occasion, if other Service Bulletins have been simultaneously complied with could you complete the blank spaces provided for this purpose. APPLICATION DE BULLETINS DE SERVICE Lorsque vous aurez applique ce Bulletin de Service sur votre avion, veuillez avoir l'amabilite de nous en informer: - Utiliser la carte reponse superieure pour continent americain (Dispensee de timbrage pour postage depuis les U.S.A.) ou le fax pour Dassault Falcon Jet : 1-201-541-4700. - Ou la carte reponse inferieure pour autres continents ou le fax pour Dassault Aviation : 33 (0)1.47.11.65.21. Eventuellement, si d'autres Bulletins de Service ont ete appliques simultanement, vous pouvez les mentionner dans les cases vierges prevues a cet effet. APPLICATION DES BULLETINS DE SERVICE SERVICE BULLETINS COMPLIANCE FALCON 2000 A/C S/N DASSAULT AVIATION Number Numero DASSAULT AVIATION ATA Number Numero ATA F2000 401 F2000 25 30 Coding: C complete complianceapplication totale T partial complianceapplication partielle Performed by: Fait par: Remarks: Revision 1 Date: Signature: Remarques: Revision 1 --- OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain, except the copies of manufacturers’ service documents, which belong to their rights holders.