# Grob Service Bulletin 1121-144: No revision named

- Rights: © Grob. Filed by the FAA in regulations.gov docket FAA-2014-0848; AD 2014-26-04 incorporates this document by reference. Not covered by OpenAirDocs’ CC0 dedication.
- Document: [Grob Service Bulletin 1121-144](https://openairdocs.org/service-documents/grob/sb-1121-144.md)
- Title as filed: MSB1121-144
- Pages: 4
- PDF: https://openairdocs.org/files/sha256/b4/f7/b4f76f52e763b4f741d641b89afaaed171421a21a80bc124d9add840818dcc01
- Page: https://openairdocs.org/service-documents/grob/sb-1121-144/file/b4f76f52e763

## Text

This text is OCR from a scan. OCR can misread letters and numbers. Each page's text from the PDF; open the PDF at a page with #page=N.

### Page 1 (OCR)

MSB1121-144
Page 1 of 4  I GROB
14 July 2014  AIRCRAFT
Replaces Issue:
SERVICE BULLETIN NO. MSB1121-144
I. TECHNICAL DETAILS
1.1  Category:
Mandatory
Note:  GROB issues Service Bulletins of category Mandatory (MSBs), if the information or
instructions have a safety intent either related to design or conformity and to
publish revisions of manuals (AFM, AMM, IPC). However, according to Article 20
(1) of Regulation (EC) No. 216/2008, only EASA may issue mandatory information,
in the form of an Airworthiness Directive (AD), in order to react to a given safety
problem. Service Bulletins classified Mandatory issued by GROB's design
organisation do not have a legally mandatory character equivalent to an AD,
cannot have enforcement implications and, therefore, serve as information or
instruction by GROB only. This also applies to cases where a Service Bulletin is
published in anticipation of an AD.
Note:  This service bulletin is issued in anticipation of an AD. Issue of an AD will not
necessarily lead to revision of this service bulletin.
1.2  Airplanes affected:
G 120A  all S/N
G 120A-I  all S/N
1.3  Time of Compliance:
Part A: Before next IFR or VFR Night flight, or within next 50FH, whichever comes first.
1.4  Subject:
ATA-Code:  80-00 Starting
Inspection of starter solenoid
1.5  Reason:
Grob received a report about a total loss of electrical power in IMC on a G 115E aircraft. Root
cause was found to be a defect starter solenoid. The starter solenoid had an internal defect
causing a short circuit. The defect cannot be detected by visual inspection. The installation is
similar to the installation on G120 aircraft.
This Service Bulletin is intended to prevent an unsafe condition. The configuration of the aircraft
is not affected by this Service Bulletin.
1.6  Concurrent documents:
Corresponding AMM
1.7  Approval Note:
The technical content of this document is approved under the authority of EASA Design
Organization Approval No. EASA.21J.030.
1121-144 MSB, Inspection of starter solenoid  G 120A, A-I
Grob Aircraft AG, Lettenbachstrasse 9, D-86874 Tussenhausen-Mattsies

### Page 2 (OCR)

MSB1121-144
Page 2 of 4  I GROB
14 July 2014
Replaces Issue:  AIRCRAFT
1.8  Accomplishment/ Instructions
Part A One-time Inspection
Disconnect the aircraft battery, refer to AMM Chapter 24-31.
Remove the Engine Cowlings, refer to AMM Chapter 71-10.
Visually inspect the starter. Make sure that the power connection bolts have the same
length, refer to Figure 1 for defective item and Figure 2 for correct installation.
Figure 1: Incorrect connection bolts  Figure 2: Correct installation
1.8.4 Release the two bolts on the starter solenoid. Carefully pull the solenoid away from the
starter housing until the dead stop. Make sure that the solenoid plunger is still attached,
refer to Figure 3. Attach the solenoid to the starter with the two bolts.
Figure 3: Starter solenoid at dead stop
1.8.5 If the starter is OK, do step 1.8.7.
1.8.6 If the starter is not OK or in case of doubt, replace the Starter.
1121-144 MSB, Inspection of starter solenoid  G 120A, A-I
Grob Aircraft AG, Lettenbachstrasse 9, D-86874 Tussenhausen-Mattsies

### Page 3 (OCR)

MSB1121-144
Page 3 of 4  I GROB
14 July 2014  AIRCRAFT
Replaces Issue:
1.8.7 Install the Engine Cowlings, refer to AMM Chapter 71-10.
1.8.8  Connect the aircraft battery, refer to AMM Chapter 24-31.
1.8.9 Release aircraft into service according to national requirements.
Part B
Reserved for the terminating action
1.9  Repetitive Actions
none
II. PLANNING INFORMATION
Material and Availability
EZ  Special Tools
₺°Z
V/N
9°Z
1121-144 MSB, Inspection of starter solenoid  G 120A, A-I
Grob Aircraft AG, Lettenbachstrasse 9, D-86874 Tussenhausen-Mattsies

### Page 4 (OCR)

MSB1121-144
Page 4 of 4  I GROB
14 July 2014  AIRCRAFT
Replaces Issue:
III. REMARKS
The instructions in paragraph 1.8 have to be accomplished and certified in the logbook by
authorized staff:
- in EASA countries according to Article 5 VO EG 2042/03 (VO EG 1056/2008) Appendix III -
Part 66
- in non-EASA countries according to national regulations with respect to maintenance.
If you have sold your aircraft in the meantime, we kindly ask you to forward this information to
the new owner and to provide us with the name and address of the new owner as well as with
the respective serial number.
For questions and assistance please contact:
Product Support,
phone:  +49 8268 998105
fax:  +49 8268 998200
e-mail:  productsupport@grob-aircraft.com
1121-144 MSB, Inspection of starter solenoid  G 120A, A-I
Grob Aircraft AG, Lettenbachstrasse 9, D-86874 Tussenhausen-Mattsies

---
OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain, except the copies of manufacturers’ service documents, which belong to their rights holders.
