# AgustaWestland Alert Bollettino Tecnico 412-134: No revision named

- Rights: © Leonardo S.p.A. Filed by the FAA in regulations.gov docket FAA-2014-0035; AD 2014-02-06 incorporates this document by reference. Not covered by OpenAirDocs’ CC0 dedication.
- Document: [AgustaWestland Alert Bollettino Tecnico 412-134](https://openairdocs.org/service-documents/leonardo/sb-412-134.md)
- Title as filed: U.S. DOT/FAA - Agusta 412-134
- Pages: 9
- PDF: https://openairdocs.org/files/sha256/3c/e5/3ce549c6c57718931567bf2d1696a525777fcc4f2b5fd53388eca1fc045e073f
- Page: https://openairdocs.org/service-documents/leonardo/sb-412-134/file/3ce549c6c577

## Text

Each page's text from the PDF; open the PDF at a page with #page=N.

### Page 1

Page 1 of 7 
 
 
BOLLETTINO TECNICO 
The technical content of this document is approved 
under the authority of DOA nr. EASA.21J.005. 
N°         412-134 
DATE        July 15, 2013    
 
REV. 
Compliance with 
this bulletin is: 
 
 
 
 
SUBJECT: SWASHPLATE OUTER RING ASSEMBLY P/ N 412 -010-407-105, 
REMOVAL FROM SERVICE. 
 
REASON:  Remove from service the subject swashplate outer ring assembly. 
 
HELICOPTERS AFFECTED: 
COMPLIANCE: 
Within the next 5 flight hours after the issue  of t his Bollettino  and subsequently every 25 
flight hours until removal from service, which as to be done within 300 flight hours after the 
issue of this Bollettino or not later than April 15, 2014 whichever comes first. 
The swashplate outer ring s assembly P/N 412-010-407-105 must not be used after April 15, 
2014; the swashplate outer ring assembly P/N 412 -010-407-117 must to be installed in lieu of 
swashplate outer ring assembly P/N 412-010-407-105. 
 
DESCRIPTION: 
AgustaWestland has received two reports of crac king in the swashplate outer ring assemblies 
P/N 412 -010-407-105. The investigations have identified  in both case a fatigue failure, 
therefore t his Bollettino mandates the removal from service of all swashplate outer ring 
assembly P/N 412-010-407-105. 
AgustaWestland S.p.A
Via Giovanni Agusta, 520
21017 Cascina Costa di Samarate (VA) Italy
Tel.: +39 0331 229111 - Fax: +39 0331 229605/222595
MANDATORY
An appropriate entry should be made in the aircraft log book upon accomplishment.
If ownership of aircraft has changed, please, forward to new owner.
ALERT
ALERT

### Page 2

B.T. 412-134 
Page 2 of 7 
 
MANPOWER REQUIRED:  
Approximately 26 man-hours are required to complete this Bollettino. 
 
WARRANTY: 
Owners / Operators of AgustaWestland AB412 who comply with the instructions of this 
Bollettino will be eligible to receive a pro-rated credit for the replacement swashplate outer 
ring assembly P/N 412-010-407-117, and cap P/N 540-011-434-111 outlined under the 
requirement material section of this Bollettino, together with the labor cost to cover the 
replacement on bench and on the aircraft. 
To receive this credit: 
 Purchase the required 412-010-407-117 outer ring assembly and cap 540-011-434-111 
from a AgustaWestland supply source. 
 Comply with the instructions contained in this Bollettino no later than the applicable hours 
in the “compliance section” of this Bollettino, or before April 15, 2014. 
 Labor cost provided for a replacement an on bench assembly will be $400.00 USD and 
$800.00 USD for an on aircraft assembly. 
 Submit an WMM to the AgustaWestland Warranty Department for the replacement parts 
and the appropriate labor cost. 
 
MATERIAL REQUIRED:    
The following material is required for the accomplishment of this Bollettino. 
P/N DENOMINATION Q.TY 
412-010-407-117 Outer ring assembly 1 
412-010-404-101  Shim 1 
204-011-429-1 Seal 2 
540-011-434-111 Cap assembly 1 
140-007-21S18C6 Washer 14 
MS21042L5 Nut 16

### Page 3

B.T. 412-134 
Page 3 of 7 
MS21250-05022 
or 
NAS625-22 
Bolt 14 
AN960-516 
or 
NAS1149F0563P 
Washer 16 
  
SPECIAL TOOLS:  N.A. 
 
WEIGHT AND BALANCE CHANGE:  N.A. 
 
REFERENCES:  
AB412-IPC  Illustrated Parts Catalogue 
BHT-412-CR&O  Component Repair and Overhaul Manual 
AB412-MM  Maintenance Manual 
 
PUBBLICATIONS AFFECTED:  
AB412-MPM Maintenance Planning Manual  Chapter 4 
AB412-IPC Illustrated Parts Catalogue 
 
ACCOMPLISHMENT INSTRUCTIONS: 
1. Prepare helicopter for safe ground maintenance. Disconnect battery and all the electric power 
source and/or the external power supply. 
2. Remove forward pylon f airing assembly in accordance with AB412 -MM, and clean 
swashplate outer ring with clean cloth damp in denatured alcohol or equivalent. 
3. Using a 5X magnifying glass and a bright light visually inspect the swashplate outer ring P/N 
412-010-407-105 for cracks (Refer to Figure 1 and Figure 2 for typical crack found during 
inspection). 
4. If the inspection does not reveal cracks, re-install forward pylon firing assemb ly previously 
removed and return the helicopter to flight configuration . Make an entry in helicopter 
applicable documentations indicating compliance of the inspection with this Bollettino.  
5. If the inspection reveal cracks , remove and replace the swashplate  outer ring assembly P/N 
412-010-407-105 with P/N 412-010-407-117 in accordance with the following instructions:  
5.1. Remove swashplate and support assembly in accordance with AB412-MM Chapter 62- 31-

### Page 4

B.T. 412-134 
Page 4 of 7 
02 step 2. 
5.2 Disassembly swashplate and support assy for enter to outer ring in accordance with BHT-
412-CR&O Chapter 62-00-00 paragraph 62-30. Scrap outer ring P/N 412-010-407-105, 
shim P/N 540-011-436-3, seals P/N 204-011-429-1 and cap assy P/N 540-011-434-1. 
5.3   Install seals P/N 204-011-429-1 in new outer ring P/N 412-010-407-117 and cap P/N 540-
011-434-111 (lip pointing downward) in accordance with BHT-412- CR&O paragraph 62-
36 step 2. 
5.4    Reassemble swashplate and support assy in accordance with BHT-412-CR&O  Chapter 62-
00-00 paragraph 62-36 using new shim P/N 412-010-404-101 an hardware listed in Figure 
3. Remark with P/N 412-010-402-111 the swashplate and support assy. 
5.5   Re-install the swashplate and support assembly in accordance with AB412-MM Chapter 62-
31-02 step 3. 
6. After re-assembly and installation of all components, the main rotor assembly shall be 
tracked and balanced in accordance with AB412-MM Maintenance Manual.  
7. Upon completion, make an entry in helicopter applicable documentations indicating 
compliance with this Bollettino.

### Page 5

B.T. 412-134 
Page 5 of 7 
 
 
 
 
 
 
 
 
 
 
Figure 1 
 
 
 
 
 
Swashplate outer ring,  
area to be inspected all around

### Page 6

B.T. 412-134 
Page 6 of 7 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Figure 2 
 
 
Crack on swashplate outer 
ring P/N 412-010-407-105

### Page 7

B.T. 412-134 
Page 7 of 7 
 
 
Figure 3 
DENOMINATION PRE B.T.  POST B.T.  
 Ref. P/N Ref. P/N 
Outer Ring Assy 1 412-010-407-105 1A 412-010-407-117 
Shim 2 540-011-436-3 2A 412-010-404-101 
Seal 3 204-011-429-1 3 204-011-429-1 
Cap Assy 4 540-011-434-1 4A 540-011-434-111 
Washer 5 140-007-21S18C6 5A 140-007-21S18C6 
Nut 6 MS21042L5 6A MS21042L5 
 
Bolt 
 
7 
MS21250-05022 
or 
NAS625-22 
 
 
 
 
7A 
MS21250-05022 
or 
NAS625-22 
 
 
 
 
Washer 
 
8 
AN960-516 
or 
NAS1149F0563P 
 
 
 
 
8A 
AN960-516 
or 
NAS1149F0563P

### Page 8

(No text on this page.)

### Page 9

Note: 
Remarks: 
Informazioni: 
Information: 
 
Al fine di gestire le varianti alla configurazione base, in relazione all’emissione de l Bollettino Tecnico, preghiamo di voler compilare il presen-
te modulo in tutte le sue parti e spedirlo all’indirizzo sopra indicato. Si ringrazia per la gentile collaborazione data.  
We request your cooperation in filling this form,  in order to  keep out statistical data relevant to aircraft configuration up- to-date. The form should be filled in all 
its parts and sent to the above address. We thank you beforehand for the information given.  
MODULO APPLICAZIONE BOLLETTINO TECNICO 
TECHNICAL BULLETIN COMPLIANCE FORM 
Data: 
Date: 
Numero: 
Number: 
Revisione: 
Revision: 
Prego spedire a questo indirizzo: 
Please send to the following address: 
 
AGUSTAWESTLAND  S.p.A. 
CUSTOMER SUPPORT & SERVICES - ITALY
PRODUCT SUPPORT ENGINEERING DPT.
Via del Gregge, 100 
21015 Lonate Pozzolo (VA) - ITALY 
Tel.: +39 0331 664905 
Fax: +39 0331 664684
Telefono: 
Telephone: 
Fax: 
Data Applicazione B.T.: 
B.T. Compliance Date: 
Denominazione Cliente ed Indirizzo: 
Customer Name and Address: 
Modello Elicottero 
Helicopter Model S/N Matricola Tail Number Ore Totali Total Hours Ore D.U.R. T.S.O.

---
OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain, except the copies of manufacturers’ service documents, which belong to their rights holders.
