# AgustaWestland Bollettino Tecnico 412-139: No revision named

- Rights: © Leonardo S.p.A. Filed by the FAA in regulations.gov docket FAA-2015-1936; AD 2015-11-07 incorporates this document by reference. Not covered by OpenAirDocs’ CC0 dedication.
- Document: [AgustaWestland Bollettino Tecnico 412-139](https://openairdocs.org/service-documents/leonardo/sb-412-139.md)
- Title as filed: Agusta BT No 412-139
- Pages: 5
- PDF: https://openairdocs.org/files/sha256/99/67/9967ceadefa47e5357bb4a9ef86c231edd04415609ed45dd5abc9ecded1a2927
- Page: https://openairdocs.org/service-documents/leonardo/sb-412-139/file/9967ceadefa4

## Text

Each page's text from the PDF; open the PDF at a page with #page=N.

### Page 1

Page 1 of 4 
BOLLETTINO TECNICO 
The technical content of this document is approved 
under the authority of DOA nr. EASA.21J.005. 
N°     412-139  
DATE     February 19, 2014
REV.
Compliance with 
this bulletin is: 
SUBJECT: INSPECTION OF THE FLANGED ADAPTER P/N 412-040-622-101 AND 
P/N 412-040-623-101 INSTALLED ON TAIL ROTOR DRIVE SHAFTS. 
REASON:   Provide the necessary instructions to inspect the above mentioned flanged adapter s 
installed on tail rotor drive shafts. 
HELICOPTERS AFFECTED: 
Agusta AB412 helicopters S/N 25801 through 25900 and AB412EP helicopters S/N 25901 
and subs.  
COMPLIANCE: 
Within and not later than 5  flight hours after the issue of this Bollettino, and subsequently 
every 100 flight hours. 
DESCRIPTION: 
AgustaWestland has recently received a report of a crack on a flanged adapter P/N 412-040 -
622-101 installed on the tail rotor drive shaft of an AB412EP helicopter.  
The investigation to determine the root causes of the crack on the flanged adapter is in 
progress, then the requirements of this Bollettino could be updated according to the 
investigation results. 
This Bollettino is issued in order to prescribe an inspection of the adapter-flanged P/N 412-
040-622-101 and P/N 412-040-623-101 for presence of cracks. 
AgustaWestland S.p.A
Via Giovanni Agusta, 520
21017 Cascina Costa di Samarate (VA) Italy
T el.: +39 0331 229111 - Fax: +39 0331 229605/222595
MANDATORY
An appropriate entry should be made in the aircraft log book upon accomplishment.
If ownership of aircraft has changed, please, forward to new owner.
ALERT
ALERT

### Page 2

B.T. 412-139 
Page 2 of 4 
MANPOWER REQUIRED: 
Approximately 3 man-hours are required to complete this Bollettino. 
WARRANTY:   N.A.  
MATERIAL REQUIRED:   N.A. 
SPECIAL TOOLS:  N.A. 
WEIGHT AND BALANCE CHANGE:  N.A. 
REFERENCES: 
AB412-IPC Illustrated Parts Catalogue 
AB412EP-IPC Illustrated Parts Catalogue 
AB412-MM Maintenance Manual 
PUBBLICATIONS AFFECTED: 
AB 412-MPM Maintenance Planning Manual 
ACCOMPLISHMENT INSTRUCTIONS: 
1. Prepare the helicopter for safe ground maintenance. Disconnect battery and all the electric
power source and/or the external power supply.
2. In accordance with AB412- MM Chapter 65 gain access to the tail rotor drive shaft.
3. Using a 5X magnifying glass and a source light visually inspect the adapter-flanged P/N 412-
040-622-101 and P/N 412-040 -623-101 for presence of cracks in proximity of the fixing
bolts (Refer to Figures 1 and 2).
4. If cracks are found, before the next flight remove from the helicopter the affected drive shaft
assy in accordance with AB412-MM Chapter 65 and replace it with a serviceable drive shaft
assy.
5. Report to AgustaWestland Product Support Engineering at the following e-mail address:
absereng@agustawestland.com any case of cracked adapter-flanged and send the affected
parts for investigation. 
6. If no cracks are found in accordance with AB412-MM Chapter 65 install the access panel and
close the access doors removed/opened during step 2.
7. Return the helicopter to flight configuration and make an entry in helicopter applicable
documentations to indicate accomplishment of this Bollettino.

### Page 3

B.T. 412-139 
Page 3 of 4 
 
 
 
 
Figure 1 - Crack found during inspection 
 
 
 
 
 
 
FLANGED ADAPTER 
EXAMPLE OF CRACK 
FOUND DURING 
INSPECTION 
AREA TO BE INSPECTED  
ON FLANGED ADAPTER 
TYP. 3 PLACES

### Page 4

B.T. 412-139 
Page 4 of 4 
 
 
Figure 2 – Detail of flanged adapter (on both sides of driveshaft) 
 
 
FLANGED ADAPTER

### Page 5

Note: 
Remarks:
Informazioni: 
Information: 
Al f
ine di gestire le varianti alla configurazione base, in relazione all’emissione de l Bollettino Tecnico, preghiamo di voler compilare il presen-
te modulo in tutte le sue parti e spedirlo all’indirizzo sopra indicato. Si ringrazia per la gentile collaborazione data. 
We request your cooperation in filling this form,  in order to keep out statistical data relevant to aircraft configuration up- to-date. The form should be filled in all 
its parts and sent to the above address. We thank you beforehand for the information given.
MODULO APPLICAZIONE BOLLETTINO TECNICO 
TECHNICAL BULLETIN COMPLIANCE FORM
Data: 
Date:
Numero: 
Number:
Revisione: 
Revision:
Prego spedire a questo indirizzo: 
Please send to the following address: 
AGUSTAWESTLAND  S.p.A.
CUSTOMER SUPPORT & SERVICES - ITALY
PRODUCT SUPPORT ENGINEERING DPT.
Via del Gregge, 100 
21015 Lonate Pozzolo (VA) - ITALY 
Tel.: +39 0331 664905 
Fax: +39 0331 664684
Telefono: 
Telephone:
Fax:
Data Applicazione B.T.: 
B.T. Compliance Date:
Denominazione Cliente ed Indirizzo: 
Customer Name and Address:
Modello Elicottero 
Helicopter Model S/N Matricola Tail Number Ore Totali Total Hours Ore D.U.R. T.S.O.

---
OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain, except the copies of manufacturers’ service documents, which belong to their rights holders.
