# Lycoming Service Instruction 1320: No revision named

- Rights: © Avco Corporation. Filed by the FAA in regulations.gov docket FAA-2012-0983; AD 2013-10-04 incorporates this document by reference. Not covered by OpenAirDocs’ CC0 dedication.
- Document: [Lycoming Service Instruction 1320](https://openairdocs.org/service-documents/lycoming/si-1320.md)
- Title as filed: U.S. DOT/FAA - Lycoming SI 1320
- Pages: 1
- PDF: https://openairdocs.org/files/sha256/a6/c0/a6c027d2d5126c34939c9ba27625d8d9365c714fbc7c07a86d6e87bbeb7506d5
- Page: https://openairdocs.org/service-documents/lycoming/si-1320/file/a6c027d2d512

## Text

This text is OCR from a scan. OCR can misread letters and numbers. Each page's text from the PDF; open the PDF at a page with #page=N.

### Page 1 (OCR)

TEXTRON Lycoming  SERVICE
652 Oliver Street  Williamsport, PA 17701 U.S.A  INSTRUCTION
717/323-6181
DATE:  March 7, 1975  Service Instruction No. 1320
Engineering Aspects are
FAA (DEER) Approved
SUBJECT:  Tightening Procedure for Exhaust Manifold Components
MODELS AFFECTED:  All Avco Lycoming turbocharged aircraft engines.
TIME OF COMPLIANCE: At anytime exhaust manifold system components are
removed or replaced.
When it is necessary to remove or replace any part of the exhaust manifold sys-
tem on Avco Lycoming turbocharged engines precautions must be taken when re-
assembling parts to the engine; uneven tightening may cause damage resulting in
probable loss of exhaust gas pressure.
Exhaust manifolding for Avco Lycoming turbocharged engines, covers both right
and left half of the engine beginning at no. 1 and no. 2 cylinders at the front of the
engine and continues to the transition assembly at the rear of the engine. If any
component of this system is removed or replaced, for any reason, loosen all attach-
ments on that side before installing the new or removed component. Then, during
assembly tighten each attaching part equally and uniformly; that is, partially tighten
all of the fastenings before securely tightening any one of them. Never fully tighten
any part of the exhaust system fully before proceeding to another part on the same
side of the engine. Tighten each part on each side of the engine equally.
It the replacement or removal of any exhaust manifold component requires the
removal of a crush-proof gasket, a new gasket should be reassembled to the engine.
Do not reuse a crush-proof gasket. These gaskets are usually found at cylinder ex-
haust ports and at v-band clamp locations.
CAUTION
Anytime a clamp is assembledover an exhaust system
component be very careful not to spread or force the
clamp beyond its normal open position. To do so will
either distort its shape and cause an ineffective seal
or it will rupture the metal and result in eventual
failure of the clamp.

---
OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain, except the copies of manufacturers’ service documents, which belong to their rights holders.
