# Mooney Service Bulletin M20-313A: No revision named

- Rights: © Mooney. Filed by the FAA in regulations.gov docket FAA-2012-0275; AD 2012-05-09 incorporates this document by reference. Not covered by OpenAirDocs’ CC0 dedication.
- Document: [Mooney Service Bulletin M20-313A](https://openairdocs.org/service-documents/mooney/m20-313a.md)
- Title as filed: U.S. DOT/FAA - Service Information
- Pages: 4
- PDF: https://openairdocs.org/files/sha256/74/4a/744aaf200716af0b5ba3eb059f5193edd9c415d72a25b3367d02f8634c9e1473
- Page: https://openairdocs.org/service-documents/mooney/m20-313a/file/744aaf200716

## Text

Each page's text from the PDF; open the PDF at a page with #page=N.

### Page 1

MOONEY AVIATION COMPANY iNC. SERVICE BULLETIN
165 Al Mooney Road North
Kerrville, Texas 78028
SERVICE BULLETIN M20-313A
Date: February 29, 2012
THIS BULLETIN IS FAA APPROVED FOR ENGINEERING DESIGN
MOONEY AVIATION COMPANY, INC. 165 Al Mooney Road North, Kerrville, Texas 78028 tel: 830-896-6000 www.mooney.com
P a g e1o f4
SUBJECT: Empennage Trim Fitting And Mounting Hardware Inspection
MODELS/ SN ALL Mooney M20B - M20C - M20D , M20E - M20F - M20G - M20J - M20K
AFFECTED: M20L, M20M, M20R, M20S, M20TN
TIME OF WITHIN NEXT 10 FLIGHT HOURS - UNLESS ALREADY ACCOMPLISHED
This is a one time inspection
COMPLIANCE:
INTRODUCTION: There have been reports in the field of the trim filler plate mounting (stacked with the trim fitting
and trim hinge) positioned incorrectly on the M20J, M20R and M20TN Mooney Airplanes. We
are issuing this Service Bulletin because we evaluated all the relevant information and de-
termined the unsafe condition described in SB M20-313 (initial release) is likely to exist in oth-
er products of the same type design. This will require an inspection and corrective action
taken. The attached compliance card needs to be filled out and returned to Mooney
Aviation Company upon completion of this Service Bulletin M20- - 313A.
INSTRUCTIONS: Read entire procedures before beginning work.
1.1. Turn master switch - OFF.
1.2. Remove LH and RH empennage fairing refer to Figure M20-313-1.
1.3. Visually inspect the position of the filler plate as shown in Figure M20-313-1.
1.4. If the trim fitting, hinge and filler plate are found to be in the “Correct” position as shown
in Figure M20-313-1, continue to steps 1.6 of this bulletin.
1.5. If the trim fitting, hinge and filler plate are found to be in the “Incorrect” position as
shown in Figure M20-313-1, DO NOT FLY - Please contact Mooney Technical Support
at 830-896-6000 or email technicalsupport@mooney.com for further instructions.
1.6. Remove LH inspection panel on empennage assembly, refer to Figure M20-313-1.
1.7. Visually inspect all 10 huckbolts to insure no signs of movement, retaining collar properly
swedged and visually verify pin protrusion (use inspection mirror for lower bolts). Make
sure all hardware is secure, bolts and collars should not rotate with finger pressure, hinge
assembly should not move on bulkhead - refer to Figure M20-313-1.
1.8. If the hardware is found to be “secure” - continue to steps 1.10 of this bulletin.
1.9. If the hardware is found to be “insecure” - DO NOT FLY - Please contact Mooney
Technical Support at 830-896-6000 or email technicalsupport@mooney.com for further
instructions.
1.10. Reinstall LH inspection panel on empennage assembly.
1.11. Reinstall LH and RH empennage fairing.
1.12. Complete log book entry.

### Page 2

MOONEY AVIATION COMPANY iNC. SERVICE BULLETIN
165 Al Mooney Road North
Kerrville, Texas 78028
SERVICE BULLETIN M20-313A
Date: February 29, 2012
THIS BULLETIN IS FAA APPROVED FOR ENGINEERING DESIGN
MOONEY AVIATION COMPANY, INC. 165 Al Mooney Road North, Kerrville, Texas 78028 tel: 830-896-6000 www.mooney.com
P a g e2o f4
NOTE:
Fill out compliance card and send by MAIL or FAX to Mooney Aviation Company as indicated on
the attached Compliance Card (see to Figure M20-313-2)
1.13. Return aircraft to service.
1.14. Procedure complete.
WARRANTY: Mooney Aviation Company, Inc. will warrant labor 1 hour when corrective action is done in
accordance with procedures of this Service Bulletin for aircraft currently covered under the
Mooney Aviation Company, Inc. factory warranty program.
REFERENCE 1. MAC Maintenance Manual (applicable A/C)
DATA:
PARTS LIST: Not applicable for this inspection

### Page 3

MOONEY AVIATION COMPANY iNC. SERVICE BULLETIN
165 Al Mooney Road North
Kerrville, Texas 78028
SERVICE BULLETIN M20-313A
Date: February 29, 2012
THIS BULLETIN IS FAA APPROVED FOR ENGINEERING DESIGN
MOONEY AVIATION COMPANY, INC. 165 Al Mooney Road North, Kerrville, Texas 78028 tel: 830-896-6000 www.mooney.com
P a g e3o f4
FILLER
HINGE
TRIM FITTING
PLATE
COLLAR
EMPENNAGE
ASSEMBLY
FILLER
PLATE
HINGE
TRIM
FITTING
INSPECTION
PANEL
HUCKBOLT
(10 PLACES)
(10 PLACES)
HUCK
VIEW SHOWING THE
CORRECT "STACK" POSITION
OF MOUNTING COMPONENTS
INCORRECT "STACK" POSITION
OF MOUNTING COMPONENTS
EMPENNAGE
FAIRING
Figure SB M20-313-1 - EMPENNAGE TRIM FITTING AND MOUNTING HARDWARE

### Page 4

MOONEY AVIATION COMPANY iNC. SERVICE BULLETIN
165 Al Mooney Road North
Kerrville, Texas 78028
SERVICE BULLETIN M20-313A
Date: February 29, 2012
THIS BULLETIN IS FAA APPROVED FOR ENGINEERING DESIGN
MOONEY AVIATION COMPANY, INC. 165 Al Mooney Road North, Kerrville, Texas 78028 tel: 830-896-6000 www.mooney.com
P a g e4o f4
MOONEY AVIATION COMPANY
KERRVILLE, TEXAS 78028 - - FAX to 830- -257- -4635
SERVICE (BULLETIN) (INSTRUCT ION) NO.________________HAS BEEN COMPLIED
WITH ON AIRCRAFT MODEL _______________ SERIAL NUMBER ________________
Tach. Time:
Owner:
N-Number (Reg. No.)
Date of
Compliance:
Complied
By:
Form 07-0001
Inspection Report:
MOONEY AVIATION COMPANY
ATT’N: TECHNICAL SUPPORT
165 Al Mooney Road, North
Kerrville, Texas 78028
PLACE
STAMP
HERE
SEND TO:
Mooney Aviation Company
165 Al Mooney Road North
Kerrville, TX 78028
Figure SB M20-313-2 - - Compliance Card

---
OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain, except the copies of manufacturers’ service documents, which belong to their rights holders.
