# Tecnam Service Bulletin 102-CS-Rev2: No revision named

- Rights: © Tecnam. Filed by the FAA in regulations.gov docket FAA-2012-1173; AD 2013-04-09 incorporates this document by reference. Not covered by OpenAirDocs’ CC0 dedication.
- Document: [Tecnam Service Bulletin 102-CS-Rev2](https://openairdocs.org/service-documents/tecnam/102-cs-rev2.md)
- Title as filed: U.S. DOT/FAA - Service Bulletin No. 102 - CS - Rev 2
- Pages: 4
- PDF: https://openairdocs.org/files/sha256/15/10/1510d8f600a4e7132f647e5803124b97ebae185176c13927f1fda6ab2bd8b89d
- Page: https://openairdocs.org/service-documents/tecnam/102-cs-rev2/file/1510d8f600a4

## Text

This text is OCR from a scan. OCR can misread letters and numbers. Each page's text from the PDF; open the PDF at a page with #page=N.

### Page 1 (OCR)

COSTRUZIONI AERONAUTICHE
TECNAM  SERVICE BULLETIN
N° SB 102 - CS - Rev2
Approved by TECNAM-under DOA certificate EASA.21J.335 N° DO-102-120626 26h June 2012
Rev1. 29th June 2012
Rev2. 03" July 2012
Page 1 / 3
INFORMATION  RECOMMENDED  MANDATORY
SUBJECT:  P2006T Aileron hinge supports inspection
SCOPE:  During an inspection of a P2006T, on the LH aileron hinge sup-
port outboard side (P/N 26-1-1082-1/3) were found multiple
cracks.
Tecnam prescribes to perform a dedicated inspection on all Ai-
leron hinge supports (P/N 26-1-1082-1/3, P/N 26-1-1081-1/3,
P/N 26-1-1081-2/4, P/N 26-1-1082-2/4) within the terms herein
reported.
MODELS AFFECTED:  P2006T airplanes, all S/N
TIME OF COMPLIANCE:  Within the next 25 hours or 30 days (whichever occurs first) af-
ter the issue date of this SB for airplanes with more than 600
flight hours.
Repeat the inspection during each the scheduled 100 flight
hours/yearly inspection.
MANPOWER:  0.2 man-hours.
REQUIRED MATERIAL: Nil
TOOLING:  Nil
WEIGHT AND BALANCE: Nil
REFERENCES:  P2006T Maintenance Manual doc. Nr 2006/45
PUB. AFFECTED:  Nil
Rev. 2, 3rd July 2012
Edition 1 Rev.2

### Page 2 (OCR)

COSTRUZIONI AERONAUTICHE  TECNAM  SERVICE BULLETIN
N° SB 102 - CS - Rev2
Approved by TECNAM-under DOA certificate EASA.21J.335 N° DO-102-120626 26th June 2012
Rev1. 29th June 2012
Rev2. 03r July 2012
Page 2 / 3
INSPECTION INSTRUCTIONS
1. Aircraft preparation
1) Park the aircraft in a closed hangar;
2) Make sure that landing gear is down and locked (Master Switch ON: LG advisory lights must be ON);
3) MASTER SWITCH: OFF;
4) STARTER RELAY BREAKER: OFF;
5) PARKING BRAKE: ON;
2. Inspect ailerons supports hinges
1) Rotate LH aileron in full up position;
2) Identify the LH aileron hinge support P/N 26-1-1082-1/3 outboard side (see following figure 1);
P/N 26-1-1082-3  P/N 26-1-1082-1
I FW
LH Aileron
hinge -
Tip side
LH Aileron
Figure 1 - Inspection items identification
3) Inspect (using a high spot light if required) the I.H aileron hinge support P/N 26-1-1082-1/3 outboard side for
absence of cracks (refer to inspection points indicated in the following figure 2).
Inspection points
Figure 2 - Inspection points
Rev. 1, 29th June 2012  Edition 1 Rev.2

### Page 3 (OCR)

COSTRUZIONI AERONAUTICHE
TECNAM  SERVICE BULLETIN
N° SB 102 - CS - Rev2
Approved by TECNAM-under DOA certificate EASA.21J.335 N° DO-102-120626 26h June 2012
Rev1. 2gth June 2012
Rev2. 03r July 2012
Page 3 / 3
4)  Operate the same inspection for the LH aileron hinge support P/N 26-1-1081-1/3 inboard side for absence of
cracks:
5)  Rotate the RH aileron in full up position;
6) Identify the RH aileron hinge support P/N 26-1-1082-2/4 outboard side;
7) Inspect (using a high spot light if required) the RH aileron hinge support P/N 26-1-1082-2/4 outboard side for
absence of cracks (refer to inspection points indicated in the following figure 2);
8) Operate the same inspection for the RH aileron hinge support P/N 26-1-1081-2/4 inboard side for absence of
cracks;
If a crack is found during inspection required by this SB, the part must be considered unserviceable and please contact
Costruzioni Acronautiche TECNAM for replacement instructions and accomplish them accordingly.
Complete the occurrence report hereby attached and send it Tecnam.
Record the application of the present Service Bulletin on the aircraft log-book.
For further information please contact TECNAM:
Tel 0039 0823 620134
Fax 0039 0823 622899
E-mail airworthiness@tecnam.com
Rev. 2, 3rd July 2012  Edition 1 Rev.2

### Page 4 (OCR)

COSTRUZIONI AERONAUTICHE  Occurrence Report Date:
• TECNAM
Aircraft Type:  Engine No.1 type:
Serial No.  " Serial No.
Registration markings:  " Time Since New:
A/C Time Since New:  " Time Since Overhaul:
" Cycles since new:  " Cycles since new
Affected Item (if applicable)  Engine No.2 type:
" ATA Chapter  " Serial No.
" Time Since New:  " Time Since New:
" Time Since Overhaul:  " Time Since Overhaul:
* Cycles since new:  " Cycles since new:
Place:
Operator's name:
* contacts:  Ph:  Fax.
* contact person:  Mobile:
Description:
List of Damaged areas:
Operator's Preliminary Investigation
No. of died persons:
No. of injured persons
Acc./s.Ine./Inc (ICAO A13)
Possible cause:
Action to be done:
Operators must fill this "Occurrence Report" as soon as possible and send preferably via e-mail to the TECNAM Office of
Airworthiness: airworthiness/@tecnam.com .
Eventually by fax: +39 081 7584528 or express courier: 1°trav. Via Giovanni Pascoli n°1 Casoria (NA) 80026 ITALY
ANY MATERIAL AVAILABLE LIKE PHOTO, VIDEO, DRAWINGS ETC. IS WELCOME.
Disclaimer: Costruzioni Aeronautiche TECNAM s.r.l. declines any responsibility for late, incomplete or not-true information
provided. Using of this form for occurrence reporting is mandatory as per Tecnam/DOA procedures.
Tecnam will adopt the date and hour of receiving of this form duly filled as a reference in later pertinent activities.
While filling this form: fields not applicable must not be left blank but marked with n.a.

---
OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain, except the copies of manufacturers’ service documents, which belong to their rights holders.
