# TCDS A11NM: West Coast Fabrications

- Type: Type certificate data sheet
- Status: Current
- Holder: West Coast Fabrications
- Revision: 1
- Revised: June 9, 1983
- Product: Aircraft, Large Airplane
- Certification basis: Part 21
- Registered aircraft: 1, by the registry models matched to it (OpenAirDocs)
- Data sheet PDF: https://openairdocs.org/files/sha256/6a/e3/6ae3c302734758800502ed2a1c3949011b6b8058f22eec88d6b3ddfa6003f190
- FAA DRS: https://drs.faa.gov/browse/excelExternalWindow/E1583BF6617258C68525672200679670.0001
- Page: https://openairdocs.org/tcds/A11NM

## Models (1)

As the data sheet lists them.

- C97G

## What the data sheet says

From the PDF's text layer, line by line; tables lose their columns. The PDF is the record.

```text
Page No. 1 2 3
Rev No. 1 1 1
Reformatted 1/94.
FEDERAL AVIATION ADMINISTRATION
A11NM
Revision 1
       Boeing
  C97G
June 9, 1983
TYPE CERTIFICATE DATA SHEET NO. A11NM
This data sheet which is a part of Type Certificate No. A11NM prescribes the conditions and limitations under which the product for
which the type certificate was issued meets the airworthiness requirements of the Federal Aviation Regulations.
Type Certificate Holder West Coast Fabrications
1524 Spruce Avenue
Chico, CA  95926
I - Model C-97G (Restricted Category), approved June 01, 1983
Engines 4 - P & W R-4360-59B
Fuel Aviation gasoline 115/145 Grade
For Alternate Fuels see T.O. 1C-97G-1 Section V
Engine limits Maximum Wet Power, Sea Level
3,500 BHP @ 2700 RPM and 247 TPSI (Torque Pressure)
Maximum Dry Power, Sea Level
3,250 BHP @ 2700 RPM and 230 TPSI (Torque Pressure)
See Airplane Flight Manual T.O. 1C-97G-1 and Appendix T.O.
1C-97G-1-1 Part 2 for complete engine power and performance data.
Propellers 4 - Hamilton Standard 34G60, Blade No. R-C7021D-8
See T.O. 1C-97G-1 Section V for limitations
 
Airspeed limits Vne = 302 knots or Mach 0.62 whichever is less
Va = 206 knots IAS Maneuvering
Vf = 155 knots IAS for 55% to 100% flaps
= 190 knots IAS with flaps to 55%
Vlo = 200 knots IAS Landing Gear Extension Speed
Maximum Cargo Doors Open and Aerial Delivery Speed
V  = 155 knots IAS
C.G. range Operating Range 18.5% to 30.5% MAC
Datum 50 in. fwd of nose (Distance from datum to nose jacking cone
228.6 in.)
Leveling means Indicator below floor in forward lower compartment (Sta. 356)
Maximum gross weight
  Take Off 153,000 lbs.
Landing weight
(10 FPS Sink Speed) 130,000 lbs.
(8.3 FPS Sink Speed) 153,000 lbs.
(Note:  Chart for Contact Sinking Speed between 130,000 and 153,000 lbs.
provided in Flight Manual T.O. 1C-97G-1)

A11NM
Page 2
Maximum Zero Fuel Weight    128,000 lbs.
(See Flight Manual for Fuel Loading distribution and limitations)
Minimum crew Pilot, Copilot, and Flight Engineer
Fuel capacity 7,790 gals. total - 2 outboard tanks 1,770 gal. each
                - 2 inboard tanks 1,520 gal. each
                - 1 Center Wing tank 1,210 gal.
Oil capacity 186 gals. total - 4 engine tanks 32.5 gal. each
                - 2 transfer tanks 56 gal.
Cargo capacity See Flight Manual T.O. 1C-97G-1 Section V
Control surface movements
MOVEMENT FROM TRAILING EDGE
CONTROL SURFACE POSITION NEUTRAL POSITION MOVEMENT
  IN DEGREES       IN INCHES            
AILERONS UP 25 (+ 1) 9.22 (+ .38)
  DOWN 25 (+ 1) 9.22 (+ .38)
AILERONS TRIM TABS                UP 5.5 (+ 1) .75 (+ .06)
                                        DOWN 5 (+ 1) .75 (+ .06)
ELEVATORS                         UP 20 (+ 1)            12.45 (+ .62)
                                        DOWN  15 (+ 1)             9.36 (+ .62)
ELEVATOR TRIM TABS
RIGHT UP           12 (+ 2)             2.55 (+ .43)
 DOWN         12 (+ 2)             2.55 (+ .43)
LEFT - WING FLAPS UP, NEUTRAL
 POSITION OF TRIM TAB
  WITH ELEVATOR IN UP           1.5 (+ .5/-.25)       .32 (+ .11/-.05)
 NEUTRAL POSITION
             WING FLAPS DOWN UP 3 (+ 1/2) 64 (+ .11)
45 DEGREES, ELEVATOR
IN NEUTRAL POSITION
MEASURED FROM POSITION
GIVEN ABOVE
RUDDER
(BY PEDAL WITH RUDDER RIGHT 22 (+ 1) 24.94 (+ 1.12)
BOOST ON)                      LEFT         22 (+ 1)            24.94 (+ 1.12)
(BY TRIM KNOB WITH RUDDER RIGHT 15.5 (+ 1/-1.5) 17.62 (+ 1.11/-1.69)
BOOST ON)                     LEFT         15.5 (+ 1/-1.5)     17.62 (+ 1.11/-1.69)
RUDDER TAB RIGHT 20 (+ 1) 2.95 (+ .15)
LEFT 20 (+ 1) 2.95 (+. 15)
WING FLAPS DOWN 45 (+ 2)

A11NM
Page 3
 Serial Numbers eligible Manufacturers Serial Numbers
   (See Note 2A and 2B) For aircraft exported and returned to United States
   (See Note 5)
 AF51- 7260 thru AF51-7271, AF52-526 thru AF52-938, AF52-2602 thru
AF52-2692, AF52-2694 thru AF52-2716, AF52-2763 thru AF52-2806,
AF53-106 thru AF53-365, AF53-3815 and AF53-3816
Data Pertinent To All Models                                                                                                                                                                 
Certification basis FAR 21.25(a)(2) and (b)(7) dated February 6, 1982, Amendment 21-1 through 21-56
Restricted Type Certificate issued
Production basis None - Prior to original airworthiness certification of each aircraft, an FAA representative
must perform an inspection for workmanship, materials, and conformity with the approved
technical data and assure that the applicant has conducted a satisfactory flight test.
Equipment The basic required equipment as prescribed in the applicable airworthiness
(See NOTE 6) regulations (see Certification Basis) must be installed in the aircraft for certification.
In addition, an FAA approved Airplane Flight Manual Supplement is required in
addition to Flight Manual T.O. 1C-97G-1.
NOTE 1. Current weight and balance report and loading instructions must agree with Section V of United States Air
Force T.O. 1C-97G-1 Manual for the C-97G airplane.
NOTE 2. A. This approval applies to basic United States Air Force Boeing C97G aircraft with no major modifications
except as described in data per West Coast Fabrications FAA approved Drawing List WC971, Revision 3,
dated June 07, 1983, or later FAA approved revision thereto.
B. Airplane certified for the special purpose of carriage of cargo.
(1) In addition to the operating limitations in this data sheet, area, economic, passenger
and other appropriate operating limitations in accordance with FAR 21.25 shall be shown on
placards or listing accessible to the pilot.
(2) Carriage of hazardous materials is prohibited unless compliance is shown with applicable
regulations in Code of Federal Regulations 49, Part 175.
(3) The following placard must be displayed in front of and in clear view of the pilot:
"This airplane must be operated as a restricted category airplane in
compliance with the operating limitations stated in the form of placards,
markings, and manuals."
NOTE 3. The aircraft must be serviced and maintained in accordance with USAF T.O. 1C-97(K)E(C)-2-1.
NOTE 4. All cargo must be loaded and restrained in accordance with USAF T.O. 1C-97G-1, Section. V.
NOTE 5. The following note must be placed under "exceptions" on all Export Certificates of Airworthiness
for this aircraft.  "This aircraft is type certificated in the restricted category and may not meet the
applicable airworthiness code as provided by Annex 8 to the Convention on International Civil Aviation.
NOTE 6. USAF T.O. 1C-97G-1 must be available in the C-97G aircraft for all flight operations.
NOTE 7. Unless already accomplished, removal of inflight refueling systems, tanks and support cradles will be
accomplished in accordance  to USAF T.O. 1C-97(K)E(C)-2-6.
---END---
```

## ADs

None name its models.

## Registered aircraft by registry model (OpenAirDocs)

- [Boeing C-97-G](https://openairdocs.org/model/boeing-c-97-g): 1 aircraft (registry code 1381606)

---
OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.
