# TCDS E45NE: Pratt & Whitney Canada Inc.

- Type: Type certificate data sheet
- Status: Current
- Holder: Pratt & Whitney Canada Inc.
- Revision: 0
- Revised: December 16, 1993
- Product: Engine
- Certification basis: Part 21, Part 33
- Registered aircraft: 39, by the registry models matched to it (OpenAirDocs)
- Data sheet PDF: https://openairdocs.org/files/sha256/64/4b/644bfe4771a7bb519f495d8c64ce35b19183e5dcdb643428be2e53008983240b
- FAA DRS: https://drs.faa.gov/browse/excelExternalWindow/D9ECD1561D65A54686257547006E5B34.0001
- Page: https://openairdocs.org/tcds/E45NE

## Models (1)

As the data sheet lists them.

- JT15D-5D

## What the data sheet says

From the PDF's text layer, line by line; tables lose their columns. The PDF is the record.

```text
PAGE  1  2  3  4  LEGEND: "- -" INDICATES "SAME AS PRECEDING MODEL"
 REV.                  "---" NOT APPLICABLE
U.S. DEPARTMENT OF TRANSPORTATION
FEDERAL AVIATION ADMINISTRATION
TYPE CERTIFICATE DATA SHEET E45NE
TCDS NUMBER E45NE
REVISION:  Original*
DATE:  DECEMBER 16, 1993
PRATT & WHITNEY CANADA, INC
MODELS:
JT15D-5D
Engines  of models described herein conforming with this data sheet (which is part of Type Certificate Number E45NE) and other approved
data on file with the Federal Aviation Administration, meet the minimum standards for use in certificated aircraft in accordance with
pertinent aircraft data sheets and applicable portions of the Federal Aviation Regulations, provided they are installed, operated, and
maintained as prescribed by the approved manufacturer's manuals and other approved instructions.
TYPE CERTIFICATE (TC) HOLDER: Pratt & Whitney Canada, Inc.
1000 Marie-Victorin
Longueuil, Quebec
Canada J4G 1A1
MODELS I. JT15D-5D
TYPE Twin spool with single stage integrally bladed fan, one axial compressor stage and
one centrifugal compressor stage, three stage turbine, annular reverse-flow
combustor and full length annular bypass duct.
THRUST RATING, POUNDS
(See NOTE 1)
 Maximum continuous at sea level
 Takeoff (5 min.) at sea level
3,045
3,045
ENGINE SPEED LIMITATIONS, RPM
  (See NOTE 4 and also refer to
  Installation Manual for transients)
 Max steady state low rotor (N1)
 Max steady state high rotor (N2)
16,860
31,777
INTERTURBINE TEMPERATURE łF/łC
MODELS: JT15D-5D
 Takeoff (5 min.)
 Maximum continuous
  Starting
 Transient (2 sec.)
1328/720
1292/700
1022/550
1364/740
   (Also see Installation Manual)
OIL INLET TEMPERATURE łF/łC
MODELS: JT15D-5D
 Maximum
 Minimum
 Transient maximum (15 min.)
250/121
-40/-40
275/135
MAXIMUM ACCESSORY TEMP. The engine compartment shall be ventilated as necessary to keep the air
temperature surrounding accessory components from exceeding the limits defined in
the applicable Installation Manual.

TCDS  E45NE                                                                                                                                                          PAGE 2
AIR BLEED, MODELS: JT15D-5D
A.  High compressor bleed.
     Maximum external bleed air
     available is:
10% of high compressor flow to 22,000 feet,
decreasing linearly to 5% at 45,000 feet. No more
than 5% may be taken from either of the bleed
ports.
- -
B.  During starting, bleed shall
     not exceed that taken by a:
0.3 - inch diameter orifice throat - -
C.  Bleed air contamination meets: Para 3.18 of MIL-E-5007C - -
FUEL / ALL MODELS
Fuel Bleed
Fuel from pump delivery may be extracted to drive jet or turbine pumps in the airplane fuel
system.  Refer to appropriate Installation Manual.
Fuel Pressure Refer to Installation Manual.
Fuel temperature Maximum fuel pump inlet temperature for starting and operating is 135 łF(57łC); minimum
inlet temperature is -65łF(-54łC), subject to a viscosity limit of 12 centistokes.
Fuel type (Also see NOTE 2) Fuels conforming with PWC, Service Bulletin 7144, plus Icing Inhibitor  (Fuel System  to
C.G.S.B. Specification 3-GP-526a or MIL-I-27686) in the absence of an approved fuel
heater.
FUEL
COMPONENTS FUEL CONTROL FUEL FLOW DIVIDER FUEL PUMP
JT15D-5D Bendix Avelex DP-L2
PWC P/N 3118402-01
Lucas 26280
PWC P/N 3118375-01
Argo Tech 717100
PWC P/N 3037078
OIL            MODELS: JT15D: -5D
OIL PRESSURE psig
Min. at 20000 rpm N2 & above
Min. below 20000 rpm N2
Max.
Max. transient (90 seconds)
60
40
90
100
OIL TYPE (Also see NOTE 7) Synthetic type conforming with the current PWA 521 (Type II) Specifications (See
Department of Transport Canada approved Installation Manual).
OIL TANK CAPACITY
Total capacity
   Imperial gallons
   U.S. gallons
Usable capacity
   Imperial gallons
   U.S. gallons
1.74
2.09
0.97
1.17

TCDS  E45NE                                                                                                                                                          PAGE 3
ACCESSORY
DRIVES
The following apply to the accessory drives, which are provided by the engine and included in the basic
engine weight:
SPEED RATIO
TO TURBINE
MAXIMUM TORQUE
(in. - lb.)
MAXIMUM
OVERHANG
DRIVE ROTATION SHAFT CONTINUOUS STATIC (in.-lb.)
DRIVEN BY HIGH ROTOR
 High rotor tachometer
 Hydraulic pump
 Starter generator
DRIVEN BY LOW ROTOR
 Low rotor tachometer
CW
CW
CW
CCW
.1282:1
.1282:1
.3640:1
.2642:1
7
225
210
7
50
1600
1600
50
10
125
180
0
*CW - Clockwise; CCW - Counterclockwise
Total accessory power limit is 22.5 hp. at 52% N2, increasing linearly to 30 hp. at 97% N2.  Refer to
Installation Manual for restrictions above 20,000 ft. altitude.  Also see NOTE 3.
IGNITION MODELS  JT15D
-5D
Exciter
  Lucas
Igniter plug
  Unison
PWC P/N 3118172-01
PWC P/N 3117464-01
PRINCIPAL DIMENSIONS Refer to Installation Drawing in approved Installation Manual.
C. G. LOCATION Refer to Installation Drawing in approved Installation Manual.
CERTIFICATION BASIS
Models JT15D-5D FAR 21.29, FAR 33, Amendments 1 through 14 inclusive, effective
September 10, 1990, and FAR 34 effective September 10, 1990.
TYPE CERTIFICATE NUMBER E45NE
MODEL
APPLIED
FOR
ISSUED/
REVISED DELETED
JT15D-5D 12/10/93 12/16/93
IMPORT REQUIREMENTS: To be considered eligible for installation on United States (U.S.) registered aircraft, 
each engine to be exported to the U.S. shall be accompanied by a certificate of 
airworthiness for export or by a certifying statement, endorsed by the exporting 
cognizant civil airworthiness authority and containing the following language:
(1) This engine conforms to its Type Certificate Number E45NE and is in a 
condition for safe operation.
(2) This engine has been subjected by the manufacturer to a final 
operational check and is in a proper state of airworthiness.
Reference FAR Section 21.500, which provides for the airworthiness acceptance 
of aircraft engines manufactured outside of the U.S. and for which a U.S. type 
certificate has been issued.  Additional guidance is contained in FAA Advisory 
Circular 21-23, "Airworthiness Certification of Civil Aircraft, Engines, Propellers, 
and Related Products Imported into the United States."

TCDS  E45NE                                                                                                                                                          PAGE 4
NOTES
NOTE 1. The engine ratings are based on static sea level conditions:
  Compressor inlet air (dry) 80łF, at takeoff and 59łF at max. continuous).
  29.92 in. Hg.
  No accessory loads or air bleed.
  Engine intake and exhaust as described in the Department of Transport, Canada,
  approved Installation Manual.
NOTE 2. Emergency operation on gasoline (MIL-G-5572, all grades) is limited to a total of 50 hours in any
engine overhaul period.
NOTE 3. The starter/generator pad may be overloaded in emergency to a torque of 340 in.-lb. for periods up to
5 minutes, subject to total accessory power not exceeding 40 hp.
NOTE 4. Minimum permissible flight idle N2 is 17035 RPM (52%).
NOTE 5. Certain engine parts are life limited.  For JT15D-5D engines, these life limits are listed in
P&WC Engine Service Bulletin Number 7002.
NOTE 6. Permissible overhaul and inspection intervals are listed in P&WC Engine Service Bulletin
Number 7003.
NOTE 7. P&WC Engine Service Bulletin Number 7001 lists approved oil brands.
NOTE 8. Prior to issue of the DOT-approved Maintenance Manual, JT15D-5D engines must be
maintained in accordance with temporary instructions issued by Pratt & Whitney personnel.
Overhauls are not permitted until issuance of the DOT-approved Overhaul Manual.
Engines may be returned to Pratt & Whitney Canada for re-manufacture to new production
standard.
NOTE 9. Service bulletins, structural repair manuals, vendor manuals, aircraft flight manuals, and
overhaul and maintenance manuals, which contain a statement that the document is
Transport Canada-approved, are accepted by the FAA and are considered FAA-approved
unless otherwise noted.  These approvals pertain to the type design only.
----END----
```

## ADs

None name its models.

## Registered aircraft by registry model (OpenAirDocs)

- [Pratt & Whitney Canada JT15D-5D](https://openairdocs.org/engine/pratt-whitney-canada-jt15d-5d): 39 aircraft (registry code 52192)

---
OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.
