# TCDS G15EU: Alexander Schleicher GmbH & Co. Segelflugzeugbau

- Type: Type certificate data sheet
- Status: Current
- Holder: Alexander Schleicher GmbH & Co. Segelflugzeugbau
- Revision: 1
- Revised: February 8, 2022
- Product: Aircraft, Glider
- Certification basis: Part 21
- Registered aircraft: 14, by the registry models matched to it (OpenAirDocs)
- Data sheet PDF: https://openairdocs.org/files/sha256/89/26/892642492c30577f6d5a097840f50732414bf8c39fcde27348d312d372af527b
- FAA DRS: https://drs.faa.gov/browse/excelExternalWindow/EFAAFA755A44C6A4862587E9006B8F43.0001
- Page: https://openairdocs.org/tcds/G15EU

## Models (1)

As the data sheet lists them.

- AS-K 13

## What the data sheet says

From the PDF's text layer, line by line; tables lose their columns. The PDF is the record.

```text
Page No. 1 2 
Rev. No. 1 1 
 
DEPARTMENT OF TRANSPORTATION 
FEDERAL AVIATION ADMINISTRATION 
 
G15EU 
Revision 1 
Alexander Schleicher GmbH 
AS-K 13 
February 8, 2022 
 
TYPE CERTIFICATE DATA SHEET NO. G15EU 
 
This data sheet which is a part of Type Certificate No. G15EU prescribes conditions and limitations under which the 
product for which the type certificate was issued meets the airworthiness requirements of the Federal Aviation 
Regulations. 
 
Type Certificate Holder. Alexander Schleicher GmbH & Co. Segelflugzeugbau 
Alexander-Schleicher-Str. 1 
36163 Poppenhausen 
Germany 
 
Type Certificate Holder Record. Alexander Schleicher, Segelflugzeugbau transferred TC G15EU to Alexander 
Schleicher GmbH & Co. Segelflugzeugbau in 1984. 
 
 
I - Model AS-K 13 Glider, approved June 21, 1967 
 
Airspeed Limits. Glide or  108 kts 
Max. speed in rough air 75 kts 
Airplane tow 75 kts 
Auto-winch tow 54 kts 
Airbrakes extended 108 kts 
 
C.G. Range. From (+2.75) to (+9.7) 
 
Datum. Wing leading edge at rib 3 
 
Leveling Means. Tangent on wing rib 3 horizontal 
 
Maximum Weight. 1060 lbs 
 
No. of Seats. 2 
 
Baggage. None 
 
Control Surface Movements. Elevator Up 20° Down 20° 
Rudder Right 30° Left 30° 
Aileron Up 30° Down 15° 
 
Serial Nos. Eligible. The NAA Export Certificate of Airworthiness (Export C of A) endorsed as 
noted below under "Import Requirements" must be submitted for each 
individual glider for which application for certification is made. 
 
Certification Basis. FAR 21.29 and Federal Republic of Germany glider airworthiness requirements 
dated August 1939 (These requirements are equivalent to FAR 21.23). 
Type Certificate G15EU issued June 21, 1967.

G15EU 2 
 
 
Date of Application for Type Certificate:  May 19, 1967. 
 
The German Airworthiness Authority, the Luftfahrt-Bundesamt (LBA), 
originally type certificated this glider under its Type Certificate (TC) No. L-267, 
issued December 13, 1966.  Effective September 28, 2003, the European 
Aviation Safety Agency (EASA) began oversight of this model and the LBA TC 
was deemed to be issued by EASA and remains valid.   
 
Import Requirements. A U.S. airworthiness certificate may be issued on the basis of an NAA Export C 
of A signed by a representative of the LBA, containing the following statement: 
"The glider covered by this certificate has been examined, tested and found to 
comply fully with the Federal Republic of Germany glider airworthiness 
requirements dated August 1939, and conforms to Type Certificate No.  
G15EU." 
 
Refer to the applicable bilateral agreement to verify eligibility for import into 
the United States of both new and used aircraft based on the scope of the 
agreement, to identify any required statements by the exporting authority on the 
export certificate of airworthiness (or equivalent document), and for procedures 
for coordinating exceptions to conformity statements on these documents. Refer 
to FAA Order 8130.2, Airworthiness Certification of Aircraft, for requirements 
for issuance of an airworthiness certificate for imported aircraft. 
 
Equipment. The basic required equipment as prescribed in the applicable airworthiness 
regulations (see Certification Basis) must be installed in the glider for 
certification. 
 
Service Information. Each of the documents listed below must state that it is approved by the EASA 
or – for approvals made before September 28, 2003 – by the LBA:  
• Service bulletins 
• Structural repair manuals 
• Vendor manuals 
• Aircraft flight manuals 
• Overhaul and maintenance manuals 
 
The FAA accepts such documents and considers them FAA-approved for type 
design data only unless one of the following conditions exists: 
• The documents change the limitations, performance, or procedures of 
the FAA approved manuals.  
 
The FAA uses post type validation procedures to approve these documents.  The 
FAA may delegate on a case-by-case basis to EASA to approve these on behalf 
of the FAA for the U.S. type certificate.  If this is the case, it will be noted on 
the document.  
 
NOTES. 
 
NOTE 1. Current weight and balance report including list of equipment in certificated empty weight, and 
loading instructions when necessary, must be provided for each glider at the time of original 
certification. 
 
NOTE 2. The following placard must be installed in full view of the pilot: 
a. "When flying in rough air do not exceed 75 knots" 
b. "No acrobatic manoeuvres including spins approved" 
...END...
```

## ADs (7, in force first)

- [AD 2022-12-07](https://openairdocs.org/ad/2022-12-07): Elevator, Spar/Rib Structure · Alexander Schleicher GmbH & Co. Segelflugzeugbau Ka2B, Ka 6, Ka 6 B and 7 more. Effective Jul 21, 2022
- [AD 2013-16-05](https://openairdocs.org/ad/2013-16-05): Flight Controls · Alexander Schleicher AS-K 13, K 8, K 8 B and 7 more. Effective Oct 4, 2013
- [AD 98-13-05](https://openairdocs.org/ad/98-13-05): Inspect Main Spar Fitting · Alexander Schleicher AS-K 13. Effective Aug 1, 1998
- [AD 97-08-06 R1](https://openairdocs.org/ad/97-08-06-R1): Quick Connectors · Alexander Schleicher AS-K 13, AS 12, ASK 21 and 39 more. Effective Aug 1, 1997
- [AD 69-05-04](https://openairdocs.org/ad/69-05-04): Landing Gear Buffer Plate · Alexander Schleicher AS-K 13. Effective Apr 5, 1969
- [AD 68-25-05](https://openairdocs.org/ad/68-25-05): Wheel Brake Cable · Alexander Schleicher AS-K 13. Effective Jan 10, 1969
- [AD 75-23-03](https://openairdocs.org/ad/75-23-03) (historical): Elevator and Control · Alexander Schleicher AS-K 13, K 8, K7 and 15 more. Effective Nov 14, 1975

## Registered aircraft by registry model (OpenAirDocs)

- [Schleicher AS-K13](https://openairdocs.org/model/schleicher-as-k13): 14 aircraft (registry code 38015GS)

## STCs approved under this data sheet (6)

- [STC SA4503NM](https://openairdocs.org/stc/SA4503NM): Remove original cloth covering and install Ceconite covering. Ceconite Division of Poly-Fiber Inc.
- [STC SG03715NY](https://openairdocs.org/stc/SG03715NY): Iunstallation and maintenance of Oratex 6000 Covering and Coating System. Lanitz-Prena Folien Factory GmbH
- [STC SG04702NY](https://openairdocs.org/stc/SG04702NY): Installation and maintenance of Oratex UL600 Covering and Coating System. Lanitz-Prena Folien Factory GmbH
- [STC SA1008WE](https://openairdocs.org/stc/SA1008WE): Installation of Poly-Fiber covering material.. Poly-Fiber Inc.
- [STC SG01164CH](https://openairdocs.org/stc/SG01164CH): Install Cooper superflite 102 fabric.. Aviation Products Systems Inc.
- [STC SG1175GL](https://openairdocs.org/stc/SG1175GL): Surrendered and incorporated into STC SG01164CH.. Cooper Aviation Supply Company, Inc.

---
OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.
