# TCDS G1EU: AB Flygindustri - Type: Type certificate data sheet - Status: Current - Holder: AB Flygindustri - Revision: 1 - Revised: April 8, 2022 - Product: Aircraft, Glider - Certification basis: CAR 10 - Registered aircraft: 2, by the registry models matched to it (OpenAirDocs) - Data sheet PDF: https://openairdocs.org/files/sha256/c5/95/c5950b84e794df40b0080fe356c97cc25f96ac24a3da43428227d2b8413b6f47 - FAA DRS: https://drs.faa.gov/browse/excelExternalWindow/CC1FCFE7414942CA86258821006D8C38.0001 - Page: https://openairdocs.org/tcds/G1EU ## Models (1) As the data sheet lists them. - JS Weihe ## What the data sheet says From the PDF's text layer, line by line; tables lose their columns. The PDF is the record. ```text Page No. 1 2 Rev. No. 1 1 DEPARTMENT OF TRANSPORATION FEDERAL AVIATION ADMINISTRATION G1EU Revision 1 AB FLYGINDUSTRI JS Weihe April 8, 2022 TYPE CERTIFICATE DATA SHEET NO.G1EU This Data Sheet which is a part of Type Certificate No. G1EU prescribes conditions and limitations under which the product for which the type certificate was issued meets the Airworthiness Requirements of the Civil Air Regulations. Type Certificate Holder AB Flygindustri Bulltofta flygplate Malmo, Sweden I - Model JS Weihe Glider, Approved November 5, 1963. Airspeed Limits Glide or dive 170 km/h (106 mph) Auto-winch tow 90 " ( 56 " ) Airplane tow 110 " ( 68 " ) Rough Air 110 " ( 68 " ) Air brakes extended 140 " ( 87 " ) C.G. Range (+16.2) to (+21.65) Datum Wing leading edge at rib No. 3 Leveling Means Top of the fuselage between wing and stabilizer shall be horizontal. No. of Seats One Baggage None Control Surface Movements Elevator Up or down 7.79 in + .55 in. (198 mm + 14 mm) Elevator trim Up or down 1.69 in + .12 in. (43 mm + 3 mm) Aileron Up 6.81 in + .39 in. (173 mm + 10 mm) Down 2.28 in + .43 in. (58 mm + 11 mm) Rudder Right or left 17.01 in + 1.10 in. (432 mm + 28 mm) Elevator and rudder measured at max. chord. Elevator trim measured at gap between elevator trim and elevator. Aileron measured at rib No. 16. Serial Nos. Eligible A Swedish Certificate of Airworthiness for Export (Export C of A) endorsed as noted under "Import Requirements" must be submitted for each individual glider for which application for certification is made. Import Requirements A U.S. Airworthiness Certificate may be issued on the basis of a Swedish Export C of A signed by a representative of the Swedish Royal Board of Civil Aviation containing the following statement: "The glider covered by this certificate has been examined and found to comply fully with valid Swedish Civil Aviation Regulations and with the Federal Republic of Germany glider airworthiness G1EU 2 requirements dated August 1939 and conf orms to T.C. No. G1EU". (This certification is equivalent to CAR 5 effective February 15, 1956) Refer to the applicable bilateral agreement to verify eligibility for import into the United States of both new and used aircraft based on the scope of the agreement, to identify any required statements by the exporting authority on the export certificate of airworthiness (or equivalent document), and for procedures for coordinating exceptions to conformity statements on these documents. Refer to FAA Order 8130.2, Airworthiness Certification of Aircraft, for requirements for issuance of an airworthiness certificate for imported aircraft. Certification Basis CAR 10. Type Certificate No. G1EU, issued November 5, 1963. Date of application for Type Certificate February 14, 1963. Each glider and any replacement parts manufactured in Sweden must be clearly identified as imported. Equipment The basic required equipment as prescribed in the applicable airworthiness regulations (see Certification Basis) must be installed in the glider for certification. NOTES NOTE 1. A current weight and balance report including list of equipment included in certificated empty weight, and loading instructions when necessary, must be provided for each glider at the time of original certification. NOTE 2. The following placards must be installed in full view of the pilot: (a) Identification placard, including (1) the manufacturer's name, (2) place of manufacturer, (3) model designation, (4) manufacturer's serial numbers, (5) Type Certificate No., (6) maximum take-off weight. (b) "Flight in cloud - Permissible only when rate of climb indicator and turn and bank indicator are fitted". (c) "No acrobatic maneuvers (including spins) are allowed." (d) "Night flying is prohibited". (e) "This glider must not be landed with the undercarriage wheel in place. The wheel must be jettisoned after take-off at a height of 10 ft or more and at a speed not in excess of 50 knots." (f) "When flying in rough air do not exceed 110 km/h (68 mph)". ...END... ``` ## ADs None name its models. ## Registered aircraft by registry model (OpenAirDocs) - [AB Flygindustri JS WEIHE](https://openairdocs.org/model/ab-flygindustri-js-weihe): 2 aircraft (registry code 3802219) ## STCs approved under this data sheet (1) - [STC SG03896NY](https://openairdocs.org/stc/SG03896NY): Installation and maintenance of ORATEX covering and coating material. Aircraft Design & Certification Ltd --- OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.