# TCDS LTC-20: Krogmann Carl F. - Type: Type certificate data sheet - Status: Current - Holder: Krogmann Carl F. - Revision: 2 - Revised: June 6, 1947 - Product: Aircraft, Large Airplane - Data sheet PDF: https://openairdocs.org/files/sha256/98/b6/98b6338197af5d74e711402fc3af1c68f715893796f4746141fd30133b76675a - FAA DRS: https://drs.faa.gov/browse/excelExternalWindow/69D14D8DEBE4A119862574950068D285.0001 - Page: https://openairdocs.org/tcds/LTC-20 ## Models (1) As the data sheet lists them. - Martin (Navy) PBM-5 ## What the data sheet says This is OCR from the scanned FAA data sheet. OCR can misread letters and numbers. ```text MARTIN-MARIETTA CORPORANION MODELS: Martin (Navy), PBM-5 (Approved 6/6/47) SPEC. NUMBER: I-20-2 (Eligible for certification in Limited Category only.) (Holder of Limited Type Certificate: Carl F. Krogmann, Washington, D.C.) Engines 2 Pratt & Whitney R-2800-22 or -34 Fuel Grade 100/130 Engine limits ц4.5 in #9 2600 pm (1700 h) Maximo fe.) 05.5 in. Hg.. 2600 xpm (1450 hp) (18,500 ft.) 42 in.Hg.. 2600 rpm (1450 (Take-off (five minutes) 55 in. Hg.. 2800 rpm Maximum, except take-off (low blower): (Sea level) 44 in. Hg., 2600 rpm (1700 hp) (8000 ft.) 41.5 in. Hg.. 2600 rpm (1700 hp) or (Sea level) 44 in. Ag.. 2500 pm (1700 hp) (6500 ft.) 42 in.Hg.. 2500 pm (1700 hp) Maximum, except take-off (high blower) (1500 (c) 5 10-59 350 p (150 0 p) 2600 rpm (1500 hp) (16,000 ft.) 42 in. Hg.. 2500 rpm (1500 hp) Propellers Curtiss C642S-B46 hub; 836-17C2-0 blades 1418" diameter (See NOTE 2b) Hamilton Standard 33E60 hub 6491A-0 blades 15'2 Airspeed limits (See NOTE 2) Glide or dive 242 mph Maximum weight 50,000 1bs. C.G. range 31 percent MAC to 35 0/0 MAC (Reference Navy 7.0. 4-46, 1118/46) Datum Forward point of nose section MAC 159.7 inches I.E. MAC 319.0 inches other Operating Technical Note 70-45, Technical Order 87-45 and Limitations: Technical Order 4-46 Certification basis Limited Type Certificate No. 20 (CAR 9 effective Production basis None may be produced under this approval Export eligibility Not eligible for a Certificate of Airworthiness for No equipment other than engines and propellers are specified. However, such equipment as required by Civil Air Regulations Part 43.30 for the particular operation authorized for NC aircraft must be installed. Also, any additional equipment necessary for the proper operation of the aircraft. In addition, the aircraft may incorporate such military equipment (except armament) as was originally incorporated in the type for military or naval service. Additional equipment may be installed as can be substantiated on the tasis that it presents no obvious hazard to safety. Weight and Balance Report including list of equipment included in the certificated empty weight must be submitted for each aircraft. Army or Navy weight records in current condition may be submitted in lieu of an actual The equipment list need include no more than the following: Required equipment as defined under "Equipment" above. Additional items as may be reasonably considered removable and are so located or of such weight that their removal or addition noticeably affect the weight and balance of the aircrait. Item built into the aircraft structure need not be listed. The equipment list must be prepared by the applicant for the approval of the certifi- cating C.A.A. representative, and in such form that it can be attached to the C.A.A. Operation Limitations. The following placards must be prominently displayed in the positions In full view of passengers: "This is a military type aircraft and under the Civil Air Regulations shall not be used for the carriage of passengers or cargo for compensation or hire." In the cockpit in full view of the pilot: "Do not exceed 127 mph with flaps extended." "Avoid continuous engine operation between 2150 and 2300 rpm." (Applies only to airplanes with curtiss propellers.) "No acrobatics permitted." The following statement must appear on the Operation Limitation: This airplane must be operated at all times within the limitations set forth in Navy Technical Note No. 70-45 and Navy Technical Orders Nos. 87-45 and 4-46 except for limitations specifically called out in Aircraft Speci- fication AL-20 in which case the values given in the Specification must be observed. A copy of Navy Technical Order and Aircraft Specification AL-20 m the caricant to secure Copies of the Navy Technical Order the C...A. must be carried during flight." does not have these documents available for distribution. NOTE 4. If any repairs or modifications are made prior to and/or subsequent to certification, it is the responsibility of the owner to furnish sufficient evidence to a C.A.A. representative to show that the moditied airplane maintains the same degree of airworthiness as the original. give no technical assistance on such matters since complete structural data for NI aircraft are not required by Part 9 and therefore are not available in the C.A.A. Prior to obtaining certification for night operation, the following modifications to the exterior lighting must be made in order to comply with the general requirements of the Civil Air Regulations. Position Lights Wing Tip - The AN-3033-9 or AN-3033-1 through -4 or the AN-3032-1 through -4 light assemblies are satisfactory without modification. If Type D-1 (AN-3091-1 through -3) or the Type D-2 (AN-3092-1 through -3) light assembly is installed on the tail cone it must be replaced with a type certificated unit. Position Light Installation The position lights shall be installed to comply with the requirements of the CAR, Parts 15.2 and 3.538. Position Light Circuit and Control The position lights (wing tips and tail) shall be controlled by one SPST switch. The circuit should be protected by its own fuse or circuit breaker. the individual wing tip and tail light switches with dim and bright positions shall be removed and the dimming resistors shall be disconnected. (4) Other Exterior Lights with the exception of the landing and anchor lights, any other exterior lights are not required and may be removed, if во desired. No original NL airworthiness certificates may be issued after 8/31/48. of mandatory changes required prior to original certification may be obtained from CAA Aircraft Service, Washington 25, D.C., Attn: A-298. ``` ## ADs None name its models. ## STCs approved under this data sheet (2) - [STC SA02268CH](https://openairdocs.org/stc/SA02268CH): Installation of Airwolf Filter Corp. Air Oil Separator. Airwolf Filter Corporation - [STC SA01282NY](https://openairdocs.org/stc/SA01282NY): Installation of Airwolf remote mounted engine oil filter kit AFC-K015 on aircraft powered by Pratt & Whitney radial reciprocating engine Series R-985, R-1340 and R-1830.. Airwolf Filter Corporation --- OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.