# TCDS LTC-22: Mustang Aviation - Type: Type certificate data sheet - Status: Current - Holder: Mustang Aviation - Revision: 2 - Revised: August 8, 1947 - Product: Aircraft, Small Airplane - Certification basis: CAR 9 - Data sheet PDF: https://openairdocs.org/files/sha256/81/5c/815c1aee234f1789f7e654ac251b12ab5a1d0779e0a70be31ec5c6640a952803 - FAA DRS: https://drs.faa.gov/browse/excelExternalWindow/8D2B6F3862586DBA8525673D004248A3.0001 - Page: https://openairdocs.org/tcds/LTC-22 ## Models (1) As the data sheet lists them. - Army BC-1 ## What the data sheet says This is OCR from the scanned FAA data sheet. OCR can misread letters and numbers. ```text MODEIS: North American (Army) BC-1 (Approved 8/8/47) SPECIFICATION NUMBER: 1-22-2 (Eligible for Certification in Limited Category only.) (Holder of Limited Type Certificate: Mustang Aviation, Inc., Dallas, TX) Engine Pratt & whitney R-1340-AN-1, R-1340-47 or -4) Fuel 80 minimum octane aviation fuel Engine limits Maximum, except take-off 34 in.Ag., 2200 rpm (550 hp) (5000 ft.) 32.5 in. Hg.. 2200 rpm (550 hp) Take-off (one minute) 36 in.Hg.. 2250 rpm (600 hp) Propellers Hamilton Standard 12D40 hub, 6101A-12 blades, Airspeed limits Glide or dive, 240 mph Maximum gross weight C.G. range 28.7" (19.0 percent MAC) to 35.2" (27.6 percent MAC) Datum Leading edge of wing center section MAC 75.6 in. I.E. MAC 14.4 in aft of datum Other Operating Limitations: Army T.O. 01060FA-1 Certification basis Limited Type Certificate No. 22 (CAR 9 effective 11/21/46) Production basis None may be produced under this approval Export eligibility Not eligible No equipment other than engines and propellers are specified. However, such equipment as required by CAR 43.30 for the particular operation authorized must additional equipment for the proper operation of the In addition, the aircraft may incorporate such military equipment (except armament) as was originally incorporated in the type for military service. Additional equipment may be installed as can be substantiated on the basis that it presents no obvious hazard to safety. Weight and Balance Report including list of equipment included in the certificated empty weight myst be submitted for each aircraft. Weight records in current condition may be submitted in lieu of an actual weight. equipment list need include no more than the following: Required equipment as defined under "Equipment" above. Additional items as may be reasonably considered removable and are so located or of such weight that their removal or addition could noticeably affect the weight and balance of the aircraft. Items built into the aircraft structure need not be listed. The equipment list must be prepared by the applicant for the approval of the certificating FAA representative, and in such form that it can be attached to the pertinent operating limitations. The following placards must be prominently displayed: In full view of passengers: '¿This is a military type aircraft and under the CAR shall not be used for the carriage of passengers or cargo for compensation or hire.' In the cockpit in full view of the pilot: "Do not extend flaps above Maneuvers prohibited: Outside loop - Inverted flight - Stall or spin - Snap rolls in excess of 130 mph - Slow rolls in excess of 192 mph."; "This airplane must be operated at all times within the limitations set forth in Army Technical Order No. 01-60FA-1 except for limitations specifically called out in Aircraft Specification AL-22 in which the values given in the specification must be observed. of the pertinent Army Technical Orders must be carried during flight.i In all cases it will be the responsibility of the applicant to secure a copy of the correct Army Technical Orders. The FAA does not have these documents available for distribution. If any repairs or modifications are made prior to or subsequent to NI certification, it is the responsibility of the owner to furnish sufficient evidence to a FAA representative to show that the modified airplane maintain! the same degree of airworthiness as the original. The FAA can give no tech- nical assistance on such matters since complete structural data for NI aircraft are not required by Part 9 and therefore are not available in the For certification for night flying the following must be accomplished: Replace the wing position lights with certificated units or satis- factorily modify the lights if pertinent. Type A-9 wing position (AN-3033-5 thru -8) may be satisfactorily modified by painting the inside frosted portion of the cover black. Type A-9 (AN-3033-1 thru -4) are satisfactory without modification. Replace the tail light with a certificated unit. "Bright and Dim" conditions are provided for the position lights, either the resistors should be disconnected from the circuits and a single-pole-single-throw switch shculd be used to replace the two single- pole-double-throw switches presently installed for. lights, or the switches should be placarded to indicate that only the "bright condition should be used. In either case the tail light and wing-tip lights should operate on one switch. NOTE 5. The list of mandatory changes required prior to original certification may be obtained from FAA, Washington 25, D.C. ``` ## ADs None name its models. ## STCs approved under this data sheet (3) - [STC SA04652CH](https://openairdocs.org/stc/SA04652CH): To allow use of 100R grade aviation fuel meeting Swift Fuel, LLC specification. Swift Fuels LLC - [STC SA01967WI](https://openairdocs.org/stc/SA01967WI): Use of GAMI G100UL High Octane Unleaded Avgas. General Aviation Modifications Inc. - [STC SA01282NY](https://openairdocs.org/stc/SA01282NY): Installation of Airwolf remote mounted engine oil filter kit AFC-K015 on aircraft powered by Pratt & Whitney radial reciprocating engine Series R-985, R-1340 and R-1830.. Airwolf Filter Corporation --- OpenAirDocs.org is an independent research project of [Contrail Labs](https://contraillabs.com/). It is not affiliated with the FAA or the NTSB. Source documents are U.S. government works in the public domain.