Aviation Weather Services, Advisory Circular 00-45F, Change 2 (March 2009) Beam blockage is most easily seen on the 0.5º Base Reflectivity images where it appears as a pie-shaped area (or areas) perpetually void of echoes. When animating the imagery, the beam blockage area will remain clear of echoes even as precipitation and other targets pass through.
4.1.4.2.3.3 Ground Clutter Ground clutter (Figure 4-8) is radar echoes returns from trees, buildings, or other objects on the ground. It appears as a roughly circular region of high reflectivities at ranges close to the radar.
Ground clutter appears stationary when animating images and can mask precipitation located near the radar. Most ground clutter is automatically removed from WSR-88D imagery, so typically it is does not interfere with image interpretation.
4.1.4.2.3.4 Ghost A Ghost (Figure 4-9) is a diffused echo in apparently clear air that is caused by a “cloud” of point targets such as insects or by refraction returns of the radar beam in truly clear air.
The latter case commonly develops at sunset due to superrefraction during the warm season.
The ghost develops as an area of low reflectivity echoes (typically less than 15 dBZ) near the radar site and quickly expands. When animating the imagery, the ghost echo shows little movement.
4.1.4.2.3.5 Angels Angels are echoes caused by a physical phenomenon not discernible by the eye at the radar site. They are usually causes by bats, birds or insects. Angels typically appear as a donutshaped echo with low reflectivity values (Figure 4-10). When animating, the echo expends and becomes more diffuse with time.
Angels typically only appear only when the radar is in clear air mode because of their weak reflectivity. Echoes caused by birds are typically detected in the morning when they take flight for the day. Echoes caused by bats are typically detected in the evening when they take flight from caves.
4.1.4.2.3.6 Anomalous Propagation (AP) Anomalous propagation (AP) (Figure 4-11) is an en extended pattern of ground echoes caused by superrefraction of the radar beam. Superrefraction causes the radar beam to bend downward and strike the ground. It differs from ground clutter because it can occur anywhere within the radar’s range, not just at ranges close to the radar.
AP typically appears as speckled or blotchy, high reflectivity echoes. When animating images, AP tends to “bloom up” and dissipate and has no continuity of motion. AP can sometimes be misinterpreted as thunderstorms; differentiating between to two is determined by animating images. Thunderstorms move with a smooth, continuous motion while AP appears to “bloom up” and dissipate randomly.
4.1.5 Radar Mosaics A radar mosaic consists of multiple single site radar images combined to produce a radar image on a regional or national scale. Regional and national mosaics can be found at the National Weather Service (NWS) Doppler Radar Images web site: http://radar.weather.gov/ridge/
The mosaics are located toward the bottom of the page.
AC 00-45F, CHG 2 Section 4: Radar and Satellite Imagery Page 4-14
Aviation Weather Services, Advisory Circular 00-45F, Change 2 (March 2009)
4.1.5.1 0.5º Mosaics - Contiguous U.S. and Hawaii
The NWS produces a set of regional and national mosaics (Table 4-2) in the contiguous U.S.
using the 124 NM 0.5º Base Reflectivity product (Figure 4-16).
Table 4-2. NWS Radar Mosaic Products Pacific Northwest Pacific Southwest Upper Mississippi Valley Southern Mississippi Valley Northeast Southeast Southern Rockies Northern Rockies Southern Plains Great Lakes Low Resolution National High Resolution National
Figure 4-16. Great Lakes Regional Radar Mosaic Example
The most recent image from single site radars is used to create the product. Single site data older than 15 minutes from the current time of the product are excluded from the image.
Therefore, data on the mosaics will be no greater than 15 minutes old. Where radar coverage overlaps, the highest dBZ value will be plotted on the image.
AC 00-45F, CHG 2 Section 4: Radar and Satellite Imagery Page 4-15
Aviation Weather Services, Advisory Circular 00-45F, Change 2 (March 2009)
4.1.5.2 0.5º Mosaics - Alaska The Alaskan mosaic (Figure 4-17) differs from the contiguous product in only one way: it is created using the 248 NM 0.5º Base Reflectivity single site product.
Figure 4-17. Alaskan Regional Radar Mosaic Example
The long range Base Reflectivity product is used because the radar sites are located at greater distances from each other. Even with the use of the long range product, many areas of Alaskan do not have radar coverage. These areas are shaded gray on Figure 4-17.
AC 00-45F, CHG 2 Section 4: Radar and Satellite Imagery Page 4-16
Aviation Weather Services, Advisory Circular 00-45F, Change 2 (March 2009)
4.2 Satellite
4.2.1 Description Satellite is perhaps the single most important source of weather data worldwide, particularly over data sparse regions such as countries without organized weather data collection and the oceans.
GOES satellite imagery can be found on the NWS Aviation Digital Data Service (ADDS) website at: http://adds.aviationweather.noaa.gov/satellite/. Additional satellite imagery for Alaska can be found on the Alaska Aviation Weather Unit (AAWU) website at:
http://aawu.arh.noaa.gov/sat.php
4.2.2 Imagery Types Three types of satellite imagery are commonly used: Visible, infrared (IR), and water vapor.
Visible imagery is available only during daylight hours. IR and water vapor imagery are available day or night.
4.2.2.1 Visible Imagery Visible imagery (Figures 4-16 and 4-17) displays reflected sunlight from the Earth’s surface, clouds, and particulate matter in the atmosphere. These images are simply black and white pictures of the Earth from space. During daylight hours, visible imagery is the most widely used image type because it has the highest resolution and approximates what is seen with the human eye.
Gray shades displayed on visible imagery can be correlated with particular features. Assuming a high sun angle, thick clouds and snow will appear white, thin clouds will appear translucent gray, land appears gray, and deep bodies of water such as lakes and oceans will appear black.
AC 00-45F, CHG 2 Section 4: Radar and Satellite Imagery Page 4-17
Aviation Weather Services, Advisory Circular 00-45F, Change 2 (March 2009)
Figure 4-18. Visible Satellite Image – U.S. Example
AC 00-45F, CHG 2 Section 4: Radar and Satellite Imagery Page 4-18
Aviation Weather Services, Advisory Circular 00-45F, Change 2 (March 2009)
Figure 4-19. Visible Satellite Image – Regional-Scale Example
4.2.2.1.1 Visible Image Data Legend The data legend (Figure 4-18) on a visible image displays albedo, or reflectance, expressed as a percentage. For example, an albedo of 72 means 72 percent of the sunlight which struck a feature was reflected back to space.
Figure 4-20. Visible Satellite Data Legend.
The gray shades (values) represent albedo or reflectance expressed as a percentage.
4.2.2.2 Infrared (IR) Imagery Infrared (IR) images (Figure 4-19 through 4-22) display temperatures of the Earth’s surface, clouds, and particulate matter. Generally speaking, the warmer an object, the more infrared energy it emits. The satellite sensor measures this energy and calibrates it to temperature using a very simple physical relationship.
AC 00-45F, CHG 2 Section 4: Radar and Satellite Imagery Page 4-19
Aviation Weather Services, Advisory Circular 00-45F, Change 2 (March 2009) Clouds that are very high in the atmosphere are generally quite cold (perhaps -50°C) whereas clouds very near the earth's surface are generally quite warm (perhaps +5°C). Likewise, land may be even warmer than the lower clouds (perhaps +20°C). Those colder clouds emit much less infrared energy than the warmer clouds and the land emits more than those warm clouds.
The data measured by satellite is calibrated and colorized according to the temperature. If the temperature of the atmosphere decreases with height (which is typical), cloud-top temperature can be used to roughly determine which clouds are high-level and which are low-level.
When clouds are present, the temperature displayed on the infrared images is that of the tops of clouds. When clouds are not present, the temperature is that of the ground or the ocean.
Figure 4-21. Infrared (Color) Satellite Image – U.S. Example The scale is in degrees Celsius. Blue/purple colors indicate colder temperatures, while orange/red colors indicate warmer temperatures.
AC 00-45F, CHG 2 Section 4: Radar and Satellite Imagery Page 4-20
Aviation Weather Services, Advisory Circular 00-45F, Change 2 (March 2009) -68 -64 60 56 52 48 44 40 E36 E32 28 524 520 518 512 08 J 0 0 8 12 16 20 24 28 Figure 4-22. Infrared (Color) Satellite Image - Regional-Scale Example The scale is in degrees Celsius. Blue/purple colors indicate colder temperatures, while orange/red colors indicate warmer temperatures.
1-39-371-351-331-31-29 -27 -25 -23-21-191-171-15-131-11-9-71- Figure 4-23. Unenhanced Infrared (black and white) Satellite Image - U.S. Example The scale is in degrees Celsius. Lighter gray shades indicate colder temperatures, while darker gray shades indicate warmer temperatures.
AC 00-45F, CHG 2 Section 4: Radar and Satellite Imagery Page 4-21
Aviation Weather Services, Advisory Circular 00-45F, Change 2 (March 2009)
Figure 4-24. Unenhanced Infrared (black and white) Satellite Image – Regional- Scale Example The scale is in degrees Celsius. Lighter gray shades indicate colder temperatures, while darker gray shades indicate warmer temperatures.
4.2.2.2.1 Infrared Image Data Legends The data legend (Figure 4-23 and Figure 4-24) on an infrared image is calibrated to temperature expressed in degrees Celsius. The legend may vary based on the satellite image provider.
Figure 4-25. Infrared (Color) Satellite Image Data Legend.
The colors (values) represent temperature in degrees Celsius.
Figure 4-26. Unenhanced Infrared (black and while) Satellite Image Data Legend.
The gray shades (values) represent temperature in degrees Celsius.
4.2.3.3 Water Vapor Imagery The water vapor imagery (Figure 4-25 and Figure 4-26) displays the quantity of water vapor generally located in the middle and upper troposphere within the layer between 700 millibars (FL100) to 200 millibars (FL390). The actual numbers displayed on the water vapor images correspond to temperature in degrees Celsius. No direct relationship exists between these values and the temperatures of clouds, unlike IR imagery. Water Vapor imagery does not really "see" clouds but "sees" high-level water vapor instead.
The most useful information to be gained from the water vapor images is the locations and movements of weather systems, jet streams, and thunderstorms. Another useful tidbit is aided AC 00-45F, CHG 2 Section 4: Radar and Satellite Imagery Page 4-22
Aviation Weather Services, Advisory Circular 00-45F, Change 2 (March 2009) by the color scale used on the images. In general, regions displayed in shades of red are VERY dry in the upper atmosphere and MAY correlate to crisp blue skies from a ground perspective.
On the contrary, regions displayed in shades of blue or green are indicative of lots of high-level moisture and may also indicate cloudiness. This cloudiness could simply be high-level cirrus types or thunderstorms. That determination cannot be gained from this image by itself but could easily be determined when used in conjunction with corresponding visible and infrared satellite images.
Figure 4-27. Water Vapor Satellite Image – U.S. Example The scale is in degrees Celsius. Blue/green colors indicate moisture and/or clouds in the mid/upper troposphere, while dark gray/orange/red colors indicate dry air in the mid/upper troposphere.
AC 00-45F, CHG 2 Section 4: Radar and Satellite Imagery Page 4-23
Aviation Weather Services, Advisory Circular 00-45F, Change 2 (March 2009) AC 00-45F, CHG 2 Section 4: Radar and Satellite Imagery Page 4-24
Figure 4-28. Water Vapor Satellite Image – Regional-Scale Example The scale is in degrees Celsius. Blue/green colors indicate moisture and/or clouds in the mid/upper troposphere, while dark gray/orange/red colors indicate dry air in the mid/upper troposphere.
4.2.3.3.1 Water Vapor Image Data Legend The data legend (Figure 4-27) on a water vapor images is calibrated to temperature expressed in degrees Celsius. The actual data values on the water vapor images are not particularly useful. Interpretation of the patterns and how they change over time is more important. The legend may vary depending on the satellite image provider.
Figure 4-29. Water Vapor Satellite Image Data Legend.
The colors (values) represent temperature in degrees Celsius
Aviation Weather Services, Advisory Circular 00-45F, Change 2 (March 2009) 5 GRAPHICAL OBSERVATIONS AND DERIVED PRODUCTS
5.1 Surface Analysis Charts Surface Analysis charts are analyzed charts of surface weather observations. The chart depicts the distribution of several items including sea level pressure, the positions of highs, lows, ridges, and troughs, the location and character of fronts, and the various boundaries such as drylines, outflow boundaries, sea-breeze fronts, and convergence lines. Other symbols are often added depending upon the intended use of the chart. Pressure is referred to in mean sea level (MSL) on the surface analysis chart while all other elements are presented as they occur at the surface point of observation. A chart in this general form is commonly referred to as the weather map.
Figure 5-1. HPC Surface Analysis Chart Example
5.1.1 Issuance Five National Weather Service (NWS) offices issue surface analysis charts:
• The Hydrometeorological Prediction Center (HPC) in Camp Springs, Maryland is responsible for land areas of North America. The charts are available at o http://www.hpc.ncep.noaa.gov/html/sfc2.shtml o http://www.hpc.ncep.noaa.gov/html/avnsfc.shtml
AC 00-45F, CHG 2 Section 5: Graphical Observations and Derived Products Page 5-1