Amendment 23-49 and Subsequent The following flow chart is valid for emergency exit in normal, utility, and acrobatic category airplanes.
Non-Commuter Emergency Exit Flowchart One Emergency Exit on Opposite Side of Cabin from Main Door Passenger Exits Available to Crew One Emer. Exit on Each Side of A/C OR Top Hatch
IN CREW AREA Pilot’s Compartment Separated from Passenger Compartment by a door that will likely block Pilot’s Escape Require One Exit in Pilot’s Compartment Exits near a Hazard
RECONFIGURE Multiengine A/C One Exit Above WL on Each Side of Aircraft OR Overhead Hatch STOP START A A No Yes Yes No Yes No No Yes
23.807(a)(1)
23.805(a)
23.805(a)
23.807(a)(3)
23.807(a)(3)
23.807(a)(4)
23.807(a)(4)
23.807(e)(1)
23.807(e)(1)(2)
23.811 Emergency exit marking
There is no corresponding rule in CAR 3.
The corresponding rule in the Airship Design Criteria, FAA-P-8110-2, Change 2, is section 4.36.
Amendment 23-36 and Subsequent
For small airplanes with emergency exits that open from the outside, the FAA recommends that markings be added to the outside of all exits as follows:
a. Outline the exit with a band of a contrasting color from the surrounding fuselage surface.
b. Mark the corners of the exit in a prominent manner.
c. Outline the exit handle with a band of a contrasting color.
d. Mark the exit with any other prominent visual identification scheme.
e. Install a decal on the outside surface of the exit or the surrounding surface adjacent to the exit that shows the means of opening the exit, including any special instructions if applicable.
Section 23.811(a) is specifically intended to be applicable to exterior emergency exit markings and placards. It does not stipulate the color of these markings and placards, except that they must be obviously identifiable from outside the airplane. Section
23.1557(d) specifically requires that each placard and operating control for each exit must be red. Also, a placard must be near each emergency exit control and must clearly show the location of that exit and its method of operation.
Since the emergency exit exterior markings are obviously identifiable from the outside of the airplane, to further require red placards that show the location of these exits does not make sense. There might be instances where the red placard may not be clearly identifiable because of the exterior color of the fuselage. Section 23.807 gives further guidance on adding external markings to emergency exits. Not one of the recommendations specifies the use of red placards. Other subparagraphs of § 23.811 require the use of red markings when the subject involves the interior of the airplane. Being consistent with these facts, therefore, we interpret the intent of § 23.1557(d) to be applicable to the interior of the airplane.
Passenger exit signs should have an initial luminescence of at least 160 microlamberts, and should be replaced when its luminescence decreases below 100 microlamberts.
Amendment 23-46 and Subsequent
The explanation for this amendment in NPRM 90-20 states as follows “The emergency exit marking standards for transport category airplanes, as stated in Sec.
25.811, have specific requirements that go beyond the current commuter category airplane emergency exit marking standards. Therefore, this notice proposes to add a new Sec. 23.811(c) providing additional airworthiness requirements for emergency exit marking that would be applicable when certification to the emergency exit provisions of Sec. 23.807(d)(4) is requested. The standards in proposed Sec.
23.811(c)(1), which are similar to the requirements of Sec. 25.811(a), ensure conspicuous marking for each emergency exit, its means of access and its means of opening for rapid identification and operation of the exits in an emergency condition.
The standards in proposed Sec. 23.811(c)(2), which are similar to the requirements of Sec. 25.811(b), ensure that the airplane occupants can readily identify and locate the emergency exits on the opposite side of the cabin from where they are seated. The standards in proposed Sec. 23.811(c)(3), which are similar to the requirements of Sec. 25.811(c) that ensure that the airplane occupants can locate the emergency exits when the cabin is filled with dense smoke. The standards in proposed Sec.23.811(c)(4), which are similar to the requirements of Sec. 25.811(e)(1), ensure that the operating handle and the instructions for opening the emergency exits are shown by a marking that is readable from a distance of 30 inches. The standards in proposed Sec. 23.811(c)(5), which are similar to the requirements of Sec.
25.811(e)(2), ensure that there is sufficient lighting to allow identification of the passenger entry door operating handle. The standards in proposed Sec. 23.811(c)(6), which are similar to the requirements of Sec. 25.811(e)(4), ensure the ease of access and operation of a passenger entry door with a locking mechanism that is released by a rotary motion of the handle. The standards in proposed Sec. 23.811(c)(7), which are similar to paragraphs (1) and (2) or Sec. 25.811(f), ensure that the emergency exits are externally marked so that they can be readily identified in conditions of low lighting or poor visibility. These proposed requirements would result in emergency exits that are easier to locate and open in adverse conditions.”
23.812 Emergency lighting
There is no corresponding rule in CAR 3 or the Airship Design Criteria.
Amendment 23-46 and Subsequent
The explanation for this rule adopted in Amendment 23-46 states as follows: “This proposal adds requirements for an emergency lighting system, to be applicable when an applicant for type certification chooses to comply with the alternate emergency exit provisions of proposed Sec. 23.807(d)(4) of this part. The proposal defines specific minimum requirements for supplying power, arming, and activating the emergency lighting system. The impact-activation requirement is consistent with that for emergency locator transmitters. The proposal also includes illumination, function, and survivability requirements for the emergency lighting system. An emergency lighting system complying with these proposed requirements would aid occupants in locating the emergency exits and getting to those exits after an emergency landing.”
23.813 Emergency exit access
There is no corresponding rule in CAR 3 or the Airship Design Criteria.
Amendment 23-36 and Subsequent
A change to this amendment was added by Final Rule docket 25147 as follows: “In addition, the requirements of Section 23.807(d)(4) are moved to a new Section
23.813, titled Emergency exit access", in this final rule.”
See § 23.807 Means of Compliance for policy on acceptance of seatbacks obstructing emergency exits that can be easily moved.
Amendment 23-46 and Subsequent
The explanation in NPRM 90-20 for this amendment states as follows: “This proposal adds requirements to ensure emergency exit accessibility, to be applicable when an applicant for type certification choose to comply with the alternate emergency exit provisions of proposed Sec. 23.807(d)(4) of this part. Structural failures or yielding of the airframe can occur during an emergency landing or minor crash event that may result in one or more emergency exits or the passenger door becoming unopenable. Since the total number of exits available for emergency egress can be fewer with the alternate emergency exit requirements, this proposal defines minimum unobstructed aisle width at the passenger entry door and adds other requirements to ensure that any partitions or doorways within the passenger compartment will not hinder occupant access to the exits during an emergency situation.”
23.815 Width of aisle
There is no corresponding rule in CAR 3 or the Airship Design Criteria.
Amendment 23-34 and Subsequent
This rule, adopted “from SFAR 41, Sec. 5(e), Doors and Exits, paragraph (k), applies to commuter category airplanes”. The main passenger aisle width is the minimum distance between seats measured without occupants. This distance is measured without compressing the seat fabric or cushions, and with the seats and other aisle constraints in their most adverse position. If the seats can swivel and the distances can be less than the rule requires, the most adverse position may be defined with placards or flight manual limitations to require locking them in either a forward or aft facing position for taxi, takeoff, and landing. This is acceptable only when those positions give an aisle distance that meets or exceeds the requirement.
Amendment 23-46 and Subsequent
A proposed revision to NPRM 90-20 explains this amendment as follows: “This proposal requires increased aisle widths to be applicable when an applicant for type certification chooses to comply with the alternate emergency exit provisions of proposed Sec. 23.807(d)(4) of this part. The proposed increased aisle width requirements are intended to ensure that the airplane passengers can reach an exit in an emergency situation even though the floor structure has been warped or there are seats or other items protruding into the normal aisle space.”
23.831 Ventilation
The corresponding rule in CAR 3 is CAR 3.393.
The corresponding rule in the Airship Design Criteria, FAA-P-8110-2, Change 2, is section 4.38.
Original Issue and Subsequent
The use of an alternate air supply, either automatic or manual, that picks up air from within the engine compartment is unacceptable for cabin ventilation because of possible contamination from either fuel, oil, or exhaust leaks.
Halon 1301 may be safely used in concentrations up to 10 percent in airplane cabins.
Ventilation in airplane cabins is sufficient for the agent to disburse in less than five minutes, so the time limit need not be considered if the concentration is held below the 10 percent limit. Halon 1211, however, should not be used in airplane cabins.
The regulation on allowable carbon monoxide (CO) concentration is given in part 23, § 23.831(a): carbon monoxide concentration may not exceed one part in 20,000 parts of air.
Tests to verify compliance with part 23, § 23.831(a) are done as part of the original type certification of an aircraft. This is done when a modification that has a possible effect on the compliance to part 23, § 23.831(a) is made and when Co is verified or suspected in operation.
Two acceptable methods of detecting carbon monoxide are given in AC 20-32B. These are acceptable either for a TC applicant, an STC applicant, a parts manufacturer approval applicant, an FAA field approval applicant, or an owner/operator. Other methods of verifying compliance to part 23, § 23.831(a) can be used if they are shown to provide acceptable results.
Amendment 23-34 and Subsequent
The source for this revision is shown by NPRM 83-17 as “Part 135, Appendix A, section 60, and SFAR No. 41, section 4(c)(3), which incorporates § 25.831(d) by reference”. For pressurized commuter category airplanes, if hazardous accumulations of smoke are found to be reasonably probable in the cockpit area, smoke evacuation to a non-hazardous level should be readily accomplished from full pressurization to minimum safe levels (per 14 CFR, part 91, § 91.211). Smoke evacuation procedures should be included in the AFM, Emergency or Non-Normal (Abnormal) Procedures Section, or on approved placards.
1. What is the acceptable level of smoke, in the cockpit, as a result from this type of test?
The test to show compliance to § 23.831(b) is for "all" fires that are possible not just engine fires. Conservatism requires the test begin with smoke sufficient to obscure the instrument panel. The plane must remove this smoke without depressurizing the plane below safe limits per § 23.831(b).
2. What is the acceptable level of toxicity of the smoke?
FAA has a requirement for carbon monoxide in § 23.831(a), but no other material.
The applicant must determine what combustion by-products will be generated from the reasonably probable failure of an engine fire in a reciprocating engine.
3. Three minutes or five minutes for clearing smoke from the cockpit?
The three-minute period is acceptable not to remove all smoke but to permit the pilot to safely fly the plane (see the flight instruments).
4. What does "readily accomplished" mean?
This rule came from part 135, Appendix A, which was based on § 25.831(d). It means the flight crew can easily activate the depressurization system while seated and belted in the cockpit. In a single pilot airplane, this means from the left seat.
5 What does "without depressurizing beyond safe limits," mean?
The source for this rule was the same as question 4. Part 91 specifies that a flight crew can operate at 14,000 feet cabin pressure for 30 minutes. This is the maximum level the plane can be depressurized without supplemental oxygen for operation above 14,000 feet for more than 30 minutes. However, applicants can use Time of Useful Consciousness for an emergency descent as in a pressurization failure. They must allow time for the cockpit to clear of smoke sufficiently for the flight crew to safely begin the descent to 14,000 feet or below.
6. Can the smoke evacuation test be done on the ground?
Yes, a ground test is acceptable IF the applicant can clearly show that all relevant test boundary conditions match the respective flight conditions (such as airflows, and pressure fields.). If an applicant elects to have a cabin altitude limiter, the ground test must be conducted at or above the setting of the limiter (example: test site above 14,000 feet Mean Seal Level (MSL), if the limiter is set at 14,000), otherwise no.
7. Can the applicant assume an emergency descent?
For answer 1, the smoke must obscure the panel. An emergency descent cannot be started until the smoke evacuation takes effect.
Amendment 23-42 and Subsequent
This amendment makes paragraph (b) and the policy under Amendments 23-34 and subsequent applicable to all part 23 pressurized airplanes, not just commuter category.
AC 25-9A, “Smoke Detection, Penetration, and Evacuation Tests and Related Flight Manual Emergency Procedures,” dated January 6, 1994, provides an acceptable means of compliance for the smoke evacuation requirements of this section.
PRESSURIZATION
23.841 Pressurized cabins
The corresponding rules in CAR 3 are CAR 3.394 and 3.395.
There is no corresponding rule in the Airship Design Criteria.
Original Issue and Subsequent
Paragraph (c) in § 23.841 requires there be a means to rapidly equalize the pressure differential. Assuming isothermal conditions, the time for the pressures to equalize depends on the cabin volume, the effective area of the safety-dump valves, the cabin inflow, and the pressures inside and outside the cabin. If the size of the effective area of the valve is small in comparison to the cabin volume, the rate of pressure change may be too slow to equalize the pressures before an adverse event could occur. The time period to rapidly equalize the pressures should consider maximum certificated cabin pressure differential, operation of the pressurization system, and either operation of the emergency exits or the cabin entrance doors, or both. When landing the airplane under emergency conditions, the safety-dump valve should have sufficient flow capacity to rapidly equalize the cabin pressure within a time period so the cabin doors and emergency exits can be opened and evacuation is not impaired.
Time to equalize the ambient and cabin pressures should be shown. Inflatable door seals, if installed, are subject to the requirements of this rule.
Paragraph (f) of § 23.841 requires a warning device for safe or preset pressure differential and absolute cabin pressure. A warning is interpreted to suggest the need for an immediate corrective action, so it may not operate unless there is a failure, and the visual indication should be red per § 23.1322. Red lines on altimeters or pressure indicators are used to indicate operating limits, but they are not acceptable warning means.
Amendment 23-7 and Subsequent This amendment changed the warning requirements in paragraph (f). The explanation in NPRM 67-14 states as follows: “Present Sec. 23.841 (f) does not describe what pressure warning devices are acceptable. This proposal would follow the approach of Sec. 25.841 (b) (6), that is, that instrument markings are sufficient for safe warning of pressure differential limits, whereas aural or visual means are necessary for safe warning of absolute pressure limits.” The Final Rule, Docket 8083, added the following: “The proposed requirement permits the use of markings on the presently required pressure differential indicator as the warning indicator.”