5/18/2009 866 component. The figure should be revised to show that the forehead is the initial point of contact, not the nose.
5/18/2009 867 APPENDIX 14 FAA POLICY MEMO ANM-115-05-001, “POLICY STATEMENT ON THE INSTALLATION OF “NO STOWAGE” PLACARDS ON SURFACES NOT DESIGNED OR INTENDED TO
BE USED FOR STOWAGE
5/18/2009 868 Memorandum U.S. Department of Transportation Federal Aviation Administration
S ubject: INFORMATION: Policy Statement on the Installation of “No Stowage” Placards on Surfaces Not Designed or Intended To Be Used for Stowage
Date: October 28, 2004
From: Acting Manager, Transport Airplane Directorate, Aircraft Certification Service, ANM-100 Reply to ANM-115-05- Attn. of: 001
To: Refer to Distribution Regulatory §§ 25.787, Reference: 25.789
Summary The purpose of this memorandum is to provide Federal Aviation Administration (FAA) certification policy with respect to the installation of “No Stowage” placards on surfaces that are not designed or intended to be used for stowage.
Current Regulatory and Advisory Material Section 25.787 provides design requirements for stowage compartments to prevent items stowed in these compartments from dislodging under specific load conditions and striking airplane occupants. Section 25.789 provides protection against a similar hazard by requiring means of retention for items of mass which are on the airplane type design.
Sections 25.787(a) and (b) states the following:
(a) Each compartment for the stowage of cargo, baggage, carry- on articles, and equipment (such as life rafts), and any other stowage compartment must be designed for its placarded maximum weight of contents and for the critical load distribution at the appropriate maximum load factors corresponding to the specified flight and ground load conditions, and to the emergency landing conditions of Sec. 25.561(b), except that the forces specified in the emergency landing conditions need not be applied to compartments located below, or forward, of all occupants in the airplane. If the airplane has a passenger seating configuration, excluding pilot’s seats, of 10 seats or more, each stowage compartment in the passenger cabin, except for underseat and overhead compartments for passenger convenience, must be completely enclosed.
5/18/2009 869
(b) There must be a means to prevent the contents in the compartments from becoming a hazard by shifting, under the loads specified in paragraph (a) of this section. For stowage compartments in the passenger and crew cabin, if the means used is a latched door, the design must take into consideration the wear and deterioration expected in service.
Section 25.789 states the following:
(a) Means must be provided to prevent each item of mass (that is part of the airplane type design) in a passenger or crew compartment or galley from becoming a hazard by shifting under the appropriate maximum load factors corresponding to the specified flight and ground load conditions, and to the emergency landing conditions of Sec. 25.561(b).
(b) Each interphone restraint system must be designed so that when subjected to the load factors specified in Sec. 25.561(b)(3), the interphone will remain in its stowed position.
Policy It has been brought to the attention of the Transport Airplane Directorate, Transport Standards Staff that an aircraft certification office has, in some instances, required an applicant to install “No Stowage” or “No Stowage During Taxi, Takeoff and Landing” placards on some surfaces that were not designed or intended to be used for stowage.
Although not designed for stowage, these surfaces could, because of their shapes and locations, accommodate the placement of articles upon them. Examples of such surfaces are table tops, side wall ledges, and thick bumpers installed in galley cart parking bays.
The placards were intended to address a concern that carry-on or other articles, not on the airplane type design, could be inappropriately stowed there and, in case of an accident or severe turbulence become injurious projectiles. The Staff has investigated this practice and determined that the part 25 regulations relating to the stowage of cargo, baggage, carry-on articles, and equipment do not require the installation of these placards for surfaces such as these. Therefore, while an applicant may be encouraged to install such placards, they cannot be required to install the placards to address this specific issue.
This policy memorandum is meant to address surfaces that are clearly not intended to be stowage compartments. Areas that are intended to be stowage compartments must meet the requirements of § 25.787.
Note that FAA operational regulations (e.g., §§ 121.576, 121.577, 121.589) require the stowage of carry-on baggage and other items during phases of flight where when they could become a hazard. Flight attendants typically prepare the cabin during taxi, takeoff, and landing to address this issue.
5/18/2009 870 Effect of Policy The general policy stated in this document does not constitute a new regulation or create what the courts refer to as a "binding norm". The office that implements policy should follow this policy when applicable to the specific project. Whenever an applicant's proposed method of compliance is outside this established policy, it must be coordinated with the policy issuing office, e.g., through the issue paper process or equivalent.
Similarly, if the implementing office becomes aware of reasons that an applicant’s proposal that meets this policy should not be approved, the office must coordinate its response with the policy issuing office.
Applicants should expect that the certificating officials will consider this information when making findings of compliance relevant to new certificate actions. Also, as with all advisory material, this policy statement identifies one means, but not the only means, of compliance.
/s/ Kalene C. Yanamura
5/18/2009 871 DISTRIBUTION:
Manager, Aircraft Engineering Division, AIR-100 Manager, Boston Aircraft Certification Office, ANE-150 Manager, New York Aircraft Certification Office, ANE-170 Manager, Ft. Worth Airplane Certification Office, ASW-150 Manager, Ft. Worth Special Certification Office, ASW-190 Manager, Atlanta Aircraft Certification Office, ACE-115A Manager, Wichita Aircraft Certification Office, ACE-115W Manager, Chicago Aircraft Certification Office, ACE-115C Manager, Anchorage Airplane Certification Office, ACE-115N Manager, Seattle Aircraft Certification Office, ANM-100S Manager, Los Angeles Aircraft Certification Office, ANM-100L Manager, Denver Airplane Certification Office, ANM-100D Manager, Brussels Aircraft Certification Office, AEU-100 Manager, Small Airplane Directorate, ACE-100 Manager, Rotorcraft Directorate, ASW-100, Manager, Engine and Propeller Directorate, ANE-100
5/18/2009 872
THIS PAGE INTENTIONALLY LEFT BLANK
5/18/2009 873 APPENDIX 15
FIGURES SHOWING REQUIRED AISLES, CROSS AISLES, AND PASSAGEWAYS FOR
TYPE A AND B EXITS
5/18/2009 Figure 1 Mid-cabin without cross aisle
- 36 0000 20" Main Aisle Figure 2 Mid-cabin with cross aisle and irregular passageway and aisle 36" Passageway 20" Cross Aisle 874
5/18/2009 Figure 3 Mid-cabin with cross aisle Figure 4 End of the cabin with cross 20" Main Aisle aisle 36° Passageway 20" Cross Aisle 875
5/18/2009 Figure 5 Mid-cabin with no cross aisle 20" Main Aisle Figure 6 Mid-cabin with cross aisle 36" Passageway 20" Cross Aisle 876
Advisory Circular Feedback If you find an error in this AC, have recommendations for improving it, or have suggestions for new items/subjects to be added, you may let us know by (1) emailing this form to 9-AWA-AVS- AIR500-Coord@faa.gov or (2) faxing it to the attention of the Aircraft Certification Service Directives Management Officer at (202) 267-3983.
Subject: Date:
Please check all appropriate line items:
An error (procedural or typographical) has been noted in paragraph on page .
Recommend paragraph on page be c hanged as follows:
In a future change to this AC, please cover the following subject:
(Briefly describe what you want added.)
Other comments:
I would like to discuss the above. Please contact me.
Submitted by: Date: