AC NO: 20-99 DATE: S/27/77
ADVISORY
CIRCULAR
DEPARTMENT OF TRANSPORTATION
FEDERAL AVIATION ADMINISTRATION SUBJECT: ANTISKID AND ASSOCIATED SYSTEMS
1. PURPOSE. This circular sets forth an acceptable means but not the only means of complying with the requirement that antiskid and associated systems mu.st be designed so that no probable malfunction will result in a hazardous loss of brald.ng or directional control of airplane.
2. REJULATIONS AFFECTED. FAR 25.735(e).
3. BACKGROUND. There have been accidents wherein nultiple loss of tires has resulted in loss of braking ability and directional control of the airplane. One such condition of brald..ng loss can occur on airplanes which have antisld.d systems utilizing locked wheel protection circuits.
The circuits compare one wheel's rotational speed with another one or more on the same and/or another gear to determine a locked wheel condition.
The locked wheel protection feature is designed to prevent tire !lat spotting and tire blowouts when braJd.ng on wet or icy ru.nw~s. When the ratio of one wheel's speed compared to another as noted is less than a predetermined min/max value, brakeS' will be released on the low speed wheel. If a wheel continues to roll after losing its tires and rim nanges, as during a momentary unbraked airplane roll condition, its rotational speed versus the speed of other wheels being compared could equal a ratio indicative of a locked wheel(s) elsewhere. This would result in the locked wheel protection circuits preventing application of brake pressure to the compared and still functionally satisfactory wheel/tire position, thus further reducing brald..ng capability.
4. ACCEPTABLE MEANS OF COMPLIANCE.
a. A failure mode and effect analysis provide an acceptable method of complying with FAR 25.735(e). 'lhe analysis should provide for failures of the antiskid and associated systems (tires, wheels, brakes, etc.) and effects on airplane safety and braki.ng performance.
Initiated by: AFS-120
5/27/77A0-20-99
b. The analysis of antiekid systems utilizing locked wheel protection circuits should include a detennination assuring that mechanical faults such as blown tires, broken wheel rims, etc., cannot signifi cantly reduce the braking effectiveness of cross coupled wheels with intact tires.
~: A tire or wheel failure that results in the loss of additional tires or wheels from overload, resulting from the initial failure, should be considered a single failure.
!J_( R. P. SKULLY Director, Flight tandards Service Page 2