Airworthiness concern sheet · Control Wheel Shafts

Issued
April 16, 2009
Products
Aircraft · Small Airplane
Makes
Piper
Models
PA-28 (All), PA-32 (All), PA-34 (All), PA-44 (All
ADs it names
AD2010-15-10

The FAA issues concern sheets to gather information before deciding whether an AD is needed. Only some are in DRS.

The concern sheet

Text extracted from the PDF.

Revised 1/24/02 Airworthiness Concern Sheet

Full Name Hector Hernandez Title Aerospace Engineer Organization FAA Department Atlanta Aircraft Certification Office Address 1895 Phoenix B’lvd City State ZIP Atlanta, GA 30349 Telephone Number (770) 703-6069 E-mail Hector.Hernandez@FAA.GOV Make, Model, Series, Serial No.:

Piper PA-28 (All Models) Piper PA-34 (All Models) Piper PA-32 (All Models) Piper PA-44 (All Models) (For further information, please refer to Piper SB 1197.)

Reason for Airworthiness Concern:

Loss of control wheel due to misdrilling of attachment hole may lead to separation of the control wheel shaft, resulting in loss of pitch and roll control.

Date: April 16, 2009 FAA Description of Airworthiness Concern (Who, What, Where, When, How? Attachments: RA and appropriate data) There have been two field reports of incorrectly assembled control wheel shafts, which if not corrected may lead to loss of pitch and roll control. The first report was an incident that occurred on March 24, 2008, concerning the loss of control wheel on a Piper Model PA-34-220T airplane (Total hours: 1196, Manufacturing date: 2001). During a check ride the right-hand control wheel shaft and universal joint had separated due to misdrilled hole for the threaded taper pin. The second report was on April, 2008, regarding a ground inspection on a Piper Model PA-34-220Tairplane (Total hours: Unknown, Manufacturing date: 2007), which revealed a similar situation between the control wheel shaft and the universal joint in left-hand side. Based on a visual examination of the inspection hole the shaft may not be engaged sufficiently.

The investigation revealed that the control wheel shafts had been incorrectly-assembled and holes were misdrilled in such a manner which may appear visually to be acceptable. The hole in the shaft may be too close to the end of the shaft, causing a significant reduction in joint strength. This condition may lead to separation of the control wheel shaft, resulting in loss of pitch and roll control.

Request for Information (Proposed Alternate Inspection/Repair Procedures, Cost Impact, Etc. Note: Any comments or replies to the FAA need to be as specific as possible. Please provide specific examples to illustrate your comments/concerns.):

We are soliciting additional information from Associations and Type Club in accordance with the Small Airplane Directorate AD Manual Supplement. Any additional information such as service problems, proposed alternate inspection/repair procedures, cost impact, etc., should be returned in writing to the FAA (address listed above). The requested information will be used to determine if any airworthiness action is warranted and what that action should be. All owners/operators are requested to provide input on this matter.

Attachments: *SDR(s) *A/IDS *SL(s) *SAIB *FAASR/*NTSBSR *AD *AMOC *RA

Notification: FAA *AOPA *EAA Type Club *TC Holder O t h e r :

Response Date Requested 05/29/2009: Emergency (10 days) Alert (30 days) Information (90 days) (Space Bar Adds “X” to Check Boxes) *Service Difficulty Reports (SDRs); Accident/Incident Data System (A/IDS); Service Letter (SL); Special Airworthiness Information Bulletin (SAIB);

Federal Aviation Administration (FAA)/National Transportation Safety Board (NTSB) Safety Recommendation (FAASR/NTSBSR); Airworthiness Directive (AD); Alternate Method of Compliance (AMOC); Risk Assessment (RA); Aircraft Owners & Pilots Association (AOPA);

Experimental Aircraft Association (EAA); Type Certificate (TC) This Airworthiness Concern Sheet (ACS) is intended as a means for FAA Aviation Safety Engineers to coordinate airworthiness concerns with aircraft owner/operators through associations and type clubs. At this time, the FAA has not made a determination on what type of corrective action (if any) should be taken. The resolution of this airworthiness concern could involve an AD action or an SAIB, or the FAA could determine that no action is needed at this time. The FAA’s final determination will depend in part on the information received in response to this ACS.

The FAA endorses dissemination of this technical information to all manufacturers and requests association and type clubs comments.

Service documents this concern sheet cites · 1

Manufacturers’ service documents named in its text, as OpenAirDocs read them: check each against the text. “Copy” marks those OpenAirDocs holds.

Query with SQL
duckdb -csv -c "SELECT d.issuer, d.type_label, d.number, c.revision, c.revision_date, c.cited_as, c.incorporated_by_reference, c.in_regulatory_text,
    'https://openairdocs.org/service-documents/' || d.document_id AS page_url
  FROM 'https://openairdocs.org/data/latest/service_document_citation.parquet' c JOIN 'https://openairdocs.org/data/latest/service_document.parquet' d USING (document_id)
  WHERE c.record_type = 'faa_concern_sheet' AND c.record_id IN ('FAA00000000000ACS_750200905S2700') AND d.issuer_kind <> 'authority'
  QUALIFY row_number() OVER (PARTITION BY c.document_id, c.revision_key ORDER BY c.record_date DESC) = 1
  ORDER BY c.incorporated_by_reference DESC, c.in_regulatory_text DESC, d.document_id, c.revision_key"

Prints the whole list as CSV. It reads the release’s Parquet files over HTTPS, so there’s nothing to download first. Install DuckDB to run it.