AD 2000-12-15

Applicability: All Model Falcon 2000, Mystere-Falcon 900, Falcon 900EX, Fan Jet Falcon, Mystere-Falcon 50, Mystere-Falcon 20, Mystere-Falcon 200, and Falcon 10 series airplanes; certificated in any category.

Note 1:

This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously.

To prevent failure of the overwing emergency exits to open, and consequent injury to passengers or crew members during an emergency evacuation, accomplish the following:

(a) Within 30 days after the effective date of this AD, perform an operational test and detailed visual inspection of the overwing emergency exit from inside the cabin to detect discrepancies (including separation, tearing, wearing, arcing, cracking) in the areas and components listed in Chapter 5 (ATA Code 52) of the applicable airplane maintenance manual (AMM). Accomplish the actions in accordance with the applicable AMM. If any discrepancy is detected during any test or inspection required by this paragraph, prior to further flight, repair in accordance with Chapter 5 (ATA Code 52) of the applicable AMM. Repeat the operational test and inspection thereafter at intervals not to exceed 13 months.

Note 2:

For the purposes of this AD, a detailed visual inspection is defined as: “An intensive visual examination of a specific structural area, system, installation, or assembly to detect damage, failure, or irregularity. Available lighting is normally supplemented with a direct source of good lighting at intensity deemed appropriate by the inspector. Inspection aids such as mirror, magnifying lenses, etc., may be used. Surface cleaning and elaborate access procedures may be required.”

(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.

Note 3:

Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.

(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

Note 4:

The subject of this AD is addressed in French airworthiness directives 1999-213-025(B), 1999-212-024(B), 1999-211-023(B), and 1999-210-009(B); all dated May 19, 1999.

(d) This amendment becomes effective on July 20, 2000.