AD 2000-26-03

Airworthiness directive · Power Unit (APU) Fire · Airbus A300 B4-601, A300 B4-603, A300 B4-605R and 12 more

Effective
February 1, 2001
Published
December 28, 2000 · 65 FR 82262–82263
Issued
January 8, 2001
Supersedes
AD99-27-10
Models
A300 B4-601, A300 B4-603, A300 B4-605R, A300 B4-620, A300 B4-622, A300 B4-622R and 9 more
Data sheet
TCDSA35EU
Registered aircraft
124 matched by model
Product
Aircraft · Large airplane
Amendment
39-12052
Docket
2000-NM-48-AD
Issued as
Final rule

Unofficial copy from the Federal Register XML, document 00-32762. Only the govinfo PDF is the legal edition. DRS record last changed May 30, 2024.

On this page

Summary

This amendment supersedes an existing airworthiness directive (AD), applicable to certain Airbus Model A300 B2 and B4 and A300-600 series airplanes, that currently requires wiring modifications to the engine and auxiliary power unit (APU) fire detection system. This amendment requires new wiring modifications for the engine and APU fire detection system. This amendment is prompted by issuance of mandatory continuing airworthiness information by a foreign civil airworthiness authority. The actions specified by this AD are intended to prevent the fire warning from terminating prematurely, which could result in an unnoticed, uncontained engine/APU fire.

The airworthiness directive

2000-26-03 Airbus Industrie: Amendment 39-12052. Docket 2000-NM-48-AD. Supersedes AD 99-27-10, Amendment 39-11491.

Applicability: Model A300 B2 and B4 series airplanes, and Model A300 B4-600, A300 B4-600R, and A300 F4-600R (A300-600) series airplanes, certificated in any category; except those on which Airbus Modifications 06267 and 07340 have been accomplished during production.

Note 1:

This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been otherwise modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b)(1) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously.

To prevent the fire warning from terminating prematurely, which could result in an unnoticed, uncontained engine/auxiliary power unit (APU) fire, accomplish the following:

(a) Modifications

PDF page 2

(a) Within 12 months after the effective date of this AD, accomplish the wiring modifications for the engine and APU fire detection system in accordance with Airbus Service Bulletin A300-26-6038, Revision 03, dated March 30, 2000 (for Model A300-600 series airplanes); or A310-26-2024, Revision 06, dated March 31, 2000 (for Model A310 series airplanes); as applicable.

Note 2:

Accomplishment of the wiring modifications prior to the effective date of this AD in accordance with Airbus Service Bulletin A300-26-6038, Revision 02, dated November 9, 1999, is considered acceptable for compliance with the applicable actions specified in this AD.

(b) Alternative Method of Compliance

PDF page 2

(b)(1) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.

(2) Alternative methods of compliance, approved previously in accordance with AD 99-27-10, are approved as alternative methods of compliance with paragraph (a) of this AD.

Note 3:

Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.

(c) Special Flight Permits

PDF page 2

(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

(d) Incorporation by Reference

PDF page 2

(d) The wiring modifications shall be done in accordance with Airbus Service Bulletin A300-26-6038, Revision 03, dated March 30, 2000; or Airbus Service Bulletin A310-26-2024, Revision 06, dated March 31, 2000; as applicable. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Note 4:

The subject of this AD is addressed in French airworthiness directive 1999-238-286(B) R2, dated May 17, 2000.

(e) Effective Date

PDF page 2

(e) This amendment becomes effective on February 1, 2001.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

DatesPage 1

Effective February 1, 2001.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of February 1, 2001.

AddressesPage 1

The service information referenced in this AD may be obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

For further information contactPage 1

Norman B. Martenson, Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2110; fax (425) 227-1149.

Supplementary informationPage 1

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) by superseding AD 99-27-10, amendment 39-11491 (65 FR 204, January 4, 2000), which is applicable to certain Airbus Model A310 and A300-600 series airplanes, was published in the Federal Register on August 2, 2000 (65 FR 47356). The action proposed to require new wiring modifications to the engine and auxiliary power unit (APU) fire detection system.

Clarification of Model DesignationPage 1

Since the issuance of the proposed AD, the FAA has changed the manner in which it identifies the airplane models referred to as “Airbus Model A300 and A300-600 series airplanes” to reflect the model designation specified on the type certificate data sheet. This final rule has been revised to show the appropriate model designations for those airplanes.

CommentsPage 1

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

ConclusionPage 1

The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Cost impactPage 1

There are approximately 113 Model A300 B2 and B4 and A300-600 series airplanes of U.S. registry that will be affected by this AD.

The actions required by this AD will take approximately 26 work hours per airplane to accomplish, at an average labor rate of $60 per work hour. Required parts will cost approximately $484 per airplane. Based on these figures, the cost impact of the requirements of this AD on U.S. operators is estimated to be $230,972, or $2,044 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory impactPage 1

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

Adoption of the amendmentPage 1

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

1. The authority citation for part 39 continues to read as follows:

2. Section 39.13 is amended by removing amendment 39-11491 (65 FR 204, January 4, 2000), and by adding a new airworthiness directive (AD), amendment 39-12052, to read as follows:

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 124

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Airbus Industrie76 aircraft
  • Airbus48 aircraft
By year built
19832007
Registered aircraft by year built: 122 aircraft
19832
19841
19851
19871
19881
19893
19905
19913
19927
19935
19945
19958
19965
19975
19986
19996
20007
200111
20026
20038
20047
20057
20066
20076

2 with no year recorded

By model

Aircraft

See all 124 aircraft