AD 2004-03-21

Airworthiness directive · Inboard Ends of Outer Skin Panels of Horizontal Stabilizer at Station Xh=7.234 · Boeing 717-200

Effective
March 17, 2004
Published
February 11, 2004 · 69 FR 6532–6533
Issued
January 30, 2004
Model
717-200
Data sheet
TCDSA6WE
Registered aircraft
111 matched by model
Product
Aircraft · Large airplane
Amendment
39-13465
Docket
2002-NM-213-AD
Issued as
Final rule

Unofficial copy from the Federal Register XML, document 04-2581. Only the govinfo PDF is the legal edition. DRS record last changed May 30, 2024.

On this page

Summary

This amendment adopts a new airworthiness directive (AD), applicable to certain McDonnell Douglas Model 717-200 airplanes, that requires inspection of the inboard ends of the outer skin panels of the horizontal stabilizer at Station Xh=±7.234 for material defects, and corrective action, if necessary. This action is necessary to detect material defects in the inboard ends of the outer skin panels of the horizontal stabilizer, which could lead to cracks and an associated loss of strength in the attachments, and consequent reduced structural integrity of the horizontal stabilizer. This action is intended to address the identified unsafe condition.

The airworthiness directive

2004-03-21 McDonnell Douglas: Amendment 39-13465. Docket 2002-NM-213-AD.

Applicability: Model 717-200 airplanes, as listed in Boeing Service Bulletin 717-55-0005, dated June 27, 2002; certificated in any category.

Compliance: Required as indicated, unless accomplished previously.

To detect material defects in the inboard ends of the outer skin panels of the horizontal stabilizer at Station Xh=±7.234, which could lead to cracks and an associated loss of strength in the attachments, and consequent reduced structural integrity of the horizontal stabilizer, accomplish the following:

(a) Inspection

PDF page 2

(a) Prior to the accumulation of 10,000 total flight cycles, or within 15 months after the effective date of this AD, whichever occurs later, do an ultrasonic inspection of the inboard ends of the outer skin panels of the horizontal stabilizer at Station Xh=±7.234 for material defects, per the Accomplishment Instructions of Boeing Service Bulletin 717-55-0005, dated June 27, 2002.

(b) Corrective Action

PDF page 2

(b) If any defects are found during the inspection required by paragraph (a) of this AD, and the service bulletin specifies contacting Boeing for appropriate action: Before further flight, repair per a method approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA; or per data meeting the type certification basis of the airplane approved by a Boeing Company Designated Engineering Representative who has been authorized by the Manager, Los Angeles ACO, to make such findings. For a repair method to be approved, as required by this paragraph, the approval letter must specifically refer to this AD.

(c) Alternative Methods of Compliance

PDF page 2

(c) In accordance with 14 CFR 39.19, the Manager, Los Angeles ACO, FAA, is authorized to approve alternative methods of compliance for this AD.

(d) Incorporation by Reference

PDF page 2

(d) Unless otherwise specified in this AD, the actions shall be done in accordance with Boeing Service Bulletin 717-55-0005, dated June 27, 2002. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Boeing Commercial Airplanes, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data and Service Management, Dept. C1-L5A (D800-0024). Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

(e) Effective Date

PDF page 2

(e) This amendment becomes effective on March 17, 2004.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

DatesPage 1

Effective March 17, 2004.

The incorporation by reference of a certain publication listed in the regulations is approved by the Director of the Federal Register as of March 17, 2004.

AddressesPage 1

The service information referenced in this AD may be obtained from Boeing Commercial Airplanes, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data and Service Management, Dept. C1-L5A (D800-0024). This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

For further information contactPage 1

Maureen Moreland, Aerospace Engineer, Airframe Branch, ANM-120L, FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5238; fax (562) 627-5210.

Supplementary informationPage 1

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain McDonnell Douglas Model 717-200 airplanes was published in the Federal Register on September 18, 2003 (68 FR 54690). That action proposed to require inspection of the inboard ends of the outer skin panels of the horizontal stabilizer at Station Xh=±7.234 for material defects, and corrective action, if necessary.

CommentsPage 1

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

ConclusionPage 1

The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Cost impactPage 1

There are approximately 56 airplanes of the affected design in the worldwide fleet. The FAA estimates that 41 airplanes of U.S. registry will be affected by this AD, that it will take approximately 4 work hours per airplane to accomplish the required inspection, and that the average labor rate is $65 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $10,660, or $260 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions. Manufacturer warranty remedies may be available for labor costs associated with this proposed AD. As a result, the costs attributable to the proposed AD may be less than stated above.

Regulatory impactPage 2

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

Adoption of the amendmentPage 2

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

1. The authority citation for part 39 continues to read as follows:

2. Section 39.13 is amended by adding the following new airworthiness directive:

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 111

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Boeing111 aircraft
By year built
19982006
Registered aircraft by year built: 98 aircraft
19982
199910
200023
200132
200215
20031
20048
20055
20062

13 with no year recorded

By model

Aircraft

See all 111 aircraft