AD 2004-22-10

This AD becomes effective December 7, 2004.

The incorporation by reference of certain publications listed in the AD is approved by the Director of the Federal Register as of December 7, 2004.

For service information identified in this AD, contact Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124-2207. You can examine this information at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.

You can examine the contents of this AD docket on the Internet at http://dms.dot.gov, or at the Docket Management Facility, U.S. Department of Transportation, 400 Seventh Street, SW., room PL-401, on the plaza level of the Nassif Building, Washington, DC.

Technical information: Ivan Li, Airframe Branch, ANM-120S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 917-6437; fax (425) 917-6590.

Plain language information: Marcia Walters, marcia.walters@faa.gov.

The AD docket contains the proposed AD, comments, and any final disposition. You can examine the AD docket on the Internet at http://dms.dot.gov, or in person at the Docket Management Facility office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Management Facility office (telephone (800) 647-5227) is located on the plaza level of the Nassif Building at the DOT street address stated in the ADDRESSES section.

The FAA proposed to amend 14 CFR part 39 with an AD for certain Boeing Model 747-400 and “400F series airplanes. That action, published in the Federal Register on August 6, 2004 (69 FR 47811), proposed to require a detailed inspection(s) for cracks and fractures of the side guide support fittings in the lower lobe cargo compartments; and applicable investigative/corrective actions and operational limitations, if necessary. That action also proposed to require a terminating action for the repetitive inspections.

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

There are about 22 airplanes of the affected design worldwide. The following table provides the estimated costs for U.S. operators to comply with this AD.

We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866;

(2) Is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD. See the ADDRESSES section for a location to examine the regulatory evaluation.

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

1. The authority citation for part 39 continues to read as follows:

2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):