Airworthiness directive · Center fuel tank · Airbus A320-111, A320-211, A320-212 and 4 more

Effective
December 22, 2005
Published
December 22, 2005 · 70 FR 75932–75933
Issued
December 8, 2005
Supersedes
AD2005-19-16
Models
A320-111, A320-211, A320-212, A320-214, A320-231, A320-232, A320-233
Data sheet
TCDSA28NM
Registered aircraft
564 matched by model
Product
Aircraft · Large airplane
Amendment
39-14429
Docket
FAA-2005-23400
Project
2005-NM-217-AD
Issued as
Final rule; rescission

Unofficial copy from the Federal Register XML, document 05-24343. Only the govinfo PDF is the legal edition. DRS record last changed May 30, 2024.

On this page

Summary

This amendment rescinds Airworthiness Directive (AD) 2005-19-16, which is applicable to certain Airbus Model A320-111, -211, -212, -214, -231, -232, and -233 airplanes. That AD requires installing a bonding strip between each of the two water scavenge jet pumps of the center fuel tank and the rear spar in section 21. That AD resulted from fuel system reviews conducted by the manufacturer. The requirements of that AD were intended to prevent an ignition source for fuel vapor in the wing, which could result in fire or explosion in the center wing fuel tank. Since the issuance of that AD, the FAA has determined that the procedures specified in the service bulletin and French AD referenced in that AD would result in duplicate actions.

Effective Date: December 22, 2005.

The airworthiness directive

2005-19-16 R1 Airbus: Amendment 39-14429. FAA-2005-23400; Directorate Identifier 2005-NM-217-AD.

(a) Effective Date

PDF page 2

(a) This AD becomes effective December 22, 2005.

(b) Affected ADs

PDF page 2

(b) This action rescinds AD 2005-19-16.

(c) Applicability

PDF page 2

(c) This action applies to Airbus Model A320-111, -211, -212, -214, -231, -232, and -233 airplanes, certificated in any category; except those airplanes on which Airbus Modification 25513 has been accomplished in production.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

AddressesPage 1

You can examine the contents of this AD docket on the Internet at http://dms.dot.gov, or at the Docket Management Facility, U.S. Department of Transportation, 400 Seventh Street, SW., room PL-401, on the plaza level of the Nassif Building, Washington, DC.

For further information contactPage 1

Dan Rodina, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2125; fax (425) 227-1149.

Supplementary informationPage 1

On September 9, 2005, the Federal Aviation Administration (FAA) issued Airworthiness Directive (AD) 2005-19-16, amendment 39-14281 (70 FR 55233, September 21, 2005), applicable to certain Model A320-111, -211, -212, -214, -231, -232, and -233 airplanes. That AD requires installing a bonding strip between each of the two water scavenge jet pumps of the center fuel tank and the rear spar in section 21. That action resulted from fuel system reviews conducted by the manufacturer. The actions required by that AD are intended to prevent an ignition source for fuel vapor in the center wing fuel tank. That condition, if not corrected, could result in fire or explosion in the center wing fuel tank.

Actions Since Issuance of Previous ADPage 2

Since the issuance of that AD, Airbus notified the Direction Générale de l'Aviation Civile (DGAC), which is the airworthiness authority for France, and informed us that it had issued Service Bulletin A320-28-1104, dated December 2, 2003; Revision 01 dated December 8, 2004; and Revision 02 dated February 21, 2005. That service bulletin has been mandated by the European Aviation Safety Authority (EASA) AD F-2005-028 and FAA AD 2005-19-14. That service bulletin specifies inspections and the restoring of electrical bonding integrity in the center tank, including the bonding addressed by Airbus Service Bulletin A320-28-1067, Revision 02, dated January 27, 1997. Airbus states that Service Bulletin A320-28-1067, Revision 02, the service bulletin cited in AD 2005-19-16, is no longer required due to the issuance of Service Bulletin A320-28-1104, original version; Revision 01; and Revision 02. Accordingly, the DGAC canceled French AD F-2005-056 by issuing AD F-2005-056 R1 on September 28, 2005.

FAA's DeterminationPage 2

Since the issuance of AD 2005-19-16, we have determined that it is necessary to rescind that AD in order to prevent operators from performing unnecessary actions.

Since this action rescinds a requirement to perform an unnecessary action, it has no adverse economic impact and imposes no additional burden on any person. Therefore, notice and public procedures hereon are unnecessary and the rescission may be made effective upon publication in the Federal Register.

Adoption of the amendmentPage 2

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

1. The authority citation for part 39 continues to read as follows:

2. Section 39.13 is amended by adding an AD which removes amendment 39-14281, to read as follows:

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 564

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Airbus377 aircraft
  • Airbus Industrie184 aircraft
  • Airbus S A S3 aircraft
By year built
19912019
Registered aircraft by year built: 525 aircraft
19913
199213
19938
19941
19954
19967
19978
199825
199932
200035
200136
200225
200319
200418
200518
200625
200720
200820
200920
201017
201126
201232
201329
201419
201522
201614
201716
201811
20192

39 with no year recorded

By model

Aircraft

See all 564 aircraft