AD 2006-16-20

Airworthiness directive · Elevator control at the stabilizer assembly, placard on the fin, and sailplane flight manual. · DG Flugzeugbau DG-1000S

Effective
September 18, 2006
Published
August 14, 2006 · 71 FR 46393–46395
Issued
August 4, 2006
Model
DG-1000S
Data sheet
TCDSG15CE
Registered aircraft
28 matched by model
Product
Aircraft · Glider
Amendment
39-14720
Docket
FAA-2006-24255
Project
2006-CE-25-AD
Issued as
Final rule

Unofficial copy from the Federal Register XML, document E6-13135. Only the govinfo PDF is the legal edition. DRS record last changed May 30, 2024.

On this page

Summary

We are adopting a new airworthiness directive (AD) for all DG Flugzeugbau GmbH Model DG-1000S sailplanes. This AD requires you to modify the elevator control at the stabilizer assembly, replace a placard on the fin, and incorporate changes in the FAA-approved sailplane flight manual (SFM). This AD results from mandatory continuing airworthiness information (MCAI) issued by the airworthiness authority for Germany. We are issuing this AD to prevent the rigging of the horizontal stabilizer without properly connecting the elevator, which, if not prevented, could lead to an inoperative elevator. An inoperative elevator could lead to loss of control of the sailplane.

The airworthiness directive

2006-16-20 DG Flugzeugbau GMBH: Amendment 39-14720; Docket No. FAA-2006-24255; Directorate Identifier 2006-CE-25-AD.

(a) Effective Date

PDF page 2

(a) This AD becomes effective on September 18, 2006.

(b) Affected ADs

PDF page 2

(b) None.

(c) Applicability

PDF page 2

(c) This AD affects all Model DG-1000S sailplanes, all serial numbers, that are certificated in any category.

(d) Unsafe Condition

PDF page 2

(d) This AD results from mandatory continuing airworthiness information (MCAI) issued by the airworthiness authority for Germany. We are issuing this AD to prevent the rigging of the horizontal stabilizer without properly connecting the elevator, which, if not prevented, could lead to an inoperative elevator. An inoperative elevator could lead to loss of control of the sailplane.

(e) Compliance

PDF page 2

(e) To address this problem, you must do the following:

ActionsComplianceProcedures
(1) Modify the elevator control at the stabilizer assembly as follows: (i) Replace the rod-end, part number (P/N) 5St94 (or FAA-approved equivalent P/N), with a rod-end 5St94 modified to P/N 10St97/1 (or an FAA-approved equivalent P/N); (ii) Install deflector part number 10St97/2 (or an FAA-approved equivalent P/N); and (iii) Replace the placard on the fin.Within the next 25 hours time-in-service (TIS) after September 18, 2006 (the effective date of this AD)Follow DG Flugzeugbau GmbH Technical Note No. 413/3, dated April 28, 2004.
(2) The parts that this AD requires to be replaced as well as those to be installed could have replacement parts approved under 14 CFR 21.303. Any such parts approved per this regulation and installed are subject to the actions of this AD. In addition, nothing in this AD prevents the installation of such alternatively approved parts provided they meet current airworthiness standards including those actions cited in this ADNot ApplicableNot Applicable.
(3) Incorporate changes in the FAA-approved sailplane flight manual, as specified in paragraph 6a) of the Instructions section of DG Flugzeugbau GmbH Technical Note No. 413/3, dated April 28, 2004Within the next 25 hours TIS after the effective date of this ADThe owner/operator holding at least a private pilot certificate as authorized by section 43.7 of the Federal Aviation Regulations (14 CFR 43.7) may do the flight manual change requirement of this AD. Make an entry in the aircraft records showing compliance with this portion of the AD following section 43.9 of the Federal Aviation Regulations (14 CFR 43.9).
(4) Do not install any rod end P/N 5St94 (or FAA-approved equivalent P/N) unless it is modified to DG Flugzeugbau GmbH rod-end P/N 10St97/1 (or FAA-approved equivalent P/N)As of September 18, 2006 (the effective date of this AD)Not Applicable.

(f) Alternative Methods of Compliance (AMOCs)

PDF page 2

(f) The Manager, Standards Office, Small Airplane Directorate, FAA, ATTN: Gregory Davison, Glider Project Manager, ACE-112, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4130; facsimile: (816) 329-4090, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19.

(g) Related Information

PDF page 2

(g) German AD Number D-2004-300, dated June 15, 2004, also addresses the subject of this AD.

(h) Material Incorporated by Reference

PDF page 2

(h) You must do the actions required by this AD following the instructions in DG Flugzeugbau GmbH Technical Note No. 413/3, dated April 28, 2004. The Director of the Federal Register approved the incorporation by reference of this service bulletin in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. To get a copy of this service information, contact DG-Flugzeugbau, Postbox 41 20, D-76625 Bruchsal, Federal Republic of Germany; telephone: ++49 7257 890; facsimile: ++45 7257 8922; e-mail: http://www.dg-flugzeugbau.de. To review copies of this service information, go to the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html or call (202) 741-6030. To view the AD docket, go to the Docket Management Facility; U.S. Department of Transportation, 400 Seventh Street, SW., Nassif Building, Room PL-401, Washington, DC 20590-001 or on the Internet at http://dms.dot.gov. The docket number is FAA-2006-24255; Directorate Identifier 2006-CE-25-AD.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

DatesPage 1

This AD becomes effective on September 18, 2006.

As of September 18, 2006, the Director of the Federal Register approved the incorporation by reference of certain publications listed in the regulation.

AddressesPage 1

For service information identified in this AD, contact DG-Flugzeugbau, Postbox 41 20, D-76625 Bruchsal, Federal Republic of Germany; telephone: ++49 7257 890; facsimile: ++45 7257 8922; e-mail: http://www.dg-flugzeugbau.de.

To view the AD docket, go to the Docket Management Facility; U.S. Department of Transportation, 400 Seventh Street, SW., Nassif Building, Room PL-401, Washington, DC 20590-001 or on the Internet at http://dms.dot.gov. The docket number is FAA-2006-24255; Directorate Identifier 2006-CE-25-AD.

For further information contactPage 1

Gregory Davison, Glider Project Manager, ACE-112, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4130; facsimile: (816) 329-4090.

DiscussionPage 1

On May 9, 2006, we issued a proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an AD that would apply to all DG Flugzeugbau GmbH Model DG-1000S sailplanes. This proposal was published in the Federal Register as a notice of proposed rulemaking (NPRM) on May 16, 2006 (71 FR 28287). The NPRM proposed to require you to modify the elevator control at the stabilizer assembly, replace a placard on the fin, and incorporate changes in the FAA-approved SFM.

CommentsPage 1

We provided the public the opportunity to participate in developing this AD. We received no comments on the proposal or on the determination of the cost to the public.

ConclusionPage 1

We have carefully reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed except for minor editorial corrections. We have determined that these minor corrections:

• Are consistent with the intent that was proposed in the NPRM for correcting the unsafe condition; and

• Do not add any additional burden upon the public than was already proposed in the NPRM.

Costs of CompliancePage 1

We estimate that this AD affects 8 sailplanes in the U.S. registry.

We estimate the following costs to do the modification and replacement of the placard on the fin:

Labor costParts costTotal cost per sailplaneTotal cost on U.S. operators
2 work-hours × $80 per hour = $160$60$2208 × $220 = $1,760

We estimate the following costs to do the incorporation of changes in the FAA-approved SFM:

Labor costParts costTotal cost per sailplaneTotal cost on U.S. operators
1 work-hour × $80 per hour = $80Not applicable$808 × $80 = $640
Authority for This RulemakingPage 1

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106 describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this AD.

Regulatory findingsPage 1

We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

1. Is not a “significant regulatory action” under Executive Order 12866;

2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a summary of the costs to comply with this AD (and other information as included in the Regulatory Evaluation) and placed it in the AD Docket. You may get a copy of this summary by sending a request to us at the address listed under ADDRESSES. Include “Docket No. FAA-2006-24255; Directorate Identifier 2006-CE-25-AD” in your request.

Adoption of the amendmentPage 2

Accordingly, under the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

1. The authority citation for part 39 continues to read as follows:

2. FAA amends § 39.13 by adding the following new AD:

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 28

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • DG Flugzeugbau28 aircraft
By year built
20022012
Registered aircraft by year built: 16 aircraft
20022
20031
20081
20091
20111
201210

12 with no year recorded

By model

Aircraft

See all 28 aircraft