AD 2007-11-16

Airworthiness directive · Center main wheel well · Boeing MD-11 and MD-11F

Effective
July 5, 2007
Published
May 30, 2007 · 72 FR 29883–29884
Issued
May 21, 2007
Models
MD-11, MD-11F
Data sheet
TCDSA22WE
Registered aircraft
108 matched by model
Product
Aircraft · Large airplane
Amendment
39-15073
Docket
FAA-2007-27341
Project
2006-NM-272-AD
Issued as
Final rule

Unofficial copy from the Federal Register XML, document E7-10111. Only the govinfo PDF is the legal edition. DRS record last changed May 30, 2024.

On this page

Summary

The FAA is adopting a new airworthiness directive (AD) for all McDonnell Douglas Model MD-11 and MD-11F airplanes. This AD requires installing bracket assemblies and jumper wires in the center main wheel well to improve the bonding path between the structure (wall) of the lower auxiliary fuel tank and its internal fuel pumps; measuring the electrical resistance between the fuel pump housings and the fuel tank structure; and doing corrective actions if necessary. This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to detect and correct an inadequate bond between the internal fuel pump housings and the structure of the lower auxiliary fuel tank. This condition, if not corrected, could fail to meet fault current requirements and result in a potential ignition source that, in combination with flammable fuel vapors, could cause a fuel tank explosion and consequent loss of the airplane.

The airworthiness directive

2007-11-16 McDonnell Douglas: Amendment 39-15073. Docket No. FAA-2007-27341; Directorate Identifier 2006-NM-272-AD.

(a) Effective Date

PDF page 2

(a) This AD becomes effective July 5, 2007.

(b) Affected ADs

PDF page 2

(b) None.

(c) Applicability

PDF page 2

(c) This AD applies to all McDonnell Douglas Model MD-11 and MD-11F airplanes; certificated in any category.

(d) Unsafe Condition

PDF page 2

(d) This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to detect and correct an inadequate bond between the internal fuel pump housings and the structure of the lower auxiliary fuel tank. This condition, if not corrected, could fail to meet fault current requirements and result in a potential ignition source that, in combination with flammable fuel vapors, could cause a fuel tank explosion and consequent loss of the airplane.

(e) Compliance

PDF page 2

(e) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.

(f) Installation of Brackets and Jumpers, and Resistance Measurement

PDF page 2

(f) Within 60 months after the effective date of this AD, do the actions described in paragraphs (f)(1) and (f)(2) of this AD, in accordance with the Accomplishment Instructions of Boeing Service Bulletin MD11-28-127, dated September 19, 2006.

(1) Install bracket assemblies and jumper wires between the structure of the lower auxiliary fuel tank and its internal fuel pumps.

(2) Do an electrical resistance measurement between the fuel pump housings and the lower auxiliary fuel tank wall.

(g) Corrective Action

PDF page 2

(g) If any resistance measurement done in accordance with paragraph (f)(2) of this AD is greater than 2.5 milliohms on either fuel pump housing: Before further flight, rework the electrical bonding between the fuel pump housings and the lower auxiliary fuel tank wall as needed to achieve a resistance measurement of 2.5 milliohms or less on both fuel pump housings, in accordance with the Accomplishment Instructions of Boeing Service Bulletin MD11-28-127, dated September 19, 2006.

(h) Alternative Methods of Compliance (AMOCs)

PDF page 2

(h)(1) The Manager, Los Angeles Aircraft Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested in accordance with the procedures found in 14 CFR 39.19.

(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.

(i) Material Incorporated by Reference

PDF page 2

(i) You must use Boeing Service Bulletin MD11-28-127, dated September 19, 2006, to perform the actions that are required by this AD, unless the AD specifies otherwise. The Director of the Federal Register approved the incorporation by reference of this document in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Contact Boeing Commercial Airplanes, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data and Service Management, Dept. C1-L5A (D800-0024), for a copy of this service information. You may review copies at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

DatesPage 1

This AD becomes effective July 5, 2007.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in the AD as of July 5, 2007.

AddressesPage 1

You may examine the AD docket on the Internet at http://dms.dot.gov or in person at the Docket Management Facility, U.S. Department of Transportation, 400 Seventh Street, SW., Nassif Building, Room PL-401, Washington, DC.

Contact Boeing Commercial Airplanes, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data and Service Management, Dept. C1-L5A (D800-0024), for service information identified in this AD.

For further information contactPage 1

Samuel Lee, Aerospace Engineer, Propulsion Branch, ANM-140L, FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5262; fax (562) 627-5210.

Examining the DocketPage 1

You may examine the airworthiness directive (AD) docket on the Internet at http://dms.dot.gov or in person at the Docket Management Facility office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Management Facility office (telephone (800) 647-5227) is located on the plaza level of the Nassif Building at the street address stated in the ADDRESSES section.

DiscussionPage 1

The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to all McDonnell Douglas Model MD-11 and MD-11F airplanes. That NPRM was published in the Federal Register on February 26, 2007 (72 FR 8311). That NPRM proposed to require installing bracket assemblies and jumper wires in the center main wheel well to improve the bonding path between the structure (wall) of the lower auxiliary fuel tank and its internal fuel pumps; measuring the electrical resistance between the fuel pump housings and the fuel tank structure; and doing corrective actions if necessary.

CommentsPage 1

We provided the public the opportunity to participate in the development of this AD. We received no comments on the NPRM or on the determination of the cost to the public.

Clarification of Alternative Method of Compliance (AMOC) ParagraphPage 1

We have revised this action to clarify the appropriate procedure for notifying the principal inspector before using any approved AMOC on any airplane to which the AMOC applies.

ConclusionPage 1

We have carefully reviewed the available data and determined that air safety and the public interest require adopting the AD with the change described previously. We have determined that this change will neither increase the economic burden on any operator nor increase the scope of the AD.

Costs of CompliancePage 1

There are about 195 airplanes of the affected design in the worldwide fleet. This AD affects about 107 airplanes of U.S. registry. The following table provides the estimated costs for U.S. operators to comply with this AD, at an average labor rate of $80 per work hour.

Estimated Costs
ActionWork hoursPartsCost per airplaneFleet cost
Install bracket assemblies and jumper wires4$1,928$2,248$240,536
Do electrical resistance measurement1None required808,560
Authority for This RulemakingPage 1

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory findingsPage 2

We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866;

(2) Is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket. See the ADDRESSES section for a location to examine the regulatory evaluation.

Adoption of the amendmentPage 2

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

1. The authority citation for part 39 continues to read as follows:

2. The Federal Aviation Administration (FAA) amends § 39.13 by adding the following new airworthiness directive (AD):

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 108

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Mcdonnell Douglas104 aircraft
  • Boeing4 aircraft
By year built
19902001
Registered aircraft by year built: 96 aircraft
19902
199113
199227
199314
19947
19957
19969
19974
19984
19994
20002
20013

12 with no year recorded

By model

Aircraft

See all 108 aircraft