AD 2007-19-02

This AD becomes effective October 17, 2007.

The Director of the Federal Register approved the incorporation by reference of certain publications listed in the AD as of October 17, 2007.

You may examine the AD docket on the Internet at http://dms.dot.gov or in person at the U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC.

Contact Boeing Commercial Airplanes, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data and Service Management, Dept. C1-L5A (D800-0024), for service information identified in this AD.

Serj Harutunian, Aerospace Engineer, Propulsion Branch, ANM-140L, FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5254; fax (562) 627-5210.

You may examine the AD docket on the Internet at http://dms.dot.gov or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Operations office (telephone (800) 647-5527) is located on the ground floor of the West Building at the DOT street address stated in the ADDRESSES section.

The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to certain McDonnell Douglas Model MD-11, MD-11F, DC-10-30 and DC-10-30F (KC-10A and KDC-10), DC-10-40, DC-10-40F, and MD-10-30F airplanes. That NPRM was published in the Federal Register on June 5, 2007 (72 FR 31003). That NPRM proposed to require measuring the electrical resistance of the bond between the No. 2 fuel transfer pump adapter surface of the fuel tank and the fuel transfer pump housing flange, and performing corrective and other specified actions as applicable.

We provided the public the opportunity to participate in the development of this AD. We received no comments on the NPRM or on the determination of the cost to the public.

We have carefully reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed.

There are about 573 airplanes of the affected design in the worldwide fleet. This AD affects about 399 airplanes of U.S. registry. The required measurement takes about 1 work hour per airplane, at an average labor rate of $80 per work hour. Based on these figures, the estimated cost of this AD for U.S. operators is $31,920, or $80 per airplane.

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866;

(2) Is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket. See the ADDRESSES section for a location to examine the regulatory evaluation.

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

2. The Federal Aviation Administration (FAA) amends § 39.13 by adding the following new airworthiness directive (AD):