AD 2008-26-10

This AD becomes effective on January 5, 2009.

On January 5, 2009, the Director of the Federal Register approved the incorporation by reference of certain publications listed in this AD.

We must receive any comments on this AD by February 23, 2009.

Use one of the following addresses to comment on this AD.

• Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.

• Fax: (202) 493-2251.

• Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590.

• Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

To get the service information identified in this AD, contact Cessna Aircraft Company, P.O. Box 7704, Wichita, Kansas 67277; telephone: (800) 423-7762 or (316) 517-6056; Internet: http://www.cessna.com.

To view the comments to this AD, go to http://www.regulations.gov. The docket number is FAA-2008-1328; Directorate Identifier 2008-CE-066-AD.

Ann Johnson, Aerospace Engineer, FAA, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Wichita, Kansas 67209; telephone: 316-946-4105; fax: 316-946-4107; e-mail address: ann.johnson@faa.gov.

Reports of improper installation of the part number (P/N) identification placard on P/N 2013142-18 alternate static air source selector valves prompted us to issue AD 98-01-01, Amendment 39-10286 (63 FR 3455, January 23, 1998), which applies to certain Cessna Aircraft Company (Cessna) Models 172R and 182S airplanes, and AD 2008-10-02, Amendment 39-155508 (73 FR 24168, May 2, 2008), which applies to certain Cessna 172, 175, 180, 182, 185, 206, 207, 208, 210, and 303 series airplanes.

These ADs require inspecting the alternate static air source selector valve to determine if the P/N identification placard obstructs the alternate static air source selector valve port and removing the placard if obstruction is found. These ADs also require reporting to the FAA if obstruction is found.

These assemblies are required for flight into instrument flight rules (IFR) conditions as defined in Sec. 91.411 of the Federal Aviation Regulations (14 CFR 91.411). Use of these assemblies is optional in visual flight rules (VFR) conditions.

After issuing AD 98-01-01 and AD 2008-10-02, we received reports of 15 airplanes not previously affected by either AD with a P/N 2013142-18 installed and the alternate static air source selector valve port was found obstructed by the P/N identification placard.

We have been informed that all P/N 2013142-18 alternate static air source selector valves shipped from Cessna Parts Distribution between January 1, 1993, and March 31, 2008, may have port obstruction caused by the P/N identification placard.

This condition, if not corrected, could result in the altimeter, airspeed, and vertical speed indicators displaying erroneous indications. This could cause the pilot to react to incorrect flight information and possibly result in loss of control.

We reviewed Cessna Single Engine Service Bulletin, SB08-34-02, Revision 1, and Cessna Caravan Service Bulletin CAB08-4, Revision 1, both dated October 6, 2008; Cessna Single Engine Service Bulletin SEB08-5 and Cessna Multi-engine Service Bulletin MEB08-6, both dated October 13, 2008.

The service information describes procedures for inspecting the alternate static air source selector valve to assure that the P/N identification placard does not obstruct the alternate static air source selector valve port.

We are issuing this AD because we evaluated all the information and determined the unsafe condition described previously is likely to exist or develop on other products of the same type design. This AD requires inspecting the alternate static air source selector valve to assure that the P/N identification placard does not obstruct the alternate static air source selector valve port. If the P/N identification placard obstructs the port, this AD requires you to remove the placard, assure that the port is unobstructed, and report to the FAA if obstruction is found.

Since an unsafe condition exists that requires the immediate adoption of this AD, we determined that notice and opportunity for public comment before issuing this AD are impracticable, and that good cause exists for making this amendment effective in fewer than 30 days.

This AD is a final rule that involves requirements affecting flight safety, and we did not precede it by notice and an opportunity for public comment. We invite you to send any written relevant data, views, or arguments regarding this AD. Send your comments to an address listed under the ADDRESSES section. Include the docket number “FAA-2008-1328; Directorate Identifier 2008-CE-066-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the AD. We will consider all comments received by the closing date and may amend the AD in light of those comments.

We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive concerning this AD.

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866;

(2) Is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

You may examine the AD docket that contains the AD, the regulatory evaluation, any comments received, and other information on the Internet at http://www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Office (telephone (800) 647-5527) is located at the street address stated in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

1. The authority citation for part 39 continues to read as follows:

2. The FAA amends § 39.13 by adding a new AD to read as follows: