AD 2011-26-05

Airworthiness directive · Wings · Bombardier DHC-8-301, DHC-8-311 and DHC-8-315

Effective
January 23, 2012
Published
December 19, 2011 · 76 FR 78522–78523
Issued
December 6, 2011
Supersedes
AD2010-26-13
Models
DHC-8-301, DHC-8-311, DHC-8-315
Data sheet
TCDSA13NM
Registered aircraft
20 matched by model
Product
Aircraft · Large airplane
ATA chapter
57 · Wings
Amendment
39-16895
Docket
FAA-2011-0916
Project
2011-NM-127-AD
Issued as
Final rule

Unofficial copy from the Federal Register XML, document 2011-32019. Only the govinfo PDF is the legal edition. DRS record last changed May 30, 2024.

On this page

Summary

We are superseding an existing airworthiness directive (AD) that applies to certain Bombardier, Inc. Model DHC-8-300 series airplanes. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

Several cases of aileron terminal quadrant support brackets that were manufactured using sheet metal have been found cracked on DHC-8 Series 300 aircraft. Investigation revealed that the failure of the support bracket was due to fatigue. Failure of the aileron terminal quadrant support bracket could result in an adverse reduction of aircraft roll control.

The airworthiness directive

2011-26-05 Bombardier, Inc.: Amendment 39-16895. Docket No. FAA-2011-0916; Directorate Identifier 2011-NM-127-AD.

(a) Effective Date

PDF page 1

(a) This airworthiness directive (AD) becomes effective January 23, 2012.

(b) Affected ADs

PDF page 1

(b) This AD supersedes AD 2010-26-13, Amendment 39-16553 (75 FR 81420, December 28, 2010).

(c) Applicability

PDF page 1

(c) This AD applies to Bombardier, Inc. Model DHC-8-301, -311, and -315 airplanes, certificated in any category; having serial numbers 100 through 530 inclusive.

(d) Subject

PDF page 1

(d) Air Transport Association (ATA) of America Code 57: Wings.

(e) Reason

PDF page 1

(e) The mandatory continuing airworthiness information (MCAI) states:

Several cases of aileron terminal quadrant support brackets that were manufactured using sheet metal have been found cracked on DHC-8 Series 300 aircraft. Investigation revealed that the failure of the support bracket was due to fatigue. Failure of the aileron terminal quadrant support bracket could result in an adverse reduction of aircraft roll control.

These conditions could result in loss of control of the airplane.

(f) Compliance

PDF page 1

(f) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.

(g) Actions

PDF page 1

(g) For airplanes with an aileron terminal quadrant support bracket having part number (P/N) 85711569: At the applicable times specified in paragraph (g)(1) or (g)(2) of this AD, install a new aileron input quadrant support bracket by incorporating MODSUM 8Q101250, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 8-57-43, Revision B, dated October 7, 2009.

(1) For airplanes that have accumulated 30,000 total flight hours or more as of February 1, 2011 (the effective date of AD 2010-26-13, Amendment 39-16553 (75 FR 81420, December 28, 2010)): Within 3,000 flight hours after February 1, 2011.

(2) For airplanes that have accumulated less than 30,000 total flight hours as of February 1, 2011: At the earlier of the times of paragraphs (g)(2)(i) and (g)(2)(ii).

(i) Before the accumulation of 33,000 total flight cycles or within 6,000 flight hours after February 1, 2011, whichever occurs first.

(ii) Before the accumulation of 33,000 total flight hours or within 6,000 flight hours after the effective date of this AD, whichever occurs first.

(h) Credit for Actions Accomplished in Accordance With Previous Service Information

PDF page 1

(h) Doing the installation by incorporating MODSUM 8Q101250 is also acceptable for compliance with the requirements of paragraph (g) of this AD if done before February 1, 2011, in accordance with Bombardier Service Bulletin 8-57-43, dated August 9, 2002; or Bombardier Service Bulletin 8-57-43, Revision A, dated January 17, 2003.

FAA AD Differences

PDF page 1

Note 1:

This AD differs from the MCAI and/or service information as follows: No differences.

(i) Other FAA AD Provisions

PDF page 1

(i) The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager, New York Aircraft Certification Office (ACO), ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the New York ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, New York 11590; telephone (516) 228-7300; fax (516) 794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.

(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.

(j) Related Information

PDF page 1

(j) Refer to MCAI Canadian Airworthiness Directive CF-2009-45, dated December 11, 2009; and Bombardier Service Bulletin 8-57-43, Revision B, dated October 7, 2009; for related information.

(k) Material Incorporated by Reference

PDF page 1

(k) You must use Bombardier Service Bulletin 8-57-43, Revision B, dated October 7, 2009, to do the actions required by this AD, unless the AD specifies otherwise.

(1) The Director of the Federal Register previously approved the incorporation by reference of Bombardier Service Bulletin 8-57-43, Revision B, dated October 7, 2009, on February 1, 2011 (75 FR 81420, December 28, 2010), under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) For service information identified in this AD, contact Bombardier, Inc., Q-Series Technical Help Desk, 123 Garratt Boulevard, Toronto, Ontario M3K 1Y5, Canada; telephone (416) 375-4000; fax (416) 375-4539; email thd.qseries@aero.bombardier.com; Internet http://www.bombardier.com.

(3) You may review copies of the service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington. For information on the availability of this material at the FAA, call (425) 227-1221.

(4) You may also review copies of the service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call (202) 741-6030, or go to: http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

DatesPage 1

This AD becomes effective January 23, 2012.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of February 1, 2011 (75 FR 81420, December 28, 2010).

AddressesPage 1

You may examine the AD docket on the Internet at http://www.regulations.gov or in person at the U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC.

For further information contactPage 1

Aziz Ahmed, Aerospace Engineer, Airframe and Mechanical Systems Branch, ANE-171, FAA, New York Aircraft Certification Office (ACO), 1600 Stewart Avenue, Suite 410, Westbury, New York 11590; telephone (516) 228-7329; fax (516) 794-5531.

DiscussionPage 1

We issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 to include an AD that would apply to the specified products. That NPRM was published in the Federal Register on September 7, 2011 (76 FR 55296), and proposed to supersede AD 2010-26-13, Amendment 39-16553 (75 FR 81420, December 28, 2010). That NPRM proposed to revise the existing compliance time to include a 33,000 total flight hours compliance time. That NPRM proposed to correct an unsafe condition for the specified products. You may obtain further information by examining the MCAI in the AD docket.

CommentsPage 1

We gave the public the opportunity to participate in developing this AD. We received no comments on the NPRM (76 FR 55296, September 7, 2011) or on the determination of the cost to the public.

ConclusionPage 1

We reviewed the available data and determined that air safety and the public interest require adopting the AD as proposed.

Differences Between This AD and the MCAI or Service InformationPage 1

We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the AD is clear for U.S. operators and is enforceable. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information.

We might also have required different actions in this AD from those in the MCAI in order to follow our FAA policies. Any such differences are highlighted in a Note within the AD.

Costs of CompliancePage 1

We estimate that this AD will affect about 13 products of U.S. registry.

The actions that are required by AD 2010-26-13, Amendment 39-16553 (75 FR 81420, December 28, 2010), and retained in this AD take about 72 work-hours per product, at an average labor rate of $85 per work-hour. Required parts cost about $1,080 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, the estimated cost of the currently required actions is $93,600, or $7,200 per product.

Authority for This RulemakingPage 1

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory findingsPage 1

We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this AD:

1. Is not a ”significant regulatory action” under Executive Order 12866;

2. Is not a ”significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this AD and placed it in the AD docket.

Examining the AD DocketPage 1

You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains the NPRM (76 FR 55296, September 7, 2011), the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

Adoption of the AmendmentPage 1

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

Adoption of the amendmentPage 1

1. The authority citation for part 39 continues to read as follows:

2. The FAA amends § 39.13 by removing Amendment 39-16553 (75 FR 81420, December 28, 2010) and adding the following new AD:

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 20

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Bombardier15 aircraft
  • Boeing Of Canada/Dehav Div3 aircraft
  • Dehavilland2 aircraft
By year built
19912009
Registered aircraft by year built: 6 aircraft
19912
19951
19971
20092

14 with no year recorded

By model

Aircraft

See all 20 aircraft