AD 2013-11-16

Airworthiness directive · Flight Controls and Wings · Winglets (Aviation Partners STC ST01411SE)

Effective
July 2, 2013
Published
June 17, 2013 · 78 FR 36089–36091
Issued
May 24, 2013
Models
BAe.125 Series 800A, BAe.125 Series 800A (C-29A), BAe.125 Series 800A (U-125), BAe.125 Series 800B, Hawker 800, Hawker 800 (U-125A), Hawker 800XP
Data sheet
TCDSA3EU
Registered aircraft
369 matched by model
Product
Aircraft · Large airplane
ATA chapter
27 · Flight controls
Amendment
39-17476
Docket
FAA-2013-0462
Project
2013-NM-092-AD
Issued as
Final rule; request for comments

Unofficial copy from the Federal Register XML, document 2013-14247. Only the govinfo PDF is the legal edition. DRS record last changed January 21, 2026.

On this page

Summary

We are adopting a new airworthiness directive (AD) for certain Hawker Beechcraft Corporation (Type Certificate Previously Held by Raytheon Aircraft Company) Model BAe.125 Series 800A (including C-29A and U-125), and 800B airplanes; and Model Hawker 800 (including variant U-125A) and 800XP airplanes modified in accordance with a certain winglet supplemental type certificate. This AD requires revising the Limitations section of the airplane flight manual (AFM) and installing placards on the instrument panel. This AD was prompted by reports of several instances of severe vibration and wing/aileron oscillations. We are issuing this AD to prevent vibration and wing/aileron oscillations, which could cause structural damage or lead to divergent flutter, and result in loss of integrity of the wing, loss of control of the airplane, and in-flight breakup.

The airworthiness directive

2013-11-16 Hawker Beechcraft Corporation (Type Certificate Previously Held by Raytheon Aircraft Company): Amendment 39-17476; Docket No. FAA-2013-0462; Directorate Identifier 2013-NM-092-AD.

(a) Effective Date

PDF page 2

This AD is effective July 2, 2013.

(b) Affected ADs

PDF page 2

None.

(c) Applicability

PDF page 2

This AD applies to Hawker Beechcraft Corporation (Type Certificate Previously Held by Raytheon Aircraft Company) Model BAe.125 Series 800A (including C-29A and U-125), and 800B airplanes; and Model Hawker 800 (including variant U-125A) and 800XP airplanes; certificated in any category; modified by Aviation Partners Inc. Supplemental Type Certificate (STC) ST01411SE ( http://rgl.faa.gov/Regulatory_and_Guidance_Library/rgstc.nsf/0/1b3a5d9052d875c0862577a700704eb6/$FILE/ST01411SE.pdf).

(d) Subject

PDF page 2

Joint Aircraft System Component (JASC)/Air Transport Association (ATA) of America Code 27, Flight Controls; and Code 57, Wings.

(e) Unsafe Condition

PDF page 2

This AD was prompted by reports of several instances of severe vibration and wing/aileron oscillation due to lack of sufficient flutter margin with winglets installed. We are issuing this AD to prevent vibration and wing/aileron oscillations, which could cause structural damage or lead to divergent flutter, and result in loss of integrity of the wing, loss of control of the airplane, and in-flight breakup.

(f) Compliance

PDF page 3

Comply with this AD within the compliance times specified, unless already done.

(g) Revise the Airplane Flight Manual

PDF page 3

Within 45 days after the effective date of this AD: Revise the Limitations section of the airplane flight manual (AFM) by inserting the text specified in figure 1 to paragraph (g) of this AD adjacent to the page which states the Operational Limitations—Maximum Permissible Altitude.

[graphic omitted; see the official PDF]

Note 1 to paragraph (g) of this AD:

When a statement identical to that in paragraph (g) of this AD has been included in the Limitations section of the general revisions of the AFM, the general revisions may be inserted into the AFM and the statement inserted as required by paragraph (g) of this AD may be removed.

(h) Installation of the Placards

PDF page 3

Within 45 days after the effective date of this AD: Install placards on the instrument panel, in accordance with paragraph 3.B. of the Accomplishment Instructions of Aviation Partners Service Bulletin SBH-13-001, Revision A, dated May 3, 2013.

(i) Alternative Methods of Compliance (AMOCs)

PDF page 3

(1) The Manager, Seattle Aircraft Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ACO, send it to the attention of the person identified in the Related Information section of this AD. Information may be emailed to: 9-ANM-Seattle-ACO-AMOC-Requests@faa.gov.

(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

(j) Related Information

PDF page 3

For more information about this AD, contact Kathleen Arrigotti, Aerospace Engineer, Airframe Branch, ANM-120S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: (425) 917-6426; fax: (425) 917-6590; email: kathleen.arrigotti@faa.gov.

(k) Material Incorporated by Reference

PDF page 3

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) You must use this service information as applicable to do the actions required by this AD, unless the AD specifies otherwise.

(i) Aviation Partners Service Bulletin SBH-13-001, Revision A, dated May 3, 2013.

(ii) Reserved.

(3) For service information identified in this AD, contact Aviation Partners Inc., 7299 Perimeter Road South, Seattle, WA 98108; telephone 800-946-4538; email info@aviationpartners.com; Internet https://www.aviationpartners.com.

(4) You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

(5) You may view this service information that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal-register/cfr/ibr-locations.html.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

DatesPage 1

This AD is effective July 2, 2013.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in the AD as of July 2, 2013.

We must receive comments on this AD by August 1, 2013.

AddressesPage 1

You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:

• Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.

• Fax: 202-493-2251.

• Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.

• Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

For service information identified in this AD, contact Aviation Partners Inc., 7299 Perimeter Road South, Seattle, WA 98108; telephone 800-946-4538; email info@aviationpartners.com; Internet https://www.aviationpartners.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

For further information contactPage 1

Kathleen Arrigotti, Aerospace Engineer, Airframe Branch, ANM-120S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: (425) 917-6426; fax: (425) 917-6590; email: kathleen.arrigotti@faa.gov.

DiscussionPage 1

We have received reports of several instances of severe vibration and wing/aileron oscillation due to lack of sufficient flutter margin with winglets installed. This condition, if not corrected, could cause structural damage or lead to divergent flutter, and result in loss of integrity of the wing, loss of control of the airplane, and in-flight breakup.

Relevant service informationPage 1

We reviewed Aviation Partners Service Bulletin SBH-13-001, Revision A, dated May 3, 2013. The service information describes procedures for revising the Limitations section of the AFM to include an altitude restriction, and installing placards on the instrument panel.

FAA's DeterminationPage 1

We are issuing this AD because we evaluated all the relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of the same type design.

AD RequirementsPage 2

This AD requires accomplishing the actions specified in the service information described previously.

Interim actionPage 2

We consider this AD interim action. Aviation Partners Inc. is currently developing a modification that will address the unsafe condition identified in this AD. Once this modification is developed, approved, and available, we may consider additional rulemaking. The modification is expected to remove the altitude restriction.

FAA's Justification and Determination of the Effective DatePage 2

An unsafe condition exists that requires the immediate adoption of this AD. The FAA has found that the risk to the flying public justifies waiving notice and comment prior to adoption of this rule because severe vibration and wing/aileron oscillations could cause structural damage or lead to divergent flutter, and result in loss of integrity of the wing, loss of control of the airplane, and in-flight breakup. Therefore, we find that notice and opportunity for prior public comment are impracticable and that good cause exists for making this amendment effective in less than 30 days.

Comments invitedPage 2

This AD is a final rule that involves requirements affecting flight safety and was not preceded by notice and an opportunity for public comment. However, we invite you to send any written data, views, or arguments about this AD. Send your comments to an address listed under the ADDRESSES section. Include the docket number FAA-2013-0462 and Directorate Identifier 2013-NM-092-AD at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this AD. We will consider all comments received by the closing date and may amend this AD because of those comments.

We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this AD.

Costs of CompliancePage 2

We estimate that this AD affects 102 airplanes of U.S. registry.

We estimate the following costs to comply with this AD:

Estimated Costs
ActionLabor costParts costCost per productCost on U.S. operators
AFM Revision1 work-hour × $85 per hour = $85$0$85$8,670
Placard Installation1 work-hour × $85 per hour = $8510959,690
Authority for This RulemakingPage 2

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory findingsPage 2

This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),

(3) Will not affect intrastate aviation in Alaska, and

(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

Adoption of the AmendmentPage 2

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

Adoption of the amendmentPage 2

1. The authority citation for part 39 continues to read as follows:

2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 369

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Raytheon253 aircraft
  • British Aerospace66 aircraft
  • Raytheon Corporate Jets40 aircraft
  • Corporate Jets8 aircraft
  • Hawker Beechcraft2 aircraft
By year built
19842007
Registered aircraft by year built: 317 aircraft
19846
19855
19862
19874
19885
19897
19906
19911
19927
19939
19946
19956
199615
199713
199821
199925
200028
200134
200235
200323
200431
200521
20065
20072

52 with no year recorded

By model

Aircraft

See all 369 aircraft