AD 2021-15-08

Airworthiness directive · Doors · Airbus A350-1041 and A350-941

Effective
September 9, 2021
Published
August 5, 2021 · 86 FR 42694–42696
Issued
July 14, 2021
Models
A350-1041, A350-941
Data sheet
TCDST00063IB
Registered aircraft
42 matched by model
Product
Aircraft · Large airplane
ATA chapter
52 · Doors
Amendment
39-21655
Docket
FAA-2021-0343
Project
MCAI-2021-00013-T
Issued as
Final rule

Unofficial copy from the Federal Register XML, document 2021-16560. Only the govinfo PDF is the legal edition. DRS record last changed May 30, 2024.

On this page

Summary

The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by a report that during an inspection of the flight deck escape hatches it was found that they were difficult to open from the inside, and several hatches were found impossible to open from the outside. Subsequent investigation revealed corrosion on the flight deck escape hatch mechanism due to condensation penetrating inside the mechanism. This AD requires replacing all affected flight deck escape hatches with serviceable hatches, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

The airworthiness directive

2021-15-08 Airbus SAS: Amendment 39-21655; Docket No. FAA-2021-0343; Project Identifier MCAI-2021-00013-T.

(a) Effective Date

PDF page 2

This airworthiness directive (AD) is effective September 9, 2021.

(b) Affected ADs

PDF page 2

None.

(c) Applicability

PDF page 2

This AD applies to all Airbus SAS Model A350-941 and -1041 airplanes, certificated in any category.

(d) Subject

PDF page 2

Air Transport Association (ATA) of America Code 52, Doors.

(e) Reason

PDF page 2

This AD was prompted by a report that during an inspection of the flight deck escape hatches it was found that they were difficult to open from the inside, and several hatches were found impossible to open from the outside. Subsequent investigation revealed corrosion on the flight deck escape hatch mechanism due to condensation penetrating inside the mechanism. The FAA is issuing this AD to address possible inaccessibility of the flight deck escape hatch, which could impede flightcrew evacuation during an emergency.

(f) Compliance

PDF page 2

Comply with this AD within the compliance times specified, unless already done.

(g) Requirements

PDF page 2

Except as specified in paragraph (h) of this AD: Comply with all required actions and compliance times specified in, and in accordance with, European Union Aviation Safety Agency (EASA) AD 2021-0004, dated January 6, 2021 (EASA AD 2021-0004).

(h) Exceptions to EASA AD 2021-0004

PDF page 2

(1) Where EASA AD 2021-0004 refers to its effective date, this AD requires using the effective date of this AD.

(2) The “Remarks” section of EASA AD 2021-0004 does not apply to this AD.

(i) Other FAA AD Provisions

PDF page 2

The following provisions also apply to this AD:

(1) Alternative Methods of Compliance (AMOCs): The Manager, Large Aircraft Section, International Validation Branch, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or responsible Flight Standards Office, as appropriate. If sending information directly to the Large Aircraft Section, International Validation Branch, send it to the attention of the person identified in paragraph (j) of this AD. Information may be emailed to: 9-AVS-AIR-730-AMOC@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the responsible Flight Standards Office.

(2) Contacting the Manufacturer: For any requirement in this AD to obtain instructions from a manufacturer, the instructions must be accomplished using a method approved by the Manager, Large Aircraft Section, International Validation Branch, FAA; or EASA; or Airbus SAS's EASA Design Organization Approval (DOA). If approved by the DOA, the approval must include the DOA-authorized signature.

(3) Required for Compliance (RC): For any service information referenced in EASA AD 2020-0144 that contains RC procedures and tests: Except as required by paragraph (i)(2) of this AD, RC procedures and tests must be done to comply with this AD; any procedures or tests that are not identified as RC are recommended. Those procedures and tests that are not identified as RC may be deviated from using accepted methods in accordance with the operator's maintenance or inspection program without obtaining approval of an AMOC, provided the procedures and tests identified as RC can be done and the airplane can be put back in an airworthy condition. Any substitutions or changes to procedures or tests identified as RC require approval of an AMOC.

(j) Related Information

PDF page 3

For more information about this AD, contact Kathleen Arrigotti, Aerospace Engineer, Large Aircraft Section, International Validation Branch, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone and fax 206-231-3218; email kathleen.arrigotti@faa.gov.

(k) Material Incorporated by Reference

PDF page 3

(1) The Director of the Federal Register approved the incorporation by reference (IBR) of the service information listed in this paragraph under 5 U.S.C. 552(a) and 1 CFR part 51.

(2) You must use this service information as applicable to do the actions required by this AD, unless this AD specifies otherwise.

(i) European Union Aviation Safety Agency (EASA) AD 2021-0004, dated January 6, 2021.

(ii) [Reserved]

(3) For EASA AD 2021-0004, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email ADs@easa.europa.eu; internet www.easa.europa.eu. You may find this EASA AD on the EASA website at https://ad.easa.europa.eu.

(4) You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. This material may be found in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0343.

(5) You may view this material that is incorporated by reference at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, email fedreg.legal@nara.gov, or go to: https://www.archives.gov/federal-register/cfr/ibr-locations.html.

Rule preamble

The FAA’s background, reasoning and cost estimate, published with the AD.

DatesPage 1

This AD is effective September 9, 2021.

The Director of the Federal Register approved the incorporation by reference of a certain publication listed in this AD as of September 9, 2021.

AddressesPage 1

For material incorporated by reference (IBR) in this AD, contact EASA, Konrad-Adenauer-Ufer 3, 50668 Cologne, Germany; telephone +49 221 8999 000; email ADs@easa.europa.eu; internet www.easa.europa.eu. You may find this IBR material on the EASA website at https://ad.easa.europa.eu. You may view this IBR material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. It is also available in the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2021-0343.

For further information contactPage 1

Kathleen Arrigotti, Aerospace Engineer, Large Aircraft Section, International Validation Branch, FAA, 2200 South 216th St., Des Moines, WA 98198; telephone and fax 206-231-3218; email kathleen.arrigotti@faa.gov.

BackgroundPage 1

EASA, which is the Technical Agent for the Member States of the European Union, has issued EASA AD 2021-0004, dated January 6, 2021 (EASA AD 2021-0004) (also referred to as the Mandatory Continuing Airworthiness Information, or the MCAI), to correct an unsafe condition for all Airbus SAS Model A350-941 and -1041 airplanes.

The FAA issued a notice of proposed rulemaking (NPRM) to amend 14 CFR part 39 by adding an AD that would apply to all Airbus SAS Model A350-941 and -1041 airplanes. The NPRM published in the Federal Register on May 7, 2021 (86 FR 24549). The NPRM was prompted by a report that during an inspection of the flight deck escape hatches it was found that they were difficult to open from the inside, and several hatches were found impossible to open from the outside. Subsequent investigation revealed corrosion on the flight deck escape hatch mechanism due to condensation penetrating inside the mechanism. The NPRM proposed to require replacing all affected flight deck escape hatches with serviceable hatches, as specified in EASA AD 2021-0004.

The FAA is issuing this AD to address possible inaccessibility of the flight deck escape hatch, which could impede flightcrew evacuation during an emergency. See the MCAI for additional background information.

CommentsPage 1

The FAA gave the public the opportunity to participate in developing this final rule. The Air Line Pilots Association, International (ALPA) indicated its support for the NPRM.

ConclusionPage 1

The FAA reviewed the relevant data, considered the comment received, and determined that air safety and the public interest require adopting this final rule as proposed, except for minor editorial changes. The FAA has determined that these minor changes:

• Are consistent with the intent that was proposed in the NPRM for addressing the unsafe condition; and

• Do not add any additional burden upon the public than was already proposed in the NPRM.

Related Service Information Under 1 CFR Part 51Page 1

EASA AD 2021-0004 describes procedures for replacing all affected flight deck escape hatches with serviceable flight deck escape hatches.

This material is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the ADDRESSES section.

Costs of CompliancePage 2

The FAA estimates that this AD affects 15 airplanes of U.S. registry. The FAA estimates the following costs to comply with this AD:

Estimated Costs for Required Actions
Labor costParts costCost per productCost on U.S. operators
4 work-hours × $85 per hour = $340$55,390$55,730$835,950

According to the manufacturer, some or all of the costs of this AD may be covered under warranty, thereby reducing the cost impact on affected operators. The FAA does not control warranty coverage for affected operators. As a result, the FAA has included all known costs in the cost estimate.

Authority for This RulemakingPage 2

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

The FAA is issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: General requirements. Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory findingsPage 2

This AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Will not affect intrastate aviation in Alaska, and

(3) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

Adoption of the AmendmentPage 2

Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:

Adoption of the amendmentPage 2

1. The authority citation for part 39 continues to read as follows:

2. The FAA amends § 39.13 by adding the following new airworthiness directive:

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 42

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Airbus42 aircraft
By year built
20152026
Registered aircraft by year built: 38 aircraft
20151
20162
20176
20187
20193
20202
20224
20247
20255
20261

4 with no year recorded

By model

Aircraft

See all 42 aircraft