AD 69-05-02

Airworthiness directive · Wing Panel · Maryland Air Industries FH-227, FH-227B, FH-227C and 2 more

Effective
June 18, 1976
Models
FH-227, FH-227B, FH-227C, FH-227D, FH-227E
Data sheet
TCDS7A1
Product
Aircraft · Large airplane
Amendment
39-2641

Unofficial copy of the text in the FAA’s Dynamic Regulatory System. The FAA’s own copy is the authoritative one. DRS record last changed May 30, 2024.

On this page

The airworthiness directive

69-05-02 FAIRCHILD: Amendment 39-729 as amended by Amendment 39-1588 is further amended by Amendment 39-2641. Applies to FH-227 Type Airplanes Certificated in all categories.

Compliance required as indicated.

To detect the development of cracks in the wing area, accomplish the following:

(a) Within 25 hours time in service after the accumulation of the specified hours in service, unless already accomplished, inspect or continue to inspect in accordance with Fairchild Service Bulletin 51-1, as amended by Revision 6, of December 12, 1975 or later revision approved by the Chief, Engineering and Manufacturing Branch, FAA, Eastern Region or with an approved equivalent inspection.

(b) Where a visual inspection may be accomplished in lieu of x-ray, at least a 10-power glass must be used.

(c) For those aircraft incorporating Fairchild Service Bulletin 51-1, Appendix No. 1, dated January 5, 1973, or an approved equivalent special structural inspection and alteration, the inspection interval for the outer wing panel without cracks remains at 1200 hours. If any cracks were discovered prior to the alteration the inspection interval will be that specified in paragraph 1.D(1) of the Appendix.

(d) If new cracks are found or if repaired cracks are found to be propagating, replace the cracked part with a part of the same part number or with an approved equivalent part, or incorporate an approved repair before further flight. However, upon request, with descriptive information of the crack and proposed operating limitations submitted through an FAA maintenance inspector, the flight of the airplane in accordance with FAR 21.197 to a base where the repair can be made, may be approved by the Chief, Engineering and Manufacturing Branch, FAA, Eastern Region.

(e) Equivalent inspection, repairs or parts must be approved by the Chief, Engineering and Manufacturing Branch, FAA, Eastern Region.

(f) Upon request, with substantiating data submittedthrough an FAA maintenance inspector, the compliance times specified in this AD may be increased by the Chief, Engineering and Manufacturing Branch, FAA, Eastern Region.

Amendment 39-729 was effective March 12, 1969. Amendment 39-1588 was effective January 31, 1973. This amendment 39-2641 is effective June 18, 1976.

NOTE: Amendment 39-2641 was distributed on June 7, 1976, as AD 76-12-04. The issuing office intended Amendment 39-2641 to be published as a revision to AD 69-5-2. Accordingly, the AD is being republished to reflect the correct AD number and AD 76-12-04 is cancelled.

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft

No registered aircraft matched this AD’s modelsForeign aircraft aren’t included, and ADs on propellers and appliances aren’t matched by model.