AD 74-10-08

Airworthiness directive · Horizontal Stabilizer · Boeing 727-100 Series, 727-100C Series, 727-200 Series and 3 more

Effective
February 27, 1975
Models
727-100 Series, 727-100C Series, 727-200 Series, 727-200F Series, 727 Series, 727C Series
Data sheet
TCDSA3WE
Registered aircraft
25 matched by model
Product
Aircraft · Large airplane
Amendment
39-2073

Unofficial copy of the text in the FAA’s Dynamic Regulatory System. The FAA’s own copy is the authoritative one. DRS record last changed May 30, 2024.

On this page

The airworthiness directive

74-10-08 BOEING: Amendment 39-1836 as amended by Amendment 39-2073. Applies to all model 727 series airplanes certificated in all categories. Compliance required as indicated. (A) Unless already accomplished on airplanes which have been delivered after September 30, 1973, or which have had new horizontal stabilizer hinge pins, P/N 69-14410, installed since that time, conduct the inspection and modification of paragraph (C) below, within the next 15 days after the effective date of this AD. (B) Unless already accomplished on all other airplanes, conduct the inspection and modification of paragraph (C) below, within the next 6 months after the effective date of this AD. (C) Inspect the horizontal stabilizer hinge pins for integrity, replace as necessary, and install threaded retention rods, P/N 69-67076, or equivalent, in accordance with Boeing Alert Service Bulletin 727-55-59, or FAA approved revisions, or in a manner approved by the Chief, Engineering and Manufacturing Branch, FAA Northwest Region. (D) If a threaded rod, P/N 69-67076-2, or an equivalent fabricated rod made from threaded rod NAS 1454-( )-( ), or any other rod with a Class 2 thread has been installed, unless already accomplished, conduct, before September 6, 1975, the hinge pin retainer nut torque inspection in accordance with Paragraph III, Part II of Boeing Alert Service Bulletin No. 727-55- 59, Revision 2, or later FAA approved revisions, or in a manner approved by the Chief, Engineering and Manufacturing Branch, FAA Northwest Region. If the torque required to rotate the self-locking nut is less than 30 inch-pounds, replace the rod in accordance with Boeing Alert Service Bulletin No. 727-55-59, Revision 3, or later FAA approved revisions, or in a manner approved by the Chief, Engineering and Manufacturing Branch, FAA Northwest Region. The Manufacturer's specifications and procedures identified and described in this directive are incorporated herein and made a part hereof pursuant to 5 U.S.C. 552(a)(1). All persons affected by this directive who have not already received these documents may obtain copies upon request to The Boeing Company, P. O. Box 3707, Seattle, Washington 98124. These documents may also be examined at FAA Northwest Region, Boeing Field, Seattle, Washington.

Amendment 39-1836 became effective on May 10, 1974. This Amendment 39-2073 becomes effective on February 27, 1975.

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 25

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Boeing25 aircraft
By year built
19711982
Registered aircraft by year built: 18 aircraft
19711
19731
19752
19763
19772
19782
19791
19815
19821

7 with no year recorded

By model

Aircraft

See all 25 aircraft