- Effective
- October 31, 1978
- Models
- 58P, 58PA
- Data sheet
- TCDSA23CE
- Registered aircraft
- 301 matched by model
- Product
- Aircraft · Small airplane
- Amendment
- 39-3324
Unofficial copy of the text in the FAA’s Dynamic Regulatory System. The FAA’s own copy is the authoritative one. DRS record last changed January 21, 2026.
Copies of the files this page was built from, with their SHA-256. Retrieved October 18, 2026.
| File | Size | SHA-256 | Original |
|---|---|---|---|
| FAA DRS HTML | 23 KB | 49a57480…01ab35a | FAA DRS (API key needed) |
On this page
The airworthiness directive
76-17-02 BEECH: Amendment 39-2697 as amended by amendment 39-3324. Applies to Models 58P and 58PA (Serial Numbers TJ-2 through TJ-19, TJ-21 through TJ-45, TJ-47 through TJ-54, and TJ-56 through TJ-58) airplanes certificated in all categories.
Compliance: Required as indicated, unless already accomplished.
To prevent cracking of the cabin window located just forward of the cabin entrance door on the left side of the airplane, with resultant loss of cabin pressurization, accomplish the following:
A. On airplanes that do not have the window frame reinforcement installed, as defined in Beechcraft Service Instructions 0828-110, Revision I or later approved revisions, accomplish the following in accordance with said service instructions:
1. Within 25 hours' time in service after the effective date of this AD and at the two next 50 hour time in service intervals thereafter, visually inspect the cabin window just forward of the cabin door on the left side of the airplane for cracks and if cracks are found during any inspection required herein, prior to any flight during which the cabin is pressurized, replace the window and install the window frame reinforcement.
2. If no cracks have been found during any inspection required in Paragraph A.1., within 100 hours' time in service after the initial inspection required by Paragraph A.1. install the window frame reinforcement.
B. On airplanes that are flown unpressurized following discovery of a cracked window during any inspection required by Paragraph A of this Airworthiness Directive:
1. Fabricate a placard worded as follows: "DO NOT PRESSURIZE IN FLIGHT" and
2. Install said placard near the cabin pressurization control switch, and
3. Operate the aircraft in accordance with the placard until the cracked window is replaced.
C. Any equivalent method of compliance with this AD must be approved by the Chief, Engineering and Manufacturing Branch, FAA, Central Region.Amendment 39-2697 became effective August 24, 1976.
This amendment 39-3324 becomes effective October 31, 1978.
Affected TCDS · 1
The type certificate data sheets for the models this AD names, matched by model and maker.
Registered aircraft · 301
Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.
| 1974 | 1 |
|---|---|
| 1975 | 8 |
| 1976 | 23 |
| 1977 | 15 |
| 1978 | 29 |
| 1979 | 39 |
| 1980 | 47 |
| 1981 | 35 |
| 1982 | 23 |
| 1983 | 4 |
| 1984 | 22 |
| 1985 | 12 |
| 1986 | 1 |
| 1998 | 1 |
41 with no year recorded