AD 79-08-03

79-08-03 CESSNA: Amendment 39-3428. Applies to the following models and serial numbered airplanes certified in all categories:

MODELS SERIAL NUMBERS 120, 140 8000 through 15075 and 15200 through 15724 150 15065062 through 15075564 A150 A15000001 through A15000480 170 18000 through 20999 and 25000 through 27169 172 28000 through 29999, 46001 through 47746, 17247747 through 17250572, and 17259224 through 17267584 R172 R1722000 through R1722724 P172 P17257120 through P17257189 175 55001 through 56777 and 17556778 through 17557119 177 17700001 through 17702314 177RG 177RG0001 through 177RG0788 180 30000 through 32999, 50000 through 50355, and 18051608 through 18052770 182 33000 through 34999, 51001 through 51556, and 18254680 through 18265965 185 18500968 through 18503458 188 188-0001 through 188-0572 and 18800573 through 18803046 190, 195 7001 through 7999 and 16000 through 16183 210-5 (205) and 210-5A (205A) 205-0320 through 205-0577206, U206, TU206, P206, TP206 206-0001 through 206-0275, U206-0276 through U206-1444, U20601445 through U20604074, P206-001 through P206-0603, and P20600604 through P20600647 207 20700001 through 20700414 (except those aircraft with factory installed 24-volt electrical system) 210, T210 21058162 through 21061039 and T210-0001 through T210-0454

COMPLIANCE: At the next appropriate inspection prescribed by Federal Aviation Regulation 91.169 following the effective date of this AD, unless previously accomplished.

To prevent an inflight electrical system failure, smoke in the cockpit, and/or fire in the wire bundle behind the instrument panel, accomplish the following:

A) Disconnect the wire, at the ammeter or at the electrical system bus as applicable, that connects the bus to the cigar lighter receptacle. (The wire is connected to either the bus side or equipment side of a circuit breaker or to the ammeter.) Following the disconnection of this wire either:1) Reconnect the wire to the electrical bus by using an existing or newly installed circuit protection device that is properly rated to protect the wire gauge used for this circuit, or

2) Disconnect the wire from the lighter receptacle at the opposite end and remove it from the airplane, or

3) Protect the wire by insulating its disconnected end, fold this wire end back against the wire bundle in which it is routed and secure it to that bundle.

NOTE: For those installations reconnected in accordance with paragraph A 1 the proper rated circuit protection device to be used may be determined by consulting FAA Advisory Circular 43.13-1A.

B) Any equivalent method of compliance with this AD must be approved by the Chief, Engineering and Manufacturing Branch, FAA, Central Region.

Amendment 39-3428 became effective May 21, 1979.

This correction becomes effective June 6, 1979.