AD 80-26-04 R1

Airworthiness directive · Rudder Pulley at Cabin Step · Piper PA-23, PA-23-160, PA-23-235 and 2 more

Effective
August 28, 1981
Published
August 27, 1981
Issued
August 14, 1981
Models
PA-23, PA-23-160, PA-23-235, PA-23-250, PA-23-250 (Navy UO-1)
Data sheet
TCDS1A10
Registered aircraft
1,267 matched by model
Product
Aircraft · Small airplane
Amendment
39-4198

Unofficial copy of the text in the FAA’s Dynamic Regulatory System. The FAA’s own copy is the authoritative one. DRS record last changed November 21, 2025.

On this page

The airworthiness directive

80-26-04 R1 PIPER: Amendment 39-3992 as amended by Amendment 39-4198. Applies to models:

PA-23, PA-23-160, Serial Nos. 23-1 thru 23-2046; PA-23-235, Serial Nos. 27-505 thru 27-622; PA-23-250, Serial Nos. 27-1 thru 27-504; PA-23-250 (6 Place), Serial Nos. 27-2000 thru 27-8054049 certificated in all categories.

To detect cracks and prevent possible misalignment of the rudder cable-pulley at the fuselage crossmember which supports the cabin entrance step, accomplish the following:

a. For airplanes with 500 or more hours in service on the effective date of this AD, within the next 100 hours in service, inspect the cabin entrance step supporting frame structure for cracks, repair as necessary in accordance with paragraph (c), and unless already accomplished incorporate additional bracketry for the footstep attachment at the rudder pulley in accordance with paragraph (c).

b. For airplanes with less than 500 hours in service on the effective date of this AD, before the accumulation of 600 hours in service, inspect the cabin entrance step supporting frame structure for cracks, repair as necessary in accordance with paragraph (c), and unless already accomplished, incorporate additional bracketry for the footstep attachment at the rudder pulley in accordance with paragraph (c).

c. Accomplish steps 1 through 5 under the "Inspection and Repair Instructions" Section and steps 1 through 9 under "Footstep Reinforcement Brackets Installation Instructions" in Piper Service Bulletin No. 672 dated June 20, 1980, or equivalent.

d. Equivalent inspections and alterations must be approved by the Chief, Engineering and Manufacturing Branch, FAA Eastern Region.

e. Upon submittal of substantiating data by an owner or operator through an FAA Maintenance Inspector, the Chief, Engineering and Manufacturing Branch, FAA, Eastern Region, may adjust the compliance times specified in this AD.

NOTE: Since the cabin step is part of the approved type design, it must be in place. This includes those cases where temporary permission was granted for its removal.

Amendment 39-3992 was effective December 19, 1980.

This amendment 39-4198 is effective August 28, 1981.

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 1,267

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Piper1,267 aircraft
By year built
19531995
Registered aircraft by year built: 1,010 aircraft
19531
19549
195534
195634
195745
195850
195960
196048
196127
196228
196332
196428
196545
196660
196731
196839
196949
197019
197124
197227
197344
197449
197536
197652
197735
197836
197946
198011
198110
19951

257 with no year recorded

By model

Aircraft

See all 1,267 aircraft