AD 90-10-03

Airworthiness directive · Entry Door Rod-End Bearings · Boeing 747-100 Series, 747-100B Series, 747-100B SUD Series and 9 more

Effective
June 4, 1990
Models
747-100 Series, 747-100B Series, 747-100B SUD Series, 747-200B Series, 747-200C Series, 747-200F Series and 6 more
Data sheet
TCDSA20WE
Registered aircraft
63 matched by model
Product
Aircraft · Large airplane
Amendment
39-6587
Docket
89-NM-264-AD

Unofficial copy of the text in the FAA’s Dynamic Regulatory System. The FAA’s own copy is the authoritative one. DRS record last changed May 30, 2024.

On this page

The airworthiness directive

90-10-03 BOEING: Amendment 39-6587. Docket No. 89-NM-264-AD.

Applicability: Model 747 series airplanes, identified in Boeing Alert Service Bulletin 747-52A2217, dated October 19, 1989, certificated in any category.

Compliance: Required as indicated, unless previously accomplished.

To ensure proper operation of the Number 3 left and right entry door emergency evacuation slide, accomplish the following:

A. Within 90 days after the effective date of this AD, inspect the Number 3 left and right entry door girt bar mechanism, to determine if the rod-end bearings are defective. If any rod-end bearing is defective or has failed, prior to further flight, replace the rod-end bearing with a serviceable part, in accordance with Boeing Alert Service Bulletin 747-52A2217, dated October 19, 1989.

B. Within 7 days after completion of the inspection required by paragraph A., above, report all failed and/or defective rod-end bearings detected during the inspection to the Manager, Seattle Manufacturing Inspection District Office, FAA, Transport Airplane Directorate, 7300 Perimeter Road South, Seattle, Washington 98108.

C. An alternate means of compliance or adjustment of the compliance time, which provides an acceptable level of safety, may be used when approved by the Manager, Seattle Aircraft Certification Office, FAA, Northwest Mountain Region.

NOTE: The request should be forwarded through an FAA Principal Maintenance Inspector (PMI), who will either concur or comment, and then send it to the Manager, Seattle Aircraft Certification Office.

D. Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base in order to comply with the requirements of this AD.

All persons affected by this directive who have not already received the appropriate service documents from the manufacturer may obtain copies upon request to Boeing Commercial Airplane Group, P.O. Box 3707, Seattle, Washington 98124. These documents may be examined at the FAA, Northwest Mountain Region, Transport Airplane Directorate, 17900 Pacific Highway South, Seattle, Washington, or Seattle Aircraft Certification Office, 9010 East Marginal Way South, Seattle, Washington.

This amendment (39-6587, AD 90-10-03) becomes effective on June 4, 1990.

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 63

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Boeing63 aircraft
By year built
19692007
Registered aircraft by year built: 49 aircraft
19691
19702
19711
19752
19761
19892
19904
19916
19922
19932
19943
19951
19974
19981
19994
20001
20011
20023
20031
20041
20053
20073

14 with no year recorded

By model

See all 24 models

Aircraft

See all 63 aircraft