- Effective
- September 11, 1991
- Models
- A300 B2-1A, A300 B2-1C, A300 B2-203, A300 B2K-3C, A300 B4-103, A300 B4-203 and 15 more
- Data sheet
- TCDSA35EU
- Registered aircraft
- 122 matched by model
- Product
- Aircraft · Large airplane
- Amendment
- 39-7093
- Docket
- 91-NM-90-AD
Unofficial copy of the text in the FAA’s Dynamic Regulatory System. The FAA’s own copy is the authoritative one. DRS record last changed May 30, 2024.
Copies of the files this page was built from, with their SHA-256. Retrieved October 18, 2026.
| File | Size | SHA-256 | Original |
|---|---|---|---|
| FAA DRS HTML | 23 KB | 979ba52c…502a8ee | FAA DRS (API key needed) |
On this page
The airworthiness directive
91-16-03 AIRBUS INDUSTRIE: Amendment 39-7093. Docket No. 91-NM-90-AD.
Applicability: Model A300, A310, and A300-600 series airplanes equipped with escape slides, certificated in any category.
Compliance: Required as indicated, unless previously accomplished.
To prevent delayed passenger evacuation during an emergency, accomplish the following:
A. Within 30 days after the effective date of this AD, or prior to the accumulation of 300 hours time-in-service after the effective date of this AD, whichever occurs first, perform a close visual inspection of the escape slide girt bars for correct installation, in accordance with paragraph 4 of Airbus Industrie All Operators Telex (AOT) 25-01, dated July 30, 1990. If the girt bars are incorrectly installed, prior to further flight, repair in accordance with the AOT.
B. An alternative method of compliance or adjustment of the compliance time, which provides an acceptable level of safety, may be used when approvedby the Manager, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate.
NOTE: The request should be forwarded through an FAA Principal Maintenance Inspector, who may concur or comment and then send it to the Manager, Standardization Branch, ANM-113.
C. Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base in order to comply with the requirements of this AD.
D. The inspection and repair requirements shall be done in accordance with Airbus Industrie All Operators Telex (AOT) 25-01, dated July 30, 1990. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51. Copies may be obtained from Airbus Industrie, Airbus Support Division, Avenue Didier Daurat, 31700 Blagnac, France. Copies may be inspected at the FAA, Transport Airplane Directorate, Renton, Washington; or at the Office of the Federal Register, 1100 L Street N.W.,Room 8401, Washington, D.C.
This amendment (39-7093, AD 91-16-03) becomes effective on September 11, 1991.
Affected TCDS · 1
The type certificate data sheets for the models this AD names, matched by model and maker.
Registered aircraft · 122
Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.
| 1983 | 2 |
|---|---|
| 1984 | 1 |
| 1985 | 1 |
| 1988 | 1 |
| 1989 | 2 |
| 1990 | 5 |
| 1991 | 3 |
| 1992 | 7 |
| 1993 | 5 |
| 1994 | 5 |
| 1995 | 8 |
| 1996 | 5 |
| 1997 | 5 |
| 1998 | 6 |
| 1999 | 6 |
| 2000 | 7 |
| 2001 | 11 |
| 2002 | 6 |
| 2003 | 8 |
| 2004 | 7 |
| 2005 | 7 |
| 2006 | 6 |
| 2007 | 6 |
2 with no year recorded