AD 93-25-07

Historical

Airworthiness directive · Fuselage Stringers · Raytheon 200 Model or Series (all), 200C, 200CT and 22 more

Effective
February 15, 1994
Superseded by
AD2005-01-18
Models
200 Model or Series (all), 200C, 200CT, 200T, 300, A100-1 (U-21J) and 19 more
Data sheet
TCDSA24CE
Registered aircraft
1,483 matched by model
Product
Aircraft · Small/large airplane
Amendment
39-8773
Docket
93-CE-38-AD

Unofficial copy of the text in the FAA’s Dynamic Regulatory System. The FAA’s own copy is the authoritative one. DRS record last changed August 7, 2025.

On this page

The airworthiness directive

93-25-07 BEECH AIRCRAFT CORPORATION: Amendment 39-8773. Docket No. 93-CE-38-AD.

Applicability: The model and serial number airplanes presented below, certificated in any category, that do not have all the fuselage stringers Nos. 5 through 11 modified on both the right and left hand sides in accordance with either (1) Beech Service Bulletin (SB) 2472, Revision 1, dated September 1993; (2) Chapter 51-10 or 53-10, as applicable, of the maintenance manual; or (3) the instructions to Priester Aviation Service Supplemental Type Certificate (STC) SA63CH:

Models Serial Numbers 200, A200, B200, and A100-1 BB-2 through BB-1462, BC-1 through BC-75, and BD-1 through BD-30 200C, A200C, and B200C BL-1 through BL-138, BJ-1 through BJ-66, BU-1 through BU-12, and BV-1through BV-12 200CT, A200CT, B200CT BN-1 through BN-4, BP-1 through BP-71, FC-1, FC-2, FC-3, FE-1 through FE-31, FG-1, FG-2, and GR-1 through GR-19 200T and B200T BT-1 through BT-38 300 FA-1 through FA-228 300 (FAA) FF-1 through FF-19 B300 FL-1 through FL-103 B300C FM-1 through FM-8 and FN-1

Compliance: Required upon the accumulation of 3,000 hours time-in-service (TIS) or within the next 100 hours TIS after the effective date of this AD, whichever occurs later, unless already accomplished, and thereafter as indicated.

To prevent structural damage to the fuselage caused by cracked stringers in the rear pressure bulkhead area, accomplish the following:

(a) Inspect fuselage stringers Numbers (Nos.) 5 through 11 on both the left and right hand sides for cracks in accordance with the ACCOMPLISHMENT INSTRUCTIONS section of Beech SB No. 2472, Revision 1, dated September 1993.

(1) If no cracks are found, reinspect at intervals that correspond with the following:

Stringers Modified in Accordance With One of the Three Modifications Referenced in the Applicability Section of this AD

Inspection Interval No Stringers Modified 600 hours TIS on all stringers Nos. 8, 9, and 10 (one side) with Internal Modification 1,200 hours TIS on unmodified stringers Nos. 8, 9, and 10 (one side) with External Modification 600 hours TIS on unmodified stringers Nos. 5 through 11 AD no longer applies

(2) If cracks are found, modify all cracked fuselage stringers at any time up to the time specified in the chart presented in paragraph (a)(3) of this AD. Accomplish this modification in accordance with the instructions in one of the three modifications specified in the Applicability section of this AD, and reinspect at intervals presented in the chart in paragraph (a)(1) of this AD.

(3) The following chart specifies the required compliance time where cracked stringers must be modified:

No. of Stringers Cracked on Any One Side of Fuselage When Modification Must be Accomplished (Hours TIS) 1 to 3 150 4 30 5 or more Prior to further flight

(b) The modifications specified in the Applicability section of this AD may be accomplished at any time as terminating action for the inspection requirement of this AD provided that all fuselage stringers Nos. 5 through 11 are modified.

(c) Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate the airplane to a location where the requirements of this AD can be accomplished.

(d) An alternative method of compliance or adjustment of the compliance time that provides an equivalent level of safety may be approved by the Manager, Wichita Aircraft Certification Office (ACO), FAA, 1801 Airport Road, Room 100, Wichita, Kansas 67209. The request should be forwarded through an appropriate FAA Maintenance Inspector, who may add comments and send it to the Manager, Wichita ACO.

NOTE: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Wichita ACO.

(e) The inspections and modification required by this AD shall be done in accordance with Beech Service Bulletin 2472, Revision 1, dated September 1993. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51. Copies may be obtained from the Beech Aircraft Corporation, P.O. Box 85, Wichita, Kansas 67201-0085. Copies may be inspected at the FAA, Central Region, Office of the Assistant Chief Counsel, Room 1558, 601 E. 12th Street, Kansas City, Missouri, or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

(f) This amendment (39-8773) becomes effective on February 15, 1994.

Affected TCDS · 1

The type certificate data sheets for the models this AD names, matched by model and maker.

Registered aircraft · 1,483

Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.

By aircraft maker
  • Beech558 aircraft
  • Raytheon454 aircraft
  • Textron230 aircraft
  • Hawker Beechcraft170 aircraft
  • Beechcraft69 aircraft
  • Other makers22 aircraft
By year built
19742026
Registered aircraft by year built: 1,209 aircraft
19741
19753
19762
19774
19783
19798
19804
198145
198245
198334
198423
198540
198620
198720
198849
198927
199034
199136
199226
199319
199417
199514
199627
199739
199843
199953
200036
200139
200231
200310
200420
200516
200612
200743
200823
200915
201024
201113
201222
201330
201432
201532
201634
201720
201823
201925
202012
202121
202215
20237
20247
20257
20264

274 with no year recorded

By model

See all 31 models

Aircraft

See all 1,483 aircraft