- Effective
- January 16, 1996
- Published
- December 15, 1995 · 60 FR 64316–64317
- Models
- 400, 400A, 400T
- Data sheet
- TCDSA16SW
- Registered aircraft
- 312 matched by model
- Product
- Aircraft · Large airplane
- Amendment
- 39-9451
- Docket
- 95-NM-76-AD
- Issued as
- Final rule
Unofficial copy of the text in the FAA’s Dynamic Regulatory System. Only the govinfo PDF is the legal edition. DRS record last changed January 21, 2026.
Copies of the files this page was built from, with their SHA-256. Retrieved October 18, 2026.
| File | Size | SHA-256 | Original |
|---|---|---|---|
| Official PDF | 117 KB | cb3eba21…6ebe28c | 95-30532.pdf on govinfo.gov |
| FAA DRS HTML | 42 KB | 12dafa38…761cb70 | FAA DRS (API key needed) |
| Federal Register text | 9 KB | 7628466a…2bb4618 | 95-30532.txt on federalregister.gov |
On this page
Summary
This amendment adopts a new airworthiness directive (AD), applicable to certain Beech Model 400, 400A, and 400T (military T-1A) airplanes, that requires modification of the standby instrument lighting system. This amendment is prompted by a report that, due to the design of the standby instrument lighting system, the lighting for the standby instruments dimmed to an unacceptable level when the main electrical power was turned off. The actions specified by this AD are intended to ensure that the standby instrument lighting system adequately illuminates the standby instrument, if normal electrical power is lost or is turned off as a result of fire or smoke in the cockpit.
The airworthiness directive
95-25-06 BEECH AIRCRAFT CORPORATION: Amendment 39-9451. Docket 95-NM-76-AD.
Applicability: Model 400 airplanes, serial number RJ-61; 400A airplanes, serial numbers RK-1 through RK-80 inclusive; and 400T (military T-1A) airplanes, serial numbers TT-1 through TT-108 inclusive; certificated in any category.
NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must use the authority provided in paragraph (b) of this AD to request approval from the FAA. This approval may address either no action, if the current configuration eliminates the unsafe condition; or different actions necessary to address the unsafe condition described in this AD. Such a request should include anassessment of the effect of the changed configuration on the unsafe condition addressed by this AD. In no case does the presence of any modification, alteration, or repair remove any airplane from the applicability of this AD.
Compliance: Required as indicated, unless accomplished previously.
To ensure that the standby instrument lighting system adequately illuminates the standby instrument, if normal electrical power is lost or is turned off as a result of a fire or smoke in the cockpit, accomplish the following:
(a) Within 200 hours time-in-service after the effective date of this AD, modify the standby instrument lighting system in accordance with Beechcraft Service Bulletin 2563, dated February 1995.
(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Wichita Aircraft Certification Office (ACO), FAA, Small Airplane Directorate. Operators shall submit theirrequests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Wichita ACO.
NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Wichita ACO.
(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.
(d) The modification shall be done in accordance with Beechcraft Service Bulletin 2563, dated February 1995. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Beech Aircraft Corporation, Commercial Service Department, P.O. Box 85, Wichita, Kansas 67201-0085. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 LindAvenue, SW., Renton, Washington; or at the FAA, Wichita Aircraft Certification Office, Small Airplane Directorate, 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
(e) This amendment becomes effective on January 16, 1996.
Rule preamble
The FAA’s background, reasoning and cost estimate, published with the AD.
Supplementary information
A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Beech Model 400, 400A, and 400T (military T-1A) airplanes was published in the Federal Register on August 28, 1995 (60 FR 44450). That action proposed to require modification of the standby instrument lighting system.
No comments were submitted in response to the proposal or the FAA's determination of the cost to the public. The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.
There are approximately 189 Model 400, and 400T airplanes of the affected design in the worldwide fleet. The FAA estimates that 189 airplanes of U.S. registry will be affected by this AD, that it will take approximately 6 work hours per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. The cost of the required parts will range from $21 to as much as $471 per airplane. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be between $72,009 (or $381 per airplane) and $157,059 (or $831 per airplane).
The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted.
The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment.
For the reasons discussed above, I certify that this action (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption "ADDRESSES."
List of Subjects in 14 CFR Part 39 Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Adoption of the Amendment Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39 - AIRWORTHINESS DIRECTIVES 1. The authority citation for part 39 continues to read as follows: Authority: 49USC 106(g), 40101, 40113, 44701.
39.13 - [Amended] 2. Section 39.13 is amended by adding the following new airworthiness directive:
Affected TCDS · 1
The type certificate data sheets for the models this AD names, matched by model and maker.
Registered aircraft · 312
Registered aircraft whose airframe or engine model this AD names. Matched by model only, so check each against the AD’s applicability.
| 1985 | 2 |
|---|---|
| 1986 | 1 |
| 1987 | 1 |
| 1988 | 6 |
| 1990 | 3 |
| 1991 | 6 |
| 1992 | 8 |
| 1993 | 2 |
| 1994 | 7 |
| 1995 | 5 |
| 1996 | 8 |
| 1997 | 17 |
| 1998 | 20 |
| 1999 | 28 |
| 2000 | 21 |
| 2001 | 17 |
| 2002 | 9 |
| 2003 | 2 |
| 2004 | 8 |
| 2005 | 10 |
| 2006 | 12 |
| 2007 | 20 |
| 2008 | 19 |
| 2009 | 1 |
| 2010 | 2 |
| 2016 | 1 |
76 with no year recorded