- Registered owner
- Safer Medical Of Mt Inc
- Location
- Fort Benton, MT
- Owner type
- Corporation
- Serial number
- DMO-202
- Year built
- 2011
- Type
- Fixed wing single engine
- Engine
- Reciprocating
- Airworthiness
- Experimental, amateur built
- Airworthiness date
- August 30, 2011
- Certificate issued
- June 1, 2017
- Expires
- June 30, 2027
- Mode S code
- A15BD2
- Kit
- Velocity Inc SE-RG
From the FAA registry file of October 24, 2026.
On this page
Airworthiness directives that may apply · 4
Matched by this aircraft’s airframe and engine models. Each AD’s applicability may narrow it by serial number, part number or equipment.
| 1969 | 1 |
|---|---|
| 1989 | 1 |
| 2003 | 1 |
Superseded and historical ADs · 1
Information bulletins that may apply
Advisory, not mandatory.
No bulletins matched this aircraft’s models
NTSB investigations
No NTSB investigations matched to N187MTMatched by N-number and event date, checked against the reported serial number, make and model. Investigations from before this aircraft carried the mark are under Earlier aircraft. Investigations on Fast Dan VELOCITY SE-RG aircraft
FAA incident reports
No FAA accident or incident reports matched to N187MTMatched by N-number and event date, checked against the reported make and model. Reports from before this aircraft carried the mark are under Earlier aircraft. Reports on Fast Dan VELOCITY SE-RG aircraft
Service difficulty reports
No reports matched to N187MTGeneral aviation reporting is voluntary. Matched to this aircraft by N-number and event date, checked against the reported serial number, make and model. Reports on Fast Dan VELOCITY SE-RG aircraft
STCs that may be installed · 14
Approved for this aircraft’s airframe or engine model. The registry doesn’t record which STCs an aircraft has; its records do.
Engine · Franklin 6A-350-C1
STC SE2932SWInstall carburetor air temperature indicator. Approved for Aircooled Motors (Franklin Engine Co.) equipped with float carburetors. Model eligibility included here may not be inclusive.STC SE1311SOInstallation of Shivers carburetor temperature gauge with a Richter Aero Equipment B-5 carburetor temperature probe.STC SE208SOInstallation of ice indicator in the carburetor.STC SE03309CHInstallation of Engine Preheat Kit, p/n TSP6CYL-2927-115 for 115 volt applicationSTC SE4178NMInstallation of oil filter kitSTC SE02602ATInstallation of an alternate engine driven fuel pump in accordance with CJ Aviation "Installation Instructions for Fuel Pump 6005-2A", IR, dated 12/23/02, drawing no. 6005-2A "Fuel Pump", IR, dated 11/14/02 and drawing no. 6005-2B "Cap Plug", IR, dated 12/03/02 or later FAA approved revisions of either document.STC SE8776SWInstallation of coated cylinders and piston rings.STC SE3331NMLycoming valve cover gasketSTC SE110CHInstallation of Slick Model 6399 magnetos.STC SE1697GLInstallation of nose seal retainer.STC SE78WEInstall two locking pins in Franklin Part Number 21014J oil transfer collar, 180 degrees apart, to prevent rotation of oil seal in collar.STC SE77WEOne Only STC Installation of two seal locking pins in the oil transfer collar, Serial No, 53005-3STC SE76WESerial Number 53056-3 ONLY: Installation of two seal locking pins in the oil transfer collar in accordance with Yehnert Helicopter Drawing YH1049.STC SE634SOInstallation external oil supply routing and vent system to permit maintaining oil pressure in inverted position.