- Date
- June 19, 2013, 08:40 local (16:40 UTC)
- Place
- Dillingham, AK
- Injuries
- 2 uninjured
- Damage
- Substantial damage
- Phase of flight
- Enroute
- Aircraft
- N620YCub Crafters CC11-100
- Defining event
- Enroute: Loss of engine power (total)
- Weather
- Visual (VMC) · Day
- Status
- Completed · report October 21, 2013
- Report
- Approved by Office Director
- NTSB office
- Alaska Regional Office
- Parties
- Federal Aviation Administration
- FAA report
- 20130619024839A
- Case key
- 87238
From the NTSB’s public API. By law, NTSB reports can’t be used as evidence in lawsuits over the accident.
On this page
Probable cause
A loss of engine power due to carburetor icing.
Findings · 2
NTSB’s coded findings. Those marked are part of the probable cause; the rest are factors or other findings. Under each, the cases with the same finding.
Sequence of events
The events NTSB coded, in order, by phase of flight. The defining event is the one that best describes the accident. Under each, the cases with the same event anywhere in their sequence.
Analysis
The airplane departed with 24 gallons of usable fuel, which normally allows for 4.5 hours of flight. About 2.5 hours into the flight, the engine started running rough. The pilot confirmed the mixture was rich and the carburetor heat was on. About 5 minutes later the engine quit and the pilot executed a forced landing to an area of tundra-covered terrain, substantially damaging the undercarriage, fuselage, and left wing strut. A postaccident examination by a Federal Aviation Administration inspector revealed that the carburetor had separated from the engine during the forced landing, and the gascolator drain had tundra embedded in it. The pilot stated that he had turned the fuel selector to the OFF position about 30 minutes after the landing. The carburetor icing chart indicated the possibility of serious carburetor icing at the reported atmospheric conditions. The Pilot's Handbook of Aeronautical Knowledge (FAA-H-8083-25A) states that first indication of carburetor ice in an airplane with a fixed-pitch propeller is a decrease in engine rpm. Additionally, it states that when conditions are conductive to carburetor icing that carburetor heat should be applied immediately and should be left ON until the pilot is certain all the ice has been removed. If ice is present applying partial heat or leaving heat on for an insufficient time might aggravate the situation. Postaccident examination of the airframe and engine revealed no preimpact mechanical malfunctions or failure that would have precluded normal operation.
Factual narrative
The airplane departed with 24 gallons of usable fuel, which normally allows for 4.5 hours of flight. Two and half hours into the flight, the engine started running rough. The pilot confirmed the mixture was rich and the carburetor heat was on. About 5 minutes later the engine quit and the pilot executed a forced landing to an area of tundra-covered terrain, substantially damaging the undercarriage, fuselage, and left wing strut. A postaccident examination by a Federal Aviation Administration Inspector revealed that the carburetor had separated from the engine during the forced landing, and the gascolator drain had tundra embedded in it. The pilot stated that he had turned the fuel selector to the OFF position about 30 minutes after the landing. The carburetor icing chart indicated the possibility of serious carburetor icing at the reported atmospheric conditions. The Pilot's Handbook of Aeronautical Knowledge (FAA-H-8083-25A) states that first indication of carburetor ice in an airplane with a fixed-pitch propeller is a decrease in engine rpm. Additionally, it states that when conditions are conductive to carburetor icing that carburetor heat should be applied immediately and should be left ON until the pilot is certain all the ice has been removed. If ice is present applying partial heat or leaving heat on for an insufficient time might aggravate the situation. Postaccident examination of the airframe and engine revealed no preimpact mechanical malfunctions or failure that would have precluded normal operation.
Aircraft
- Registration
- N620Y
- Reported as
- Cub Crafters CC11-100
- Category
- Airplane
- Serial number
- CC11-00005
- Airframe hours
- 487
- Engine
- Cont Motor O-200, 100 horsepower, reciprocating
- Damage
- Substantial damage
- Flight
- Personal · Part 91
- Operator
- Walla Walla University
- Registered owner
- Walla Walla University
- Airworthiness certificate
- Special, Special light-sport (Special)
- Last inspection
- Annual · June 16, 2013
- Departed
- PAMR · Anchorage, AK
- Destination
- PADL · Dillingham, AK
- Flight plan
- Unknown
- Airport
- PADL · Dillingham Airport
Matched to the registry by N-number and the event date; the registry’s history has gaps, so older matches can be wrong. Compare the reported make and model.
Flight crew
As NTSB recorded them. NTSB leaves out names.
- Role
- Pilot
- Age
- 38
- Injuries
- None
- Certificates
- Airline transport, Commercial
- Airplane ratings
- Multi-engine land, Single-engine sea, Single-engine land
- Instrument ratings
- Airplane
- Medical
- Class 1, Without waivers/limitations
- Seat
- Front
- Flight hours
- 6,470 total · 40 in this make and model · 6,350 as pilot in command
Weather
- Conditions
- Visual (VMC) · Day
- Wind
- 300° at 6 knots
- Visibility
- 15 statute miles
- Lowest ceiling
- 6,500 ft broken
- Temperature
- 57 °F, dew point 50 °F
- Altimeter
- 29.84 inHg
- Observed at
- PADL, 13 nm away
Docket · 4
The files NTSB released with the investigation on September 28, 2013, on NTSB’s docket system: statements, records, photos and specialists’ reports. 1.1 MB in all.
FAA reports on this event · 1
The FAA’s own accident and incident reports, matched to the aircraft by N-number and date.